0
Mazda MPV
The Multi-Purpose Vehicle (MPV) is a minivan manufactured by Mazda Motor Corporation from 1989 to present. Originally introduced as rear wheel drive (RWD) vehicles in 1989, the MPVs manufactured since 2000 are all in front wheel drive (FWD) configuration.
698 Questions
How do you change a pcv hose on a 2005 MPV Mazda?
The pcv hose is connected to the Pcv valve and the intake manifold. the pcv valve is circular metal piece on the top of the engine cover. Just replace with any rubber hose with similar thickness and heat resistance. You may use same ring clamps if necessary
What does it mean when the hold light flashes on a 1991 Mazda MPV?
there is a button on either your gear shifter or your turn signal that says hold. press and release and the light will go off. According to the 1991 Mazda MPV manual, the flashing indicates that there is an electrical problem with the transmission.
How do you replace the tail light assembly on a 2003 Mazda MPV?
Start by removing the two Philips head screws. There are two retaining pins that still are holding the cover on so it will not just pop right off. The retaining clips are on the oposite side from where the two screws are so you pretty much have to jiggle the tail light assembly to the side to remove it. To reinstall, just line back up the retaining pins to their respective sockets then reinstall the two Philips head screws.
The trick is the light assembly must be pulled outward. For example: If you are standing at the right taillight, you must pull the assembly to your right outward (after you remove the screws of course). I used a plastic, childrens knife to kind of wedge it in there as to not damage the paint. Hope this helps.
Thanks, this worked for my 2004 MPV. To clarify, the hidden pins face right and left. By wedging a plastic piece on the far side from the screws and prying starting at the bottom of the rail light assembly and moving towards the top the assembly pops out nicely.
Having just broke the assembly following these instructions I should add a clarifier that outward really means sideways and NOT to the rear of the car.
Does a 2002 Mazda MPV 3.0 V6 have a timing chain or a timing belt?
A 2002 Mazda MPV 3.0 V6 has a timing chain.
What is the firing order for a 2001 MPV?
The firing order for a 2001 Mazda MPV is 1, 4, 2, 5, 3, 6. The 3 cylinders closest to the firewall are numbers 3, 2, 1 when viewed from left to right.
How do you reset the check engine light on a 2000 Mazda MPV?
Check in your owners manuel, it will have in there.
AnswerIt is reset with an OBD2 scan tool. Unless you repair the problem that set the light it will just come back on.
disconnect the negative battery terminal for 30 seconds.
What are the early symptoms for a water pump going bad for a 2000 Mpv?
If it leaks, change it. If it's not leaking, I wouldn't be worried about whether it's going bad, just wait for it to leak.
How do you replace the blower motor on a 1992 Mazda MPV?
Remove the 3 screws from the black panel above the passengers feet. Remove the 8 screws from around the panel that holds the glove box. (4 top and 4 bottom)
Take a flat head screwdriver and pop off the upper right side panel.(The panel on the side of the upper right AC vent.) You will see one last screw with a tab, holding the glove box panel. Pull out and down a little and the panel will come off. Unplug the speaker wire 2 pin connector.
Now you will see the white box that holds the blower motor. On the bottom of it, you will see one black screw that holds a rectangular box approx. 4x2". unscrew it to get it out of the way. Unscrew the passenger side floor to door carpet, foot panel.(4 screws) Unscrew the "plastic" screw in the upper corner of the right plastic triangular floor panel, then pull out the plastic spacer.
Pull up the rubber door molding on the lower door frame about one foot. Take a flat head screwdriver and and pop the triangular panel off. On the lower right of the blower motor, attached to the right wall, you will see a metal heat sink. (It has 3 connectors attached to it) There are 2 bolts on the bottom attaching it to the side and a metal tongue groove on the top. Unbolt it and slide it down and out. You don't have to unplug the wires. Again this is for easier access. (At least for my big hands.)
On the bottom front of the blower motor you will see a black board with 3 connectors. This is the blower motor resister. The middle connector goes to the motor. Unhook it. To the right of it is another connector that goes to the other side of the motor and is resting in the white frame. Unplug it.
There are 3 gold screws on the bottom of the blow motor assembly. Take a stubby screw driver and unscrew them. Disconnect the small black plastic air hose. Wiggle the blower motor and fan cage out.
Take the new motor assembly and do in reverse.
when you reverse connect a battery there is a good chance you will blow the main fuse this will protect the car from more damage but usually stops the battery for been charged as well... check and change the main fuse or fuseable link The alternator probably already was bad before you put the battery in.
Where is the fuel filter located on a 2005 Mazda mpv?
I just found out when I went to go and get my filter changed that you have to have the whole fuel pump removed because they are connected and can't be seperated. The pump at Autozone is 211.00
The black wires are the heater wires, the white wire is the signal wire and the green is the ground wire.
Mazda MPV leaking yellow fluid?
If a Mazda MPV is leaking yellow fluid then it is possible that the fluid is brake fluid. It is best to take the car to a mechanic right away.
How to change the emergency light switch on a Mazda mpv?
Are you asking how to change the Hazard switch? What makes you think it is bad? They almost never go bad and I would be really surprised if it were. Have you replaced the Flasher Relay for the hazard lights.
How do i find the engine number for a 2.5ltr Mazda MPV 2000?
I got an MPV 2000, also had challenges identifying where the engine number is. Had to call in a mech, but you can DIY, you can read the engine number from beneath the engine not too far from the oil filter, or somewhere very close, cos the mech didnt have any problem locating it, got the engine number out in a minute.
Where is the pcv valve located on a 1995 Mazda MPV?
Not sure if 1995 is like 1994, but on my 1994 MPV 6cyl (3.0L), the PCV is in the middle of a hose on the BACK of the engine, UNDER the throttle body assembly. Took me a LONG time to find it!
How do you install valve cover gasket on 1995 Mazda mpv?
instructions on how to install engine valve cover gaskets on l996 Mazda mpv van with 3.0 engine.
Tail light fuse short 89 Mazda mpv?
Are your dash light off also? Is that circuit blowing fuses? If your not blowing fuses, then your turn signal/headlight switch is going bad. It cost abour $60 for a new one which is a sub unit of the column levers used to activate light/wipers/lights/headlights. Don't let them sell you the whole unit, it cost about $300.
Mazda 6 ERR code on your audio system?
Err will display if you enter 3 times error code. sorry for bad english. i want say you entered invalid password 3 times
What size are 2002 Hyundai elantra replacement wiper blades?
20" drivers side, 18" passenger side and 20" rear. Be sure to always lookup the exact part numbers for the brand of wipers you decide to purchase. This not only ensures the correct lengths but also the correct attachments. See related links below.
It means that one of the engine contol devices has ceased functioning, and you need to take the car somewhere so the codes can be extracted, and the problem corrected.
