0
Lexus ES
The Lexus ES series is a line of middle-sized luxury sedans manufactured by Lexus from 1989 to present. The series is patterned on the Toyota Camry platform and features an automatic transmission, V6 engine and front-wheel drive.
1,090 Questions
How do you remove the front middle vents from a 1997 Lexus ES 300?
gently pull them off. they are clipped in.
How many spark plugs are in a Lexus IS300?
There are six(6) spark plugs to require to change for the IS300. Not as easy to change.
Does the 1993 Lexus ES300 have an interference or non-interference engine?
It is a NON - interference engine , according to the Gates website
( they make timing belts etc. )
What are the fuses in a Lexus gs300?
under the bonnet or there are more fuses in the footwell sidepanel. if you have LHD vehicle there should be a hidden side panel next to the actual parking brake in the carpet of the footwell
How many gallons does the gas tank in the 2014 Lexus ES-350 hold?
The gas tank on the 2014 Lexus ES-350 holds 17.2 gal..
Replace brake light in a Lexus es300?
The 3rd brake light can be replaced by removing the subwoofer cover by pushing down and towards the front of the car, other brake lights can be replaced by opening velcro covers on inside of trunk lid.
Is the thermostat in the bottom hose of a 91 Lexus es250 and how do you change the water pump?
No it is on top of motor.
The above is incorrect , I believe. It appears to be on the side of the engine attached to the water pump. But it is not on the top, as above stated( i just looked, and ruined a perectly good upper hose gasket.)
What is price for complete brake repair on a Lexus 2000 ES300?
The exact answer depends on how many parts actually need to be replaced.
$200 for pads and labor to $600 for pads, rotors (discs) calipers and hardware including labor.
I want to replace the power steering belt on a Lexus Rx 330 the engine is a 3.3 liter v6?
The belt tensioner for the AC/Alternator belt is beneath the alternator. Facing the engine from bumper you can see the ac/alternator belt tensioner on the left side and beneath the alternator. Losen that bolt with size 12 socket. Next, loosen the tensioner bolt until the belt loosens.
Now, with the Power Steering Belt you can loosen it by locating the belt tensioner usually found inside of the power steering belt on the power steering pump. Loosen both bolts and if needed pry UP the power steering belt tensioner and the belt should loosen. Repeat until belt comes off.
Installation is the reversal of removal.
NOTE: You may have to pry down the power steering pump tensioner to tighten the belt.
What is the cost for a Lexus ES?
The cost of a Lexus ES will vary depending on which country one is purchasing the vehicle from. In the United States they can be purchased for $36,370.
Where is the factory amplifier of a 1999 Lexus es300 located?
It's behind the glovebox if you have the nakamichi stereo
Is the primary oxygen sensor for a 93 Lexus es300 the same as the secondary sensor?
no the primary one is the one closest to the engine
How do you install a new timing belt and adjust the timing on a '92 Lexus ES 300?
buy a do and he will make a Lexus TRUE stOrY
Is there an emergency fuel pump shut-off on a 1994 Lexus ES300 and if so where is it located?
In the trunk
What would cause a 2004 Lexus ES 300 to stop idling?
could be alot of different problem. best thing is to have it place on an obd2 testor and see if any codes come up. most parts stores will do it for you. they want to sell you parts to fix it. They what can cause it to happen are: bad crank sensor, bad idle sensor, computer malfunction. fuel pump relay, trottle body intake sensor not working properly. This sounds familiar. check the manufactor web site to see if there are any recalls. . hope it helps. duboff.
How do you change the solenoids in transmission on 1995 Lexus ES300?
Remove the pan from the transmission. You will have to drop the valve body. The solenoids are on top of the valve body. Unplug it and screw it out. Be careful the gaskets for the valve body are very brittle and will break easily.
Where is the 1998 Lexus es300 neutral safety switch?
the neutral safety switch is located on the transmission directly below the starter. in order to gain easier access, remove the cold air intake (which is directly behind the battery). by doing so you should gain enough space to be able to service the N.S.S. Keep in mind that once you remove the old one and replace it with new you will still have to adjust the switch so it will line up with the corresponding electrical connections for the switch to function properly.
A sexy girl. One that deserves alot. Shes beautiful and you can trust her. Shes amazingggg!! she also is adventerist and outgoing. guys or girls are attracted to him or her!!!
Where is the main office of Lexus cars company?
Lexus is not a car company. Lexus is a Toyota brand.
Try http://www.toyota.com.
How do you replace low beam head light on Lexus 2004 ES 330?
It will vary depending on if you have HID lighting or Halogen Lighting which you did not include in your question. 2004 Lexus ES330 headlight bulb general replacement procedure: Purchase the correct replacement headlight bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information and full light bulb part numbers list. Then consult your owner's manual for the headlight bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
How do you turn off the OD dash board indicator light in a 1996 Toyota Camry?
there will be a small button below the gear shift stick.... on the stick itself..
just click that button.....
Bring to a shop that has an ABS scanner
How do you replace 1993 Lexus ES300 Knock Sensors?
They are located underneath the intake manifold. You must disassemble the intake manifold to get to them. A dealer will charge you around $1100 to do this. If you do it yourself, there are gasket kits available. Once you're that close to having the top end of your engine torn down, you might as well change the water pump, timing belt, and check your cams (there are 4 on that car) for wear. Good luck.
