0
Pontiac Le Mans
The Pontiac Le Mans was a family of compact and intermediate-sized cars produced between 1962 and 1981 by General Motors’ Pontiac division. It was introduced in 1961 as the top-of-the-line version of the Pontiac Tempest.
213 Questions
Where does the fuel line and water pump connect to on a 1974 Pontiac Lemans 350ci 2bb?
On a 1974 Pontiac LeMans with a 350ci 2-barrel engine, the fuel line connects to the fuel pump located on the engine block, typically mounted on the driver's side. The water pump, which is also mounted on the front of the engine, connects to the radiator via a hose for coolant circulation. Ensure that both connections are secure and free from leaks for optimal engine performance.
What are the tune up specs for a 1962 Pontiac tempest lemans?
The tune-up specifications for a 1962 Pontiac Tempest LeMans typically include a spark plug gap of 0.030 inches, ignition timing set at 4-6 degrees BTDC (before top dead center), and a idle speed of around 600-800 RPM. The recommended points gap is usually 0.019-0.021 inches. It's also important to ensure that the air-fuel mixture is correctly adjusted for optimal engine performance.
What is the firing order for a Pontiac Sunbird 2.0?
The firing order for a Pontiac Sunbird with a 2.0-liter engine is 1-3-4-2. This means that the first cylinder fires, followed by the third, fourth, and then the second cylinder in that sequence. This firing order is typical for many four-cylinder engines, helping to ensure smooth operation and balance.
Why would your rear passanger wheel lock up?
Your rear passenger wheel may lock up due to issues with the brake system, such as a stuck brake caliper or brake pad. Other possible causes could include a malfunctioning wheel bearing or a problem with the suspension components. It is important to have the issue diagnosed and repaired by a qualified mechanic to ensure safe driving.
Reman or used engine. You can rebuild the lower end of the engine, but it seems like an engine that has cancer. That is, shortly after doing the lower end, the upper starts with problems. Just from what I have seen. Would appreciate any info anyone else has.
The best bet is usually a used engine for cost effectivness and down time concerns. Not much rebuilding happening at the dealership level, even for warranty repairs.
How do you install a fan shroud on a 71 Pontiac lemans?
If it's new, you may have to cut it to fit.
You don't need to remove the fan to install it, just slide it in between the fan and the radiator. It will be a very tight fit, just go slow. Once it's in, you will need to install the 4 bolts on the top, and 2 on the bottom.
How do you replace the water pump on a 1990 Pontiac Le Mans?
Hey Connie==Get a manual from a parts store on your car and it will tell you how. You may need to get a manual from MOTORLIT.COM. Good luck Joe
First buy a new thermostat, water pump and timing belt. Unsnap timing belt cover and remove top outside portion. Take off top belt pulley which is actually the power steering pump pulley. Note aligning mark on top timing belt pulley which matches a notch in the back of the timing belt cover. Also notice the bottom belt pulley has a notch which aligns with a protruding point on the belt cover next to the bolt where the back cover is attached. Remove the bottom belt pulley (not for the timing belt but the accessories) Try to align the top timing belt pulley which will align the notch on the accessory pulley before removing the pulley. Once the top pulley is removed you can remove the timing belt being careful to not move either base where the pulleys were attached which would mess up the timing. Remove the power steering pump (turn small nut on end of pipe into pump housing) and remove hose from other pump line. Now you can move the cover enough to remove the water line housing containing the thermostat. This should be replaced now since it is so much trouble to replace separately that everything should be done at the same time. The thermostat gasket has a slot to fit over both sides of the metal flange. The water pump is held by 3 Allen wrench bolts (metric good luck) and is also the timing belt tensioner. Install new pump and timing belt making sure marks and notches are correct and belt is tight enough using the turning of the water pump. Reassemble everything else.
How do you determine if you have a rod knock?
Always check your repair monuel before using any tip to see if it will hurt your electrical or ignition system. Increase the rpm until the noise is heard then disable one fuel injector at a time. When the noise quits you have found the cylinder with the problem. If your engine is carb you have to pull one spark plug wire at a time to determine the cylinder. If the noise does not quit the problem is in the top end of the motor or the belt or acces. system. One last hint, cracked automatic flywheels will sound just like a rod bearing.
What is Jacque Lemans most known for?
Jaque Lemans is a men's accessory company that is most known for their production of designer watches. The watches are especially popular in various countries in Europe.
It is the fuse for your Fan.
How much horse power does an 89 Pontiac lemons SE have?
74 ground-pounding horsepower with the 1.6 liter engine.
There are no timing marks on the water pump.the only timing marks are on the crankshaft and camshaft gears.And if you're working on a quad-four engine as I suspect you are,you will need to line up the holes in the cam sprockets with the holes in the block and insert pins to hold them in place.The correct size drill bits will work good for this if you don't have the special GM tool.
Does anyone have the timing marks for a 68 lamans with the ohc engine in it?
its been awhile all i know it runs the same as a Oldsmobile same motor it run conter clock wise
An LMS is a learning portal-or an online learning platform-meant to automate the delivery of eLearning and mobile learning courses to learners. To put it simply, add users, add courses, and assign courses to learners, and view reports of completion, test scores, certificates, and analytics data. Corporate clients use an LMS to ensure anytime, anywhere delivery of eLearning courses to their employees, customers and partners. Training companies create eLearning courses and distribute it to their customers who are either learners who want to subscribe to their courses or to corporate customers who want their employees trained.
Who Uses an LMS?
Any organization or business that wants to create a high-impact learning organization that drives efficiency. Businesses that want to leverage the right kind of learning technology to maximize business impact use LMS. L&D Teams that face challenges to manage and train people for the uncertain future requirements opt for a modern LMS.
You know you need an LMS when -
- Most of your time is spent on administrative tasks like managing a training calendar, booking training rooms, co-ordination with trainers, monitoring attendees, provide training material, tracking completions and so on
- Assessing the impact of training programs is tedious and often unproductive. Preparing training needs analysis document, collection of feedback, course completion reports is cumbersome
- Information silos are killing your training program efficiency
- You want to sell courses online and setup a revenue stream
Read more about an LMS in details at - Abara LMS
How do you install radiator 1971 Pontiac lemans?
Drain the radiator of fluid, take the shroud off if it has one, take top and lower radiator hoses off the radiator, if automatic transmission you need to take the 2 lines that go into the bottom of the radiator off, unbolt the 4 bolts that hold the radiator in to the radiator support and pull the radiator out, to install new radiator just reverse the process.
What is the rotation of the firing order for an 1991 Pontiac firebird 3.1?
According to my Chilton book :
The distributor rotor turns CLOCKWISE
The firing order is ( 1 - 2 - 3 - 4 - 5 - 6 )
The engine cylinder locations are numbered :
firewall
5 - 6
3 - 4
1 - 2
front
And according to the picture , the # 1 position on the distributor cap faces towards the FRONT
What is the timing degrees starting point for a 302 out of a 1977 monarch?
You should start out at 6-8 degrees btdc. The higher you can run without spark knock or detonation, the better performance the engine will have. A higher grade gasoline may allow up to 20 degrees advance of advance. For stock purposes, 6-8 is fine.
Where can you get A replacement Key for Ignition and door locks for 1989 Pontiac Le Mans?
A locksmith will be able to obtain a suitable key blank and be able to grind a new matching key. The other way would be to find a car at a junkyard that still has the key and pull the lock cylinders.
