What is the sputtering noise coming from the exhaust manifold on a 1994 Mitsubshi Eclipse 1.8?
If the sputter dissipates when the engine gets warm then a portion of the exhaust manifold is not tight against the engine block and is letting exhaust gas escape until the metal heats up and expands, if no then you might have a break in the exhaust gasket. Nothing that will harm the car or keep you from passing a smog test but annoying for sure. In my case the last bolt on the end of the manifold broke for some reason and caused the same sputter, I ened up removing the bolt and replacing it and the sputter went away. Good luck
What is the spark plug gap on a 1999 Mitsubishi Eclipse?
In Mitsubishi eclipse rs with Crysler (2.0 DOHC) engine 0.037-0.039.
Where is the location of a starter on a 2003 Mitsubishi Galant?
3.0 V6 (1999-2003): The starter motor is located behind the front exhaust pipe toward the driver's side of the oil filter. Are there pictures on removing it .
You need to remove the gas tank to replace the fuel pump. The tank contains the pump. It is A good idea to replace the strainer and filter when replacing the pump, They are both actually just filters and you cannot get the fuel too clean, but it can be too dirty.
Where is the amplifier fuse located on a 2001 eclipse gs?
The Audio with Amplifier fuse is No. 15 in the fuse box. It should be a yellow 20 amp fuse. The box is located in the engine compartment driver side above the wheel well.
Where is the fuse for the 2003 eclipse cigarette lighter?
it may be marked on the fuse box ..of not start pulling one fuse at a time utill you find it
Mitsubishi Eclipse GS-T How do you upgrade it's Horsepower?
i have a 97 eclipse gs.. to get you started get a cat back 2.5 inch then a cold air also change your trans to LSD because your car sucks right about now with one wheel pulling the 100 dollar insert works okay then your gs is a gst with out a turbo..[[ [take your time with the trany]]]]] also the act flywheel is a great improvement and get the egr cut off plate i am working on my breaks right now front rotors from a gsx but there to big so you have to get a caliper bracket from the gsx i am doing this because the gsx has bigger breaks in the front and what do you stop on .. the front breaks lol then i am gonna boost in a bit but watch your oil the 420a is crap stock ..gay i know but eBay has h beam rods to fix that eBay will be your best friend for starting out also i find the rest of my parts off horsepowerfreaks.com they got everything that you need for the gs i know i have been playing with my car for about 2 years now ..
What is Mitsubishi part no md113566 for?
Mitsu part # MD113566 is a relay for the Mitsubishi charging system (alternator relay).
2001 Eclipse gs what type of manual transmission fluid?
DSM or Mistubishi/Chrysler imports probably use ATF-4, but its is most likely on the dipstick or manual.
How to change Fuel Filters Mitsubishi Eclipse 1994-18?
http://www.autozone.com/servlet/UiBroker?ForwardPage=/az/cds/en_us/0900823d/80/1c/b5/e2/0900823d801cb5e2.jsp
How do you replace the timing belt on a 1992 Mitsubishi eclipse 4 cylinder dohc manual?
Remove the timing belt cover. There should be a pully that will ratched in and out to tighten and loosen the belt.
You want to install dual turbos on my 5.7 liter engine what size turbos should you use?
t/3 t/4 turbos , should be efficient enough.
if the windows switches are on the door panel, you may have broken wires between the door and the body.
Does a 2002 Mitsubishi Eclipse have automatic headlight or daytime lights?
No they did not come factory equipped with daytime running lights.
Where is the fuel pump relay on a 95 Mitsubishi eclipse?
The relay is located undert he center consol. It's black with a black rubber boot on it. You can take off the side panel on the passanger or driver side and get to it. This is the fuel pump relay. Mine went bad I was not getting any power to the pump. I replaced this relay and pump works great! Thanks, Jenn The relay is located undert he center consol. It's black with a black rubber boot on it. You can take off the side panel on the passanger or driver side and get to it. This is the fuel pump relay. Mine went bad I was not getting any power to the pump. I replaced this relay and pump works great! Thanks, Jenn
Where is the oxygen sensor located on 2004 Mitsubishi eclipse?
You can find them in the exhaust pipe. Depending on engine size you might have anywhere from 2 to 4 oxygen sensors.
Do all Mitsubishi eclipse have center speaker?
I dont have one and I have a 2001 gt but my clock pod has the speaker cover on it so idk
Which stage will the Moon always be in during an eclipse?
Moon.
[URL=http://imageshack.us/photo/my-images/717/tle2004octgmt1.gif/][IMG]http://img717.imageshack.us/img717/3190/tle2004octgmt1.gif[/IMG][/URL]
For the eclipse to occur the Earth, Sun and Moon have all got to be on the same line. For lunar eclipse, Moon has to be behind Earth, looking from Sun, so Earth's shadow could cover it. Also, Moon has to be behind Earth for full moon - that's when we see the biggest part of it lit.
Moon can't be possibly eclipsed during new moon, because it's then located between Earth and Sun and therefore Earth cannot cast on it a shadow.
Also, solar eclipses can only occur when Moon is located between Earth and Sun, ie. in new moon phase.
In order for a lunar eclipse to occur, the Moon must be directly 'behind' the Earth,
exactly opposite the Sun and in Earth's shadow. It's behind the Earth, opposite
the sun, once every month, and that's the position for a Full Moon. But it's usually
above or below the shadow, which is why we don't have a lunar eclipse at every full moon.
How do you program a key chip for a Mitsubishi eclipse?
Locate the Data Port under drivers side dashboard usually located to the right of steering column.
Insert keys in ignition and leave in the OFF position.
Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Port terminals 1 and 4 with a suitable jumper wire, leave the jumper wire connected throughout the programming procedure. Make sure you know which terminals are 1 and 4.
Within 10 seconds after connecting the jumper wire, press the Hazard Switch 6 times. Note: The doors will automatically lock and unlock once at this time indicating that the system is in the programming mode.
Press the LOCK button on the remote to be registered three times within 10 seconds. Upon successful programming, the door will lock and unlock once.
Repeat step 5 with up to 4 remotes (including any existing remotes) within one minute. After completing each programming, the doors will lock and unlock once.
Disconnect the programming wire and remove the keys from the ignition.. Locate the Data Port under drivers side dashboard usually located to the right of steering column.
Insert keys in ignition and leave in the OFF position.
Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Port terminals 1 and 4 with a suitable jumper wire, leave the jumper wire connected throughout the programming procedure. Make sure you know which terminals are 1 and 4.
Within 10 seconds after connecting the jumper wire, press the Hazard Switch 6 times. Note: The doors will automatically lock and unlock once at this time indicating that the system is in the programming mode.
Press the LOCK button on the remote to be registered three times within 10 seconds. Upon successful programming, the door will lock and unlock once.
Repeat step 5 with up to 4 remotes (including any existing remotes) within one minute. After completing each programming, the doors will lock and unlock once.
Disconnect the programming wire and remove the keys from the ignition..
Where is the Intake Air Temperature Sensor on a 2001 eclipse?
i think u r talking about the MAF sensor or mass air flow sensor which is like half way between the air filter and the intake manifold on the air tube
Does a 1995 Mitsubishi eclipse have ABS brakes?
IT MIGHT HAVE IT...LOOK UNDER THE HOOD TO SEE IF YOU CAN FIND THE ABS UNIT AND IT'S OIL RESERVOIR. GOOD LUCK!...BB
Clutch disc is worn out. Not knowing what vehicle you have, most are hydraulically operated and there is no adjustment. Time for clutch replacement.