0
Mercury Villager
The Villager was a minivan manufactured by Ford Motor Company from 1993 to 2002, and was a rebadged version of the Nissan Quest. Designed by Moray Callum, the Villager featured a five-speed automatic transmission and a front engine, front-wheel drive layout.
1,605 Questions
Since the spark is produced in the distributor, that may be the part is defective. I'd suggest pulling your codes first though to see if any problem is indicated.
How do I put freon in a 1996 mercury villager?
The system has 2 valves, like car tires. The recharge can(s) have a fitting for these and probably a gauge. One will be on high side and one on low.
How do you change the Timing belt on a 1996 Villager?
This is not a job for the faint hearted. If you are an advanced home mechanic, get a repair manual and read it first. (procedure is too complex to outline here) Or, take it to a competent technician. The repair will cost about $400.
How do you replace Mercury villager corner light?
Remove the top screw located on the hood support bar.
There are two hooks holding the light with side fender. Push the corner light towards the center (HeadLamps) and release it using screw driver.
Pull the light outwards, there is a screw held by locking strip. It should come out by pulling the light.
For aasembly, start from inserting hooks in their place, push the light in (will require little force) and put the top screw in.
Where do you find the front blower motor in a 1997 mercury villager. How do you replace it?
Open the glove box compartment and remove it. Disconnect the electrical connection and remove the three mounting screws. The blower motor fan wheel is attached to the shaft with a push nut. Grip the nut with a pair of pliers or pry it off with a small screwdriver, being careful not to crack the nut. To reinstall, push the nut onto the shaft. Be sure to check the resistor board located to the left of the motor for broken resistor wires or a melted thermal limiter.
1995 Mercury Villager takes 20-25 minutes for heater to blow warm why?
agree with the coolant level.
Answer
1. Check coolant level.
2. Thermostat stuck open.
3. Very cold temperatures, consider blocking radiator with some cardboard.
Can you replace the knock sensor on a 2001 Chevy suburban without removing the intake?
According to Chilton's, on a V6 you can, but with the V8 you have to take off the intake manifold and get inside...
1992 buick park avenue drivers power seat not working where and what to look for?
See if you have power to motor Check fuses
Spray penetrating oil, such as WD-40, on the shafts coming out of each of three motors under the seat, right where the shaft exits the motor, trying to get the oil into the motor. Over time, dirt accumulates in this area, creating friction and the motor stops turning and the seat doesn't move. After several tries the motor will begin to turn again and the seat will once again move.
There is a two wire connector from the wiring harness to the control box under the seat. Check the orange and black wires at both sides of the connector to make sure they aren't broken. You can also check for power coming from the harness side.
Where is the heater core in 1999 Mercury Villager?
According to my Hanes repair manual, it is under the dash attached to the firewall just beside the evaporator housing.
How do you bleed air from the cooling system of a 1999 Mercury Villager?
This should not be necessary on this vehicle.
99 Mercury Villager estate and a burning smell is coming from your heater?
I had this issue over the winter....had a mechanic tell I needed to take the blower fan out and clean it. Apparently some mice built themselves a home in my fan. The smell is likely the fan burning up because it is trying too hard to work.
Is 2000 mercury villager a interference engine?
In spite of what you may hear, the engine in the Villager is NOT an interference engine.
Where is the camshaft positioning sensor located on the 98 mercury villager?
Cam position is taken from the distributor. There is no separate cam sensor.
What is plug gap on 1993 villager?
According to one of Fords websites :
For the 3.0 liter V6 engine in a 1993 Mercury Villager :
( the spark plugs are gapped at .032 inch )
What causes the radiator fan to stay on?
Yahoo Groups has a very helpful group; villagerquest. It is here you find the answer(s).
How do you know what are the stereo wiring colors for a 1995 mercury villager?
OK. I'm going to give this a shot although ther could be one of two different systems in that model year. The more popular is a radio with cassette and is wired through an amplifier. If this is not what you have, repost and be more specific. right front speaker..... GRY/BLU & YEL/BLU (blue and green respectfully directly from the amplifier and then connected to the gry/blu & yel/blu wires to the speaker) left rear speaker........ BLU/WHT & BLU/YEL left front speaker....... GRY & YEL/BLU (second set) right raer speaker...... RED/BLU & BLU/BLK
How do you replace dash lights 1996 Mercury Villager?
The entire instrument cluster must be remove to replace lamps. If equiped with Electronic cluster, it might be better to take it to the dealer.
What is the sparl plug gap setting for a 1994 Mercury Villager Van 3O 6 cylinder engine?
According to one of Fords websites :
For a 1994 Mercury Villager , 3.0 liter V6 engine :
( the spark plugs are gapped at .032 inch )
How may quarts of transmission fluid on a mercury villager?
If you drained the pan, it will take about 4-4 1/2 qts to fill it. If you drained the whole transmission it will take more like 8 or 9.
How do you replace the fuel pump on a 1998 mercury villager?
The fuel pump is in the tank and the tank must be removed to replace it.
Where is the rest switch for fuel pump on a 1999 mercury villager?
The fuel pump reset switch is on the driver's side kick panel.
Its the closest to the sun. It is a very small planet, second to Pluto. It has a very short revolution arounf the sun, either two or three months I believe. While it can be the hottest planet in the solar system, the other half is colder than most planets and comets
How do you remove the nut on the crankshaft pulley on 1998 mercury villager?
1. Large air impact wrench.
2. Fabricate or buy holding tool to keep pulley from turning while you remove nut.
