Hand Tools

If it is the supercab the lug wrench and the jack are located under the jump seat on the passenger side, at least in a 95 they are.

Google

Take some basic tools with you. Every Vehicle is a different size. Most common 7/16, 1/2 and 9/16.

7 mm

I believe that would be a 1/2 inch wrench, but would it be too difficult to take 2-3 wrenches and try them fr size.

I think that is a 14 mm open wrench, not Allen.

You fit the end over the bolt head and turn . - Clockwise to tighten.

It means they want you to have the engine serviced. Typically it means that there is an engine diagnostic code waiting to be read. You can borrow, rent or buy a code scanner at most auto parts retailers, it depends on the retailer, but Auto Zone often lets you borrow them. Your 2007 should use OBD2 and it should be relatively easy to use.

I used a 7mm hex bit socket. Worked fine, but the tool was a little hard to find. the 7mm hex key does not typically come in a L-key set.

You use a speed wrench, (or speeder wrench) in place of your ratchet handle that came with your socket set. It has an off-center grip that you rotate around the wrench shaft. Due to its length, you will usually be able to keep your hands and the wrench clear of the work area, and will be able to rotate the wrench 360 degrees without interference - allowing you to install or remove nuts and bolts much quicker than with a standard socket/ratchet set.

13 mm

13 mm

A 3/8 Allen key.

The symbol of a wrench and an oil can on the dash of a Chevy Trailblazer means that your vehicle needs oil. If the light doesn't go away oil is added, you need to take your vehicle in for service.

3/8

open end

--------------------------------------------------

A box end wrench is better ( Helpfull )

( the first answer is not mine )

It's the button on the speedo next to the 0.0 button :D

I believe that one is 3/8 allen wrench, but it takes about 5 minutes to check so you should make sure.

the part of the screwdriver is nothing its not a wheel nor axle its a butt

a sledge hammer is a tool you break things down or build them up.

i think they are external torx

This week, I have changed the brake pads on two vehicles that I have never worked on before. I jack them up and get in there with a full set of Allen keys and small wrenches within reach. I look and see if it needs an Allen key or wrench and approximately what size. Then I try tools that may fit till I find the correct one -usually within 2 tries. - This is not a complicated exercise. . . .

No, they are usually phillips.

it`s best that he wouldn't do this but if he does the battery will melt or explode or the wrench will melt the car can even burst in to flames.

An Allen screw is not likely in that period Pontiac. Try 15 mm regular wrench.

It means there are problems in the engine and in trans or drive shaft. Take it for a analysis at your agency.