answersLogoWhite

0

Geo Metro

The Geo Metro was a small economy car produced between 1989 and 2001. The first generation model was available as 3-door and 5-door hatchback, as well as 4-door notchback sedan. It came in three trim levels: XFi, Base and LSi.

1,033 Questions

Where is the control module 1992 Geo Metro?

Had the same problem. Looked up what the module was supposed to look like but could not find anything like it in the engine compartment. Looked it up in Haynes book and identified the wires. Ends up it was about the size and shape of your thumb and was wrapped up in the wire bundle just below the right hood hinge. Good luck.

How do you remove the crankshaft pulley in a 1993 Geo Metro LSi 3 Cylinder?

There is a large metric bolt right (17 or 18mm) in the center of the main crank pulley. Immobilize the crank using a vise-grip equiped with a locking chain. Wrap an old fan belt (cut-to-size) around the crank and protect the serpentine gooves of the crank pulley, then wrap the vise chain and clamp onto the crank. Use a good breaker bar, or impact hammer to break the bolt torque free counter-clockwise. Note: Don't remove the four 10mm bolts on the crank pulley. The whole thing comes off as one assemble piece.

What are Geo Metro Check engine light pulse codes?

They pertain to different problems the engine might be having, To check them read them as flash flash pause flash flash flash....that would be code 23 Check what they mean at the following website

http://www.troublecodes.net/suzuki/

Where do you put transmission fluid in a 1996 Geo Metro?

If it is an automatic you will likely have to add fluid through the dipstick tube. This is a real pain because the diameter of the tube is quite small and overflows easily. You will need to buy a funnel where the size is very close to the inside diameter of the upper neck of the tube. It will still probably make a mess though. It helps alot if you heat up the fluid before adding it, lowering the viscosity keeps it from overflowing in the tube.

How do you replace the antenna on a 1997 Geo Metro which broke in the automated car wash?

Looks like you'll have to remove the radio and just trace the lead back to the antenna. It either will have screws holding it in or a fitting around the base that has to be unscrewed. Check with Autozone or Advance for a replacement and see if your sales person will come out and look at it. They should be able to tell you how it comes out. I've always tied a strong piece of nylon string around the end of the old antenna lead before removing it. This way, you can tie it to the new lead and pull it back in the car. there are two screws on the outside of the car that screws the antenna to the car take them out and pull the wire out a little cut the wire then tape your new wire plug to the end of the old cut wire then carefully pull the wire through from the inside by pulling the old wire through and it will bring the new one to the radio

Where is the freeze plug in 93 Geo Metro?

Bottom of intake manifold, dorman part #, 555-091, 565101,or 555101.

What causes a bent valve?

The main cause for bent valves is a failure in the timing chain or belt. When the valves and pistons are not exactly in sync, they can collide.

How do you replace clutch in a 1994 Geo Metro?

You have to pull the engine and tranny out, separate the two, and do the clutch work. With a cherry picker or another way to lift the eng/tran it's really not that bad of a job. All of the electrical connectors will only mate up with the right counterpart, and all of the mechanical dissconnects are pretty easy. You will need ramps or GOOD solid jack stands to get to the motor mount electrical and other things you need to remove underneath before lifting the eng/tran out.

Will 96 Geo Tracker engine fit 97 metro?

I would say most likely not. Even if you had the engine and transmission to go in the new car. There will be many modifications to make to make it work. Not to mention, the sensors and everything else most likely will be diiferent as well.

How many people can fit in a car?

That would depend on the size and model of the car.

It would also depends on the size of the people.

Does Geo Metro engine have a VIN on it?

All cars manufactured in America (for certain) have VIN numbers on the engine, chassis and possibly other locations as well. This is for consumer protection mainly as the Chassis and Engine VIN should always match, unless the engine has been replaced with a rebuilt one.

Why would a 1996 Geo Metro have problems while accelerating and will not pick up speed?

Um, because it's a Geo Metro??

----

Perhaps it is because of your large behind IN a Geo Metro?

----

Your catalytic converter may be getting stopped up too.

Try changing the fuel & oil filters.

Mine was doing the same thing last summer, the fuel & oil filters were both plugged.

----

Stop trying to drive up walls.

----

It could be a lot of things. It may be running too rich and bogging down(replace oxygen sensor). The camshaft lobes may be worn down and the valves aren't opening all the way(replace or regrind the cam). The catalytic converter or exhaust pipe could be clogged up with carbon. But keep in mind it is a Geo Metro, economy is the goal here, not performance...

I am having the same problem. Oil and fuel filters have been replaced and now will not accelerate at all. my mechanic says it is acting like an issue with the timing belt but the belt is fine and working properly. The computer diagnostics are fine as well. any ideas

Does a 97 geo metro have a fuel light?

The '97 Geo Metro (Base, LSi or XFi) does not have a fuel light.

Where do you find the low side hook up for the AC on a 95 Geo Metro?

You find the low side access of the AC charging system for a 1995 Geo Metro in the engine compartment. It is located on the back side of compartment, next to the windshield.

Where is the fuse box 93 Geo Metro?

A 1993 Geo Metro has two fuse boxes. One fuse box, that has the relays in it, is under the hood and the other fuse box is under the dash next to the driver side door.