answersLogoWhite

0

Toyota 4Runner

The 4Runner is a mid-size sport utility vehicle (SUV) produced by Toyota Motor Corporation since 1984. This SUV is offered in four-wheel drive (4WD) and rear-wheel drive (RWD) layouts.

3,192 Questions

What size speakers are in a 2004 Toyota solara?

6 x 9 's all around. Although most refit 6.5" in those space for better bass.

Is there a kill switch on a 95 Toyota?

None I ever heard of that come factory installed.

What is the city and highway range of the 2010 Toyota 4Runner in miles?

The EPA range estimate for the 2010 Toyota 4Runner is 432.0 mi. in the city, 552.0 mi. on the highway.

Where are the fuses in a 2000 Jetta?

On the drivers side, at the left side end of the steering wheel there is a compartment which houses the fuses. You need a flathead or strong fingernails to pop the cover off and access the fuses. There are also some fuses and relays under the hood, just above the air filter box.

How do you reset alarm on 1998 Toyota 4 runner?

The Toyota 4 runner will not start, it sounds like it is going to and it will not, the starter, spark plugs are fine?

Are the threads on the bolt for the crankshaft pulley Left hand or right hand threads?

Toyota 4runner 1999 has right hand threads. I used a flush gear puller (washered out between the puller halfves to allow alignment of two drill bits into holes in crankshaft pulley and also allows enough room for 19mm socket to be used on crankshaft pulley bolt, I then used a deep socket over one of the puller bolts (nut end) with a couple of extentions wedged against the truck frame ) then with a half inch drive breaker bar and a four foot cheater pipe was able to break the torque on the nut. However the bolt on my gear puller will have to be replaced (bent), but I didn't have to purchase or manufactured any special holding tool.

Where is the knocking sensor located on 1990 Toyota 4Runner?

Its located deep inside the motor, between the heads. You have to dismantle the the whole top of the motor to get to it. I just had a blown head gasket repaired, and the mechanic showed me the knock sensor and said that while the heads were off and the engine was stripped down, and he could actually get to it, that I should replace the wires leading to the sensor.

Why use synthetic motor oil?

synthetic motor oil doesn't break down nearly as fast as conventional oil it also can have greater lubrication and anti rust protection.

What would cause your 1999 4runner to get 10 -12 mpg?

If you have no trouble light I would suspect an injector or the cold start injector of dumping fuel. Do you have an exhaust leak? If so the O2 sensor will get the wrong information and dump more fuel. How is it running? Rough, no power, slow to accelerate? Check the filters and intake manifold for clogs in the tubing and vacuum hoses. Even the permanent ones can get clogged and not allow vacuum to key components.

If there is a check engine light on do a diagnostic check to find the code and it could point you to the exact component. If need be pull into an auto parts place. They usually do the check free of charge. You just might have to sit around for a bit why they get to you.

How do you find top dead center on a 1988 V6 Toyota 4Runner and set the timing after an engine swap?

top dead center for cyl. #1 is when the notch on the crank lines up exactly with "0" on the timing cover. if you have the upper timing cover off, the marks on the cam gears should be up and in line with the marks on the metal plate behind the gears. if all those things are lined up, the engine has cylinder #1 at TDC of the compression stroke. to set the distributor at this point, find where the #1 plug wire is. trace its location down to the distributor body and mark on the distributor EXACTLY where the electrode is. (you need to be able to see where its supposed to be because you cant install the distributor with the cap on) now remove the dist. cap. before installing the distributor, turn the crankshaft counterclockwise just a little to line up the notch on the crank to the 10 deg. mark. now install the distributor so when its fully seated, the rotor points directly at the mark you made on the distributor. (you may have to remove and remesh the gears a few times to make this work, you also have flexibility with the built in adjustment on the dist. itself) this will be very close to correct ignition timing. after the engine is running it should be checked with a light.

What is the rear wiper size for 1999 Toyota 4Runner?

A toyota-only 13 inch rear wiper blade that you need to get at the dealer. The front wiper blades are available aftermarket. See sources and related links below for more information.

How do you change front wheel bearing on a Toyota 4-runner 03 model?

I went on Ebay and found a tool that does the job in 15 minutes. It's listed under Rear Axle Bearing Puller Tool-09521-25011 Toyota Trucks.

1995 Toyoto 4 Runner fuse box diagram?

Fuse box diagram for a 1995 Toyota four runner

How do you fix power windows in a 1988 Mazda 626?

Since there's not enough info for a specific answer, here's the first thing to check.

You say windows, meaning more than 1 not working - if none are working that would be the fuse for that whole window circuit. Check the fuse box in the driver area, and the fuse box in the engine compartment.

That's the first check - because you really don't just "fix" them without knowing what's wrong with them.

What does ect mean on a 1996 Hyundai Elantra?

I think the question might refer to the switch near the transmission gear selector. If so, it stands for Electronically Controlled Transmission. Basically it just gives you some more power. I believe that it delays the shifts until a higher RPM is reached. Of course this only relates to an automatic transmission, and it will probably decrease your miles per gallon. Engine Coolant Temperature

What is the wheel base of the 2003 Toyota 4Runner?

The 2003 Toyota 4Runner has a 9 ft. 1.8 in. (109.8 in.) wheel base.

How do you replace cigarette lighter in 1990 Toyota 4runner?

You need to remove the heater conrol knobs, cover plate, and a/c button. Then remove the lower trim infront of your center trim, next remove the center front trim that the cigarette lighter is located in there are a few screws holding it on then a few clips just pop off with it. Once that is removed you need to disconnect the clock, unscrew the retaining ring on cigarette outlet, disconnect the positive plug, and clip the ground wire as close as you can to the old connection. Once that has been done, get your new outlet add a fitting to the wire you just clipped and plug it all together. Reconnect everything just as you took it off.

Why Window washer fluid doesn't spray Toyota 4 runner?

IT COULD BE BECAUSE OF THE LINES BROKE OR THE CANTAINER SOMETIMES HAS A PLUG, TO TELL IT TO SPARAY

Where is the radiator drain plug on 1997 Toyota 4-runner?

Most of the radiator drain plug lies at the bottom of the radiator. Check your car handbook or just look in the bottom of the radiator

Why does my engine make a tapping noise at idle?

possibly low oil or low oil pressure, the tapping may be coming from the oil operated hydraulic lifters.

Where is oxygen sensors for 1997 Toyota 4 Runner?

On the exhaust line just behind the area where the 2 manifolds become one but before the catalytic converter. Should have a shroud around it.

How do you roll down the rear windows in a 1991 lebaron?

The drive motors for the rear sit at the bottom of the window wells. Water runs into the area, and if the drain holes are not kept clear then water builds up above the level of the vent holes in the bottom of the motors. The entire window assemble can be removed, held by only three bolts (don't cut the back of your hands in this area). Either replace the motors, or clean the insides of the brush and contact area with a dremel wirewheel. Lube with white grease do slow the return of the corrosion.

How can Daytime running lights be turned off in Toyota Camry solara?

You cannot turn them, at leas not officially. The work around is to remove running light relay.