0
Car Shaking Problems
Car shaking problems are usually the results of mechanical problems. Out of adjustment tires or suspension will make the car shake after reaching a certain speed. Warped brake rotors will also make the car shake when it’s slowing down.
2,252 Questions
What would cause vibration in the front on a Volvo S40 when accelerating between 40-50 mph?
Check the bearings in the CV joint. They can be rebuilt as the original parts are very expensive. This is a very common problem in the S40 model.
Check tyres (all) for bulges,tread separation and for egg shape.failing that have your wheels balanced at a garage or tyre specialists. if you are sure that the front end of your vehicle is sound and in good repair tires wheel bearings ty-rods etc., the check to see if you have any slop or movement in your carrier bearing, or u-joints. some movement is normal if you shake your drive shaft from noon to six but you should have no movement if you shake it from three to nine. hope this helps.
What causes Steering wobble on series 1 landrover discovery?
Its usually the Front Wheel Balance, but Being a Bushed Axle, Make sure all the bushes are good and there is no play in them. A set of worn Panhard Rod bushes Will not help, as will a Tired Old Steering Damper. I had the exact same problem. Severe wobble when I reached a particular speed (80kmph) I drove home and examined the undercarriage and discovered that clay/mud was stuck to the inside of both front and back left side wheels. (I had been driving off-road that day) I scraped all the mud out with my hands and tested the vehicle again. No more wobble!
the tires could be out of balence bent rim bad tire
What would cause your 1995 subaru legacy to jerk and shake when you turn to the right or left?
could be something with the steering or with the power steering pump.
Sorry to tell you but you have a blown head gasket, cracked head, or both. The white smoke is coolant entering the combustion chamber. STOP driving this vehicle or you will destroy the engine. You must have this repaired and it is not cheap.
Can you wheel tilt inwards because of bad ball bearings?
Yes. If the wheel is off the ground a little movement is normal. If the car is on the ground, don't drive the car until it's fixed
Why does your car shake when ac is turned on?
The engine management system may not be adjusting for the extra load of the A/C. Can also be the A/C compressor is seizing up. Have this looked at by a professional.
Only if it has a posi traction or limited slip differential.
Why are your brakes squealing after your brake pads and rotors were replaced?
The pads are vibrating against the caliber. Remove the pads and apply some anti-squeal to the back of the pads where they make contact with the caliber. Also make sure the slide pins are clean and free of rust.
You have to be more specific. Is the vehicle a 5 spd or auto? Does it only happen on first gear? Are all you motor mounts and tranmission mounts good. write back and I'll be able to get into more specifics.
Why Car engine shake when AC is on at idle?
The engine idle may be set to low to compensate for the AC compressor starting up. Rev the engine a few times to see if it stops. If it doesn't, there may be a problem with the AC temperature signal or motor mount.
First, change the fuel filter. if tha t doesn't work take it to the tire shop and have the tires checked for being round and in balanced. If they are ok have a tune up done.
it cant do that because no one can stop a vibration only the earth could
What would cause a PVC valve on a 1992 ford f150 pickup to keep going bad?
make sure your air cleaner is clean,also check for fouled spark plugs
Why does my car shake and rattle when i apply the brakes at high speed?
Could be many things, but your rotors are probably warped, or cracked, or about to go. Not something you want to let slide, especially if you have kids in the car. Just picture them all the sudden not working at all, or locking up unexpectedly... what are you gonna do??
Why does the steering wheel shake when i go 50 mph or higher?
More than likely you have a tire out of balance. It is possible you have a bent wheel. Have your tires balanced, inspected, and rotated.
Why is my car shaking on start up?
This doesn't happen every time, but every id say 1/30 start ups my 1999 Chrysler 300m starts shaking horribly after I start it and stay in idle. There is no rattling but it shakes pretty bad. When you hear the car try to start, you hear 2- 3 "vroooms" as it tries to start, then it just dies. It It usually does the same thing for the next 5 attempts but once I shift it into R or D its fine and back to normal. I looked up online for a few answers and some people say it's electrical problem. Any ideas of the source?
This probably means 1.3mm which would be about 0.051 inches.
Changing rear light bulbs on a Toyota MR2 mk2?
Hi there, I had the same problem trying to replace a bulb but struggled. You need a screwdriver to place between the yellow inddicator & bonnet. The yellow indicator should just snap out of position, then you'll see the screws.
If your car vibrates when you are braking, you might have pads that have worn unevenly. You can have the brake pads inspected to see if there is wearing on the drum or if you have a problem with your rotors.
What does code PO 326 mean on a 1996 Saturn SL2?
Trouble code P0326 means:Knock sensor no.1 circuit,range or performance problem (bank 1 or single sensor)
If you grab it in the 12 and 6 o'clock positions, you are typically checking for play in wheel bearings and ball joints. If you grab it in the 9 and 3 o'clock positions you are typically checking for tie rod ends or wheel bearings. But you are not totally limited to these although the most common.
