0
GMC Sierra
The GMC Sierra is the latest series of full-size pickup trucks from the American car builder General Motors. The GMC Sierra is known for its luxurious interior, unique grille and four-wheel steering system.
2,525 Questions
How do you replace front speakers in your 2001 elantra?
1.Remove the front door trim panel.Remove the speaker retaining bolts.Disconnect the electrical connector and remove the speaker from vehicle. Installation is the reverse.
Where is the fuel filter located on a 1997 GMC Sierra 3500?
it is located on the back side of the frame rail on the drivers side about half way between the tires
How do you change spark plug wires for a 2004 gmc sierra?
Chase the sparkplug wires back to the coil pack. Depending on the size of engine is going to determine how many wires there will be. Keep in mind where you unplug the wires from the new wires will need to go back the exact same way to keep the firing order the same.
When the speedometer doesn't work how do you fix it?
did you check the speed sensor on the side of the transmission?
How much power does a stock 305 gmc sierra engine have?
Its not very powerful at all. I have a 305 in my 1995 Sierra 4x4 probably around 225 hp,
What is the location of the oxygen sensors on a 1993 GMC sierra truck?
the O2 (oxygen) sensor on a 93 gmc is in the left down pipe of the exaust Y pipe
How do you remove rear panel in 1996 gmc sierra to change speakers?
What you have to do is start from the bottom, these trucks are put together from the top down, so take them apart you work from the bottom up.
First of take the seat out, its a necessity There are two bolts on each end that go through the metal mounts of your seats and through the supports. Helps if you have two people to lift it out.
Second, the piece of hard plastic on the inside of the door will have two screws on it, take out the one furthest from the back, and simply take the bottom side panel and pull it slightly to the inside just enough to pull it over top of the hard plastic moulding piece.
Third you have to take of your seat belt mount to pull the bottom piece off. There will be a little flap that will open on the furthest back side of the plastic moulding. (this is the bottom of the seatbelt, on both sides on two door extended cabs, and only the one on three door) open this flap and there will be a "torqs" bolt that goes into the bottom of your cab, take that out. There will also be a screw just back and up of your seat mount, that must come out to. If I'm remembering correctly that's all the screws, the rest are clips into the side of the panel, put your arm underneath to get as much surface area around each tab and pull, or use pliers and squeeze them as you pull.
Fourth, there will be a screw above your rear quarter window, take that out. then your top seat belt will pull out from the sides and up, then there will be another "torqs" bolt. to take the belt off.
Fifth, there are two or three metal clips that go into the side of the cab, the only problem is that they are melted into, or glued or something into the body paneling. They are located nearest to the back window. i highly suggest using long pliers to a trim tool to pull this clips out, or the clips will stay in the cab, and break of the moulding. then your screwed. The rest of the clips should pull out fairly easily, just make sure your working in a nice and hot environment so things bend not break when pulling them out from the clips.
Repeat for both sides, fairly easy once you figure it out. The top panel never comes out or gets moved, no broken pieces if you take your time. Make sure you use very good water tight wire connectors, like those ones that shrink when heated with a lighter to make sure your speakers never crap out, and you have to repeat this whole long process
1996 gmc sierra speaker sizes?
The standard speaker size on a 1996 GMC Sierra truck is 9 inches. Larger speakers can be added but required the opening to be enlarged.
flasher module in the fuse box. tin can about the size of a silver dollar around. it pulls out. some fords have a second one on the back side of the fuse panel opposite the first one.
How much speed transmission does a Chevy 305 engine have?
An autimatic transmission will have a 4 speed transmission and a manual transmission will have a 5 speed transmission.
What kind of transmission fluid goes in a 1990 GMC 1500 sierra manual trans?
Synchromesh transmisssion fuild is what is recomened. Do not use Atf in those trans!
Why does truck pull to the right?
Out of alignment? Air pressure in tire low? Bent steering component? Frozen brake caliper? Parking brake dragging?
Which is the fuse for the automatic mirrors on a 1995 Mitsubishi 3000GT?
Look for fuse box in Central fusebox Fuse #5 it is 15amp and is the same fuse which shares cigarette lighter Should be Blue in color Hope that helps Ray
How much horsepower does an 85 stock gmc 2 wheel drive 1500 with a 305 have?
Advertised horsepower is..........160HP @ 4400 RPMs. 4-barrel carb.
Where is the EGR valve located on a 1997 GMC Safari?
This is from AutoZone: "On your 1997 GMC TRUCK SAFARI VAN 2WD, the EGR VALVE is UNDER HOOD, CENTER, UPPER ENGINE AREA, FRONT OF INTAKE MANIFOLD, PASSENGER SIDE OF WATER OUTLET, MOUNTED IN INTAKE MANIFOLD."
It is a heater hose to core coupling. Some auto supply stores have no clue. I went to Auto Zone and they didn't know what I was talking about and couldn't find anything on their system. Then I went to O'reillys and they pulled it right up on their computer. It cost me $6.00. You can use a large fuel line "quick connect" tool to compress the tabs and release the old coupler from the core. That tool set only cost $10.00 at O'reillys as well.
What is the bumper mounted ball towing capacity of a 1994 GMC Sierra 5.7?
On my '94 Sierra, The bumber is actually stamped, near the ball mount hole, with the bumber load limits. I believe it to be 200 lb tongue weight. Tongue weight is the amount of actual weight pushing down on the bumber at the ball mount, not the total weight of the trailer.
Why is my Brake lights not turning off on 1990 GMC Sierra?
Although it's possible there could be other reasons, the most common causes for brake lights to stay on continuously include:
- The brake light [if mounting position is adjustable] is out of adjustment, or
- The brake light switch contacts are fused ["welded"/melted] together, or
- The brake light switch is otherwise defective.
Where is the hazard relay located on 2002 gmc sierra?
Its in the fusebox at the side of the dashboard on the driver's side. it is attached to the backside of the fusebox. You can remove the lower half of the dashboard to access it esier. It is rectangular shaped like the relays under the hood.
