0
Mitsubishi Eclipse
The Mitsubishi Eclipse is a mid-size coupe manufactured from 1990 to the present. As of 2009, the car is officially available in Brazil, North America, Saudi Arabia, Oman, Kuwait, China, UAE, South Korea and the Philippines.
2,030 Questions
Where is the horn located on a 1995 Mitsubishi Eclipse?
What would cause a cylinder 3 misfire in a 2003 Mitsubishi Eclipse GTS?
Usually a bad coil , or plug. if the injector was bad , the computer would have coded for it. But the cylinder 3 coil and plug arent that easy to get to. Its the one at the fire wall
How do i change a burnt headlight on a Mitsubishi Mirage 2000?
To change the burnt lightbulb simply take out the battery, remove the bulb connector, remove the rubber moisture guard, and unhook the attached wire, replace the bulb and return the aforementioned contents to their proper place. Total time about 12 minutes.
File et carpe diem.
How much boost can a non turbo 1.8 eclipse motor take?
If it hasn't got a turbo there's no place for it to get boost from.
What is the correct gap for a spark plug on a 1997 Mitsubishi eclipse GS?
.032 (In thousandths of an inch)
1997 Mitsubishi Eclipse 2.4L MFI SOHC 4cylThe Spark Plug Gap.044 (In thousandths of an inch)
1997 Mitsubishi Eclipse GSX AWD 2.0L MFI Turbo DOHC 4cylThe Spark Plug Gap.032 (In thousandths of an inch)
1997 Mitsubishi Eclipse 2.0L MFI DOHC 4cylThe Spark Plug Gap.050 (In thousandths of an inch) Heres all the engines for 1997 Mitsubishi Eclipse
Where is sunroof drainage for Mitsubishi eclipse 1998?
It is up in the front corners of the moonroof it might be a hidden by the moonroof track. If you take a look you should see a pen size hole and it drains into your wheel wel.
How do you reset service engine light on 2003 Mitsubishi eclipse?
DISCONNECT THE NEGATIVE BATTERY CABLE
Where can you find a wiring diagram for a Mitsubishi pajero 1992 model?
Go to the dealership that you bought it from or look in the manual thing that you get when you bought the car.
There are technically two types of "turbo coolers".
1. A radiator device to reduce the temperature of the compressed intake air after it's left the Turbo housing and before it reaches the engine. This is an Intercooler. Air heats up when compressed (look up the Ideal Gas Law) but cool air is denser thus carries more oxygen per unit volume. Since the fuel air mixture for combustion is tied to oxygen availability more oxygen per unit volume is desired. The Intercooler reduces the intake air temperature thus boosting combustion efficiency and reducing side effects like pre-ignition.
2. An automatic device to shut the turbocharged engine off after it has idled for several minutes. This allows the turbo housing to slowly drop in temperature from an active state to the lowest running state prior to shutdown. These devices are simply called a "turbo timer". Allowing the turbo to cool slowly extends the life of the turbo by reducing thermal stress. With some turbocharged engines such as in light aircraft this idle cooldown is mandatory.
What does the ignition coil do?
Ignition coils
Ignition coils are very rugged and reliable, but can fail for a variety of reasons. Heat and vibration can damage the coil's windings and insulation causing shorts or opens in the primary or secondary windings. But the number one killer of ignition coils is voltage overload caused by bad spark plugs or plug wires.
===========================================================
The ignition coil is basically a transformer. It converts a low voltage into a high voltage to create a spark at the spark plug.
The way it works may seem backwards, but basically, a low voltage (about 12 volt) electrical current is sent through a coil of wire (the "primary" winding), which causes an electromagnetic field to build up. When this low-voltage electrical is inturrupted (by the points in a conventional distributor, or by the engine's computer), it causes this electromagnetic field to collapse suddenly. As it collapses, it cuts across the windings of a "secondary winding" which is wound around the primary winding. Since the secondary has many more turns of wire than the primary, the magnetic field causes a much higher voltage (anywhere from 5,00 to 20,000 volts) to flow in it. This is the voltage that is sent out through the ignition leads to the spark plugs.
Why do they have it trigger the high voltage when the current is shut off rather than when it's turned on? Because, back when they first started making ignition systems for engines, they used mechanical "points" to switch the voltage on and off. When the points "made" to allow the current to flow, they had a tendency to bounce, causing the voltage to build up erratically. When they were opened, though, the current was shut off very rapidly, giving the sudden change in current flow necessary to create the higher voltage to be induced. Nowadays, with electronic ignition systems, it could be done either way, but they usually stick with the "old" way just because it's what they're used to.
How do you reset a Mitsubishi eclipse car radio 2001?
The radio has an annoying anti-theft feature that disables/locks the radio whenever power is lost (battery dies or is disconnected for engine servicing). When this happens the radio display will show CODE. Using the radio presets 1, 2, 3, and 4 you must enter your radio's four digit security code. Usually this is written on a card by the dealer and supplied when the vehicle is delivered. If you do not have your radio's 4-digit code, any Mitsubishi dealer should be able to provide it to you for free - if they try to charge you CALL ANOTHER DEALER. When you call you will need to give them your vehicle VIN number and sometimes they ask for the radio's serial number which is on a label on top of the radio unit. You'll have to pop the top dash cover off to view the radio serial number. I wrote my code down in the owners manual because usually need it every six months of so when I work on my vehicle and disconnect the battery. Keep it handy.
Where is the starter located in a 2000 Mitsubishi Eclipse GT?
The starter is located right above where your muffler connects to the engine on the front side of the engine. if you are looking at it from under the car.
Where can you find a stereo wiring diagram for a 1999 Mitsubishi Eclipse?
you could go to a nearest dealer to get the diagram or you could go to a website called "alldata" i don't remember if its .com, . net or whatever just look it up on a search engine or see if you could look it up online cause sometimes you can get lucky and find some diagrams
you can also go to www.the12volt.com the have the diagrams for almost every car out there, I used them to wire up a factory Toyota radio into a friends Tracker.
How do you program home link garage door opener on a Mitsubishi 1997 eclipse?
go to www.homelink.com and click on FAQ for programming http://www.homelink.com/home/faqs.taf
What size are Mitsubishi stock rear speakers?
the rear speakers are 61/4 inch I just dont know what the center speaker size is
How do you reset the check engine light on a Mitsubishi?
it resets every time you turn your car on. i have a 01 eclipse and the dealer told me that.
How long does a 1998 Mitsubishi Eclipse RS last mileage wise?
With proper care, a 1998 Mitsubishi Eclipse should be a viable vehicle for at least 150,000 miles or more. Modern engines and drive trains are especially and comparatively long lasting.
How do you program the remote garage door opener in a 1996 Mitsubishi Eclipse sunvisor?
2. Prepare transmitter by erasing all three of the factory default channels by holding down the two outside buttons until the red light begins to flash. Release both buttons.
3. Hold the end of your hand-held transmitter (garage door remote) against the Homelink transmitter keeping the red light within the Homelink icon in view.
4. Using both hands push the hand-held transmitter button and the deisre button to be programmed on the Homelink transmitter. Do not release the buttons at this time.
5. Hold down both buttons until the red light on the universal transmitter flashes, first slowly then rapidly. When the light flashes rapidly, release both buttons.
To program the remaining two buttons, follow steps 3-5. ==================================================================================================================
It should be in your owners manual. If you don't have one, get one from MOTORLIT.COM.
you hold the button on the visor while holding the button on your remote. once the visor light becomes solid, your set.
Do you have to remove the intake to change the sparkplugs on a 2000 Eclipse GS?
no u dont but u will need at least a 6" socket exstension to reach the plugs u also have to take the coil packs off the top to get at 2 of the plugs
