0
Toyota Highlander
Also known as the Toyota Kluger in Australia and Japan, the Toyota Highlander is a 4-door, midsize crossover sport utility vehicle (SUV) produced by the Japanese auto builder Toyota Motor Corporation since 2000.
1,728 Questions
What is the tire pressure for 2010 Toyota Highlander?
The recommended tire pressure for a 2010 Toyota Highlander is typically around 30 to 35 PSI (pounds per square inch) for both the front and rear tires. It's important to check the owner's manual or the tire placard located on the driver's side door jamb for the exact specifications, as they can vary based on the specific model and tire size. Always ensure tires are inflated to the proper pressure for optimal safety and performance.
Where can you find a parts or repair manuals for Deutz or Memo tractors?
Ward Bros. Tractor they have alot of manuals in Hendersonville, NC.
My Brake tail Lights Stay on when my car is complete turned off and my lights are off to.
How much does it cost to replace a rear spindle on a 2003 Hyundai Tiburon?
If you purchase at the dealer it will cost between $300 and $400CAD Junkyard it will cost you between $50 and $100?
Remove a stuck CD in a Toyota Highlander?
How do i remove a stuck Cd from my 2005 Toyota Highlander? The CDs will not eject.
It couylld very well be a strut or upper bearing. This is not a job for the backyard mechanic.
How do you replace fog light lens on 98 740IL?
I have a 740 and the lens or bulb can not be replaced. Mine was broken by rock on road and had to replace the whole assy. It is $220 from dealer and 145 from on line autohaus in Arizona.
Appalachia highlands on a map?
The Appalachian Highlands are not a destination or location and therefore do not appear on a standard map. They are a defined geographic area that run (roughly) from the Virginia/Pennsylvania border south to the area of western South Carolina and eastern Georgia.
it may not be grounded. correctly. did you check it before you put it on? check with volt meter see if it is getting power. also it maybe that the rod to the wipers are jammed check them out.
What is the P430 error code on a 2003 Toyota Highlander?
That code means that the oxygen sensor downstream of the catalytic converter on bank 2 is detecting that the converter is not working as efficiently as it should be. It could be a bad oxygen sensor, a bad catalytic converter or and exhaust leak.
I'm guessing that you mean a Serpentine belt. This is the multi grooved belt that runs the power steering, alternator, waterpump, a/c & other items under the hood. It's called a Serpentine belt because it snakes back & forth around pulleys to run a lot of different items under the hood. It replaced some cars having 2-3 separate belts under the hood.
What is the tire size for a 2007 Toyota Highlander?
The proper tire sizes for a 2007 Toyota Highlander are P225/70R16 101S or P225/65R17 101S. Check your rim size to validate whether you have 16" or 17" rims. Also, check the size of tire on your current vehicle by finding the tire size on the sidewall.
How do you determine trailer hitch height?
First, set the trailer you're towing on level ground...if you have a jack stand w/wheel combination that'd be great! Level the trailer by either using a small level on a central part of the trailer and make adjustments to the level by winding your jack up/down. (It ain't rocket science, so you could eyeball it by standing a good distance from the side.) Measure the distance from the ground to the top of the "ball mount" on the trailer. The Highlander, is essentially a Camry with a SUV body, so your weight/towing limits are modest, compared to a truck for instance. So, what I'm getting at, is the chances are your trailer is under 150# hitch weight...The Highlander shouldn't "squat" too badly when you put the trailer on.
Determine where your hitch is located...(I doubt Highlanders have bumper-mounting capabilities, so I'll take a guess and say you have a Class I - perhaps Class II). Measure the distance from the top of the inside of the "receiver" section (where the hitch goes) to the ground. Subtract trailer height from your Highlander measure. That should give you a ballpark measure of between 2-5".
Determine your ball size (it's stamped on the tongue of the trailer). Next, GO SHOPPING!
I recommend "Wally World", they're more apt to give you money back on mistakes! Buy the measured "drop", if any. Obtain a locking pin or hitch pin and cotter key that fits the hole in the receiver shaft and grab the right size ball as well...Make sure your receiver size is correct! (You'll need a LARGE crescent wrench to mount the ball.) Place the hitch into the receiver and mount the ball and make sure the washers are put on the bolt out of the bottom of the ball in the same order as packaged. Using the receiver as your vise tighten the nut below the ball, hand tight...There's absolutely NO NEED TO BREAK THE WRENCH TIGHTENING THE NUT. If you have any more questions write again.
P.S. practice mounting/dismounting the trailer and it's operation in a large open parking lot...If you have someone to help spot the hitch as you back up to the trailer it helps alot.
On the tow vehicle, 18" to 20" from the ground to the top of the ball usually puts you in the ball park.
What is the maximum cargo capacity of the 2012 Toyota Highlander?
The maximum cargo capacity of the 2012 Toyota Highlander is 95.4 cu.ft..
How do you remove the 2004 highlander center console?
REMOVING CENTER CONSOLE FROM HIGHLANDER
1) Remove the two arm-rests from the front seats. (Snap off the bolt covers, and remove the 14mm bolts. Be careful not to drop the washers/spacers when you pull off the arm rests.)
2) Slide out the ash tray.
3) Using your fingers, or a padded pry bar, remove the trim panel from around the gear shifter. You'll have to put the car in gear to get it off. Disconnect the connectors from the cig plug and the air bag indicator.
4) In the storage bin, lift up the small carpet bottom and remove the two 10mm bolts.
5) Under the dash, use a flat head screwdriver and your fingers to remove the two extended plastic covers. (On the driver's side, it's the piece immediately beside the accel. pedal. On the passenger side, it's similar.)
6) On the floor, approximately halfway down the console, snap off the button screw cover (one on each side) and remove the Phillips screws.
7) Around the gear shift area (where you removed the trim), remove the three Phillips screws.
8) Lift the console up and to the rear. After moving it about 4 inches, disconnect the connector going to the ash tray lamp.
How do you find out if a 2004 Toyota Highlander has a chipped key?
Does the 2005 highlander V6 have a timing chain or belt?
The 3.3 litre V6 engine in a 2005 Toyota Highlander has a timing BELT
What is the maximum towing capacity of the 2002 Toyota Highlander?
The maximum tosing capacity of the 2002 Toyota Highlander is 3000 lbs..
