How do you reset your abs and trac off light after abs unist are replaced?
It is more question than the answer. I have ABS light on all time and turn off light on also all time (talking about ther ABS brake system on Chevy impala 2001 ls 3.8.
I drive ok and brakes are ok. But light stays on makes me nervious all time. Someone said cut them to the hell! But I want to cut them off by right way: to understand why light on and how to stop the problem.
Pads are new? everything ok and there isn't any wrong in brakes working. Others say something here is dirty I need to clean for contacts. Other also say a unit ABS computer ar center.
No idea what reason !
Tell me please someone in order i can drive my car without being nerviuos on this reason all time thinking about that. Evern can't take a baby to the car she will say your brakes don't work we can't have the love on the hill tyou car can move from the hill itself to the river... Ha-ha-ha...
What is the location of backup light switch on a grand prix?
look where the transmission shift linkage attaches to the transmission, there should be a proximity switch there, likely the only thing with wires going to it on the assembly.
P1416 is your O2 censors.
ANSWER:
P1416 refers to a problem in the exhaust system which is, unfortunately, very difficult to track down. Depending on who you talk to about it, you can do nothing and never have a problem or you can do nothing and it can ultimately lead to a problem with the catalytic converter. Damned if you do and damned if you don't.
We also had this problem on our 1999 Grand Prix...it could be your moon roof drain tube as well that come out in your door jam on both sides. Ours was on the passenger side and it got dirt down in there and we had it blown out. No more leaks.
AnswerI had this problem with my 2001 Grand Prix. The windshield was replaced before I bought it and whoever installed it didn't put the cover over the air intake for the HVAC. The intake on mine is under the grill directly under the windshield on the passenger side. The water would run straight down into the intake and drain out by the fan and lower vents. This fried my resistor block (located in the blower housing). You should be able to find another cover in a junk yard. I made a temporary cover using a peice of tarp and caulking to make sure that any water that drained down would flow past the intake. ANSWERI just recently had this problem with my 1998 grand prix gt, i had the same problem as the first post answer, the little rubber strip above the heater was moved over about an inch, so i moved it back and put black caulking underneath so it would not move again.. i still had a leak somewhere.. so i ran a bead of black caulking along the plastic shroud that's underneath the whiper blades, beginning at the start of it, and ran it to the middle of the shroud, almost to where the red blinking security light is on your dash.. my floor since has been drying up nicely..Sometimes the drainage holes in the firewall get clogged check those
What is code p0102 on a 1999 grand prix 3.8 v-6?
Trouble code P0102 means:Mass or volume circuit low input
How od I fix a Grand Prix trunk leak?
Do you have a spoiler? Could be coming from the bolts holding it on.
What does a 1991 Pontiac grand prix headlight look like?
rectangular, tapering in n up towards hood. its holds 2 bulbs
Can you put a cold air intake on a 1995 se grand prix?
There are 2 yas to put a cold air intake on it is to cut out a hole big enough behind the driver side head lights to fit it in there. The next way " more expensive " is to buy a hood or put vents in the stock hood and run that way. The easiest bolt on air performance upgrade is a air ram kit which is simply an open type filter like a cold air intake but not able to get fresh air.
keep the engine full and just drive it OR replace the engine
Torque specs for 1998 Pontiac Grand Prix?
The torque of the 1998 Pontiac Grand Prix is 220 ft.-lbs. at 4000 rpm. This remained the standard for all sixth generation models of this car.
How do you do a burnout in a 2002 grand prix gt?
If the car has traction control you must disengage it first, then if you are doing a stand still burnout engage the parking brake provided that they work. If you are doing this from a traffic light and plan to proceed down the road disengage the t/c and then hope that your car has enough juice to spin the tires
Is a Pontiac grand prix considered a sports car?
Is a Pontiac Grand Prix considered a sports car?
A Sports car was a car that could be raced in the Grand Prix on the weekend and used to take the kids to school during the week. Generally it has no back seat, light weight, and has the engine between the wheels for better weight distrubution. It was a track racing, street car. The Pontiac Grand Prix is 100% street car. Despite its name it is not a racing, or sports car.
How can you get the crank sensor out of the block when it is broke off?
http://mykidz.net/GTP/CrankPosSensor.shtml
Hope this helps.
"G" OK ITS THE METAL PART THAT GOES IN THE ENGIE
Is a cabin air filter for a 2006 Pontiac grand prix the same as an air filter?
No, the cabin air filter is of a size and design to filter the air inside the cabin of the car.
The "air filter" refers to the filter used to provide filtered air to be taken into the engine for combustion.
Hope this helps.
"G"
How do you install a heater hose fitting on 2004 Pontiac grand prix gt?
First remove the resovoir tank to have more space. Remove drive belt. Two top bolts and 1 side bolt to remove alternator plus connections( power and ground). Then 3 remove 3 bolts from tensioner housing and remove. Should come out with heater hose fittings. Be careful the fittings could break in manifold. Finally replace fittings and reinstall housing, bolts,alternator w/ connections, drive belt and reservoir tank. Used Dorman heater hose fittings # 47065 from local autoparts store autozone/ oreilly's have replaced them 6 times in past year. 6th was 2 days ago.keep blowing out... its true practice makes perfect. Wrote this in 5 mins!
What is the bolt pattern for a 2001 Pontiac Grand Am?
If its the 2001 model it should be 5x115, pattern is different prior to that year. Hope this info helps!