0
Saturn L-Series
The Saturn L-Series was a range of vehicles produced in 2000 to 2005 by Saturn Corporation. Based on the Opel Vectra B, these mid-size sedans and station wagons were offered with straight-4 and V6 engines with 5-speed manual/4-speed automatic transmissions.
976 Questions
Where is the ac expansion valve on 2001 Saturn L's?
on the firewall. Follow the a/c lines to the wall remove the lines and the x-valve is right there It is "hidden in the insulation ...tricky to get in
Does an 02 Saturn L200 Have a timing belt or timing chain?
The V6 Saturn used a timing belt. The 4 cylinder's used a timing chain.
What does the service engine soon light mean on a 2000 Saturn LS?
It means that anything from a malfunctioning sensor to serious engine issues But there is a quick and FREE way to find out EXACTLY what is wrong. You only need to take your vehicle to any Autozone, O'Riely autoparts, or napa, I personally would advise you to go to autozone if there is one near you, if you need a part for your car later they are the cheapest, easiest, nicest, and also lifetime warranty ;) But anyway just take your car to any of these locations and tell them you have a check engine light on and you would like them to check your cars computer which will be OBD2 standard "todays standard" and within seconds-minutes you will know exactly what is wrong with your car because the tester will read the error code that set off the light and display the problems and its all FREE ;) no strings attached, its a free service they offer, along with testing your battery and alternator. Hope this helps.
How do you replace stereo in 2000 Saturn?
Depending on wich Saturn its really easy just pop off the dash around the radio remove the screws take out your radio unplug the wires and buy a new radio w/ wiring harness and face plate.
My 2003 Saturn L300 shifts hard?
A couple things can cause a computer controlled auto transmission to shift hard:
1. the speed sensor can be disconnected or not functioning properly.
2. the computer may have detected a transmission fault that caused the computer to put the transmission into "safe" operation mode. When it does that it causes a condition called "high line", meaning high hydraulic line pressure, which forces hard shifts in an attempt to save clutches that might otherwise be damaged if something is not functioning properly in the transmission.
Unfortunately, this is one of those situations that you'll probably need to take the vehicle to a specialist; either a transmission shop or the dealer.
How much does a car passenger window cost?
That depends on how much you want to spend.
A new window can be quite expensive, but a USED window can be relatively inexpensive and in general, a good way of repairing a problem.
Glass doesn't typically "wear out", so a used side window will function as well as a much more expensive new one.
I recently purchased a 1994 Saturn drivers side rear window for $35. It functions as well as a new one and after it has been installed, it's virtually impossible to tell the difference between new and used.
What does it cost to replace a fuel pump on a Saturn L 300?
Replacing the Saturn L300 fuel pump will cost approximately $450. The exact cost is dependent upon several factors, such as the rate for labor.
Why would the floor board be wet on a 2002 Saturn L200?
Check your sunroof drain hose. mine came loose and when it rained my floorboard was wet.
How do you check the transmission fluid in a 2000 Saturn L series?
No dip stick. That's supposed to be a "sealed" transmission, meaning that you shouldn't need to service it; but this is the real world so we all know better.
There is an access plug at the side of the transmission just for checking the fluid level. You'll need to either have someone show you where it is or you'll need to get the book so you can find it.
Where is the port for freon in Saturn l 300?
Some old advice is still very appropriate, especially in the age of such complex machinery. "If you don't know what it is, don't mess with it." That certainly holds true for automobile air conditioning systems.
BUT...
The AC refrigerant portS are on the AC hoses; one is near the compressor, the other is behind the engine. If you're planning to add refrigerant, you should use gauges that test both the high side AND the low side.
Recalls on 2000 Saturn Ls-2 models?
The tail lights were recalled and a more reliable replacement has been available for several years.
There was a problem with a gasket on the cooling system.
There was a problem with the original coolant.
There was a problem with the AC seals.
The original tires (Firestone) were on a "service bulletin".
Clean the sensor in the Air tube between the filter box and the throttle body. I believe it is an air temperature sensor. If that doesn't work try replacing it. You will probably also have a "Service Engine Soon" light. go to Auto Zone and have your code read for free. While there get some mass air flow sensor cleaner and spray the sensor, also get some dielectric grease and use this on the plug in connector you may only have a bad connection. This should fix the problem, but if it doesn't the code you get from Auto Zone will lead you in the right direction, they can give you an explanation of the code and what needs to be done to fix it. Once the problem is corrected you may have to drive around 50 miles for the code to reset itself. Auto Zone will not reset your codes, only read them for you.
How do you change a clutch express L300?
Jack up vehicle and place 4 stands front and back so you can easily roll in and out of under the car. Disconnect battery.
1. Remove tailshaft (4 bolts) at the rear uni joint.
2.Remove speedo cable and disconnect reverse light wires and earth straps attached to gearbox. Disconnect clutch cable and gear selectors,
3.remove bolts that hold the starter motor and push starter motor back
4. Remove remaining bolts around the bell housing
5. Place jack on wheels under the gearbox pan and jack up (At this point you may want to drain the gearbox oil prior to using the jack to make the gearbox lighter)
6 remove gearbox rear mount bolt and nut
7.Gently pull the jack backwards and remove the gearbox and bell housing
8. Remove clutch assembly from flywheel by unbolting the securing screws.
9.remove flywheel and get it machined. Replace the spigot bearing.(6002V bearing).
10. refit flywheel with a bit of loctite 243 on the nuts and tighten to approx 65ft/lb.
11. Fit new clutch plate and flywheel and use a clutch aligning tool while doing this. It is so the shaft lines up with the cluth plate.
12. Remove old clutch thrust bearing and clips from bell housing and clean up the shaft and bell housing. Fit new thrust bearing with a light smear of grease on the shaft where the bearing slides and grease the shaft spline lightly. Carefully put the clips in either side of the thrust bearing and attach to the pivot. Check the bearing pivots smoothly by moving the clutch lever back and forth.
13. Align gearbox on the jack and insert into the clutch assy.
14. if gearbox is not going in far enough for bolting up, have someone put a wrench on the engine bottom pulley(harmonic balancer) and gently rock back and forth while you manouver the gearbox shaft in.
15. When shaft and gearbox has gone in as far as possible start bolting up and this will pull the gearbox in the remaining 5-10mm. Bolt up slowly and sequentially so the gearbox is being pulled in evenly.
16. Refit starter motor and tailshaft. Check everything is reconnected and bolted up. Gearbox oil top up.
17 adjust clutch cable if needed.
As far as clutches go this is a straightforward job that needs approx 4hrs to reassemble once you have all the parts and flywheel machined. You only need basic tools 13mm ,14mm, 17mm, 12mm sockets and socket extensions , 15/16" socket for gearbox pan. Ring spanners for tailshaft, Pliers.
Car still running after turned off and key removed from ignition?
The throttle may be jammed. If the car has been unused for a period of time make sure that the throttle mechanisms are well lubricated.
How do you change the starter on a 1996 Saturn?
Disconnect the battery from the car. Raise the car and support as you will be working underneath the entire time. The starter is on the back side of the engine bolted into the transmission with two bolts. The bolts are the same size, the front bolt is easy, the back bolt is easy to remove with a 3/8" drive wratchet with a 4-6" extension. Putting it back in is a trick. Unbolt the starter and pull out of the transmission. Undo both bolts holding the wiring on than remount the wiring to the new starter. Put it back in place and put in the bottom bolt first, bring it up close to snug but allow yourself some play to move the starter for the top bolt. Take your wratchet and extension and put a good glob of grease into the socket than insert the head of the top bolt. The grease will allow you to keep the bolt in but still allow you to pull the socket off when completed. Slide it behind and feel for the hole, than move the starter slightly until you catch a thread. Tighten it all up than reconnect your battery and your good to go.
How do you turn off or reset a check engine light for a 1999 Saturn SL2?
I had a 1999 Saturn SL2 and my husband took both the battery cables off and then replaced them. This caused the check engine soon light to go off. == other answer== Depending on what triggered the light to go on, you could fix it, and the light has a chance to go out on it's own (I have had mine come on 4 times , 2 of which I have had to reset with a diagnostic computer from a local parts place, once it went out on it's own [bad spark plug] and THIS time it's still on) the answer above is correct only to the point of the next self-diagnostic check from the car, if something is still wrong, the light will come back on The " check engine light" is by far one of the most misunderstood technological advances It is a warning light that is illuminated when there is a problem affecting the EMISSIONS of the vehicle.. Don't let it bother you as it is a good thing once you understand it. One point that was brought up a recent meeting of technicians was that the amount of hydrocarbons is greater when the gas cap is left off than when the engine is running. Hydrocarbons are part of pollution emitted as gasoline evaporates. Going a step farther, one facet of the emission system is the "Evaporative" portion. This is when the fumes from the gasoline are leaking from the system into the outside air. This is one part of the emission system that can trigger a check engine light. I would say a small percentage of the vehicles that have a check engine light are the result of a loose or inadequate gas cap. But understand that many scenarios are possible with the "check engine light" The vehicle's powertrain computer (note that some vehicles have multiple computers aside from the powertain computer) will run a series of self-tests. They will only run under certain criteria. And they are different from manufacturer to manufacturer. Some self-tests or
Where is the accelerator pedal position sensor on a 2001 Saturn 3.0L?
There is a throttle position sensor mounted to the throttle body. That's the place where the air intake valve sits near the top of the engine. Look for the throttle butterfly valve; on the end of the butterfly valve shaft should be a little sensor with wires connected; that's the throttle position sensor.
How do you remove the door panel to replace the speaker in 1994 Saturn SL1?
on my 95 SL1 the plastic screen over the speaker just pops off with a screwdriver. dont take the door apart if you don't have to.
