0
Chevy Avalanche
Chevy Avalanche is a sport utility truck produced by General Motors that has five or six seating capacity. It is distinguished by its removable rear window and back seat open bed which can be opened via a folding panel.
1,380 Questions
How much horsepower does a stock 2002 Chevy Camaro 3.8L V6 have?
200
The 3.8 in my 1996 put out 200 from the factory. This is the same 3.8 you have. It also puts out 197 lb/ft torque.
i have a stock V6 '02 camaro and it was dyno'd at 224 hp w/ 205 lbs of torque n@ 5500 rpm.
They have 231 horsepower off the showroom floor i know a person that works for GM with camaro's but it also depends on the condition of the engine, how new it is or how many miles it has on it. Power decreases over time.
Its 200hp.
The 231 is the size of the 3.8L engine in cubic inches.
Now 200hp is of course an average, and most cars will be close, but you may get one with a little more or less, although automakers will usually aim low on HP ratings to aviod embarassment, as Ford had over Cobras a few years ago and had to compensate by recalling them to give a larger gear ratio.
How do you repair your driver's side door on your 98 astro van?
depends what the problem is, more information would be helpful
How much does a 350 engine cost?
depends on which 350
a regular carburated 350 new would be like 3000
a regular fuel injected would be about the same.
the the lt1 and ls1 would be about 4-5000
How much horsepower does a 1998 interceptor have?
175-hp, 4.6-liter V-8 (natural gas)
200-hp, 4.6-liter V-8
215-hp, 4.6-liter V-8 `p71 and sport version`but not all
What is horsepower of a 1990 ford Bronco 5.8L?
first of all it is highly unlikly that its a 5.8 liter v8 or 360 unless you put it in their yourself. but it all depends on all you have done to the motor and also how many miles and how much stress you have put on the motor. but probably a 1990 model 5.8 liter has aproximently 250-325 if it is still stock.
first of all it is highly unlikly that its a 5.8 liter v8 or 360 unless you put it in their yourself. but it all depends on all you have done to the motor and also how many miles and how much stress you have put on the motor. but probably a 1990 model 5.8 liter has aproximently 250-325 if it is still stock.
The 1990-96 Bronco came with a 210HP 5.8L (351cid) engine mated up with a 3-speed automatic only. Automakers always downplayed their Horsepower numbers, for insurance reasons, so you can add another 10% to it for a total of 231HP
Suggested motor oil for 2004 Chevy Avalanche?
i run valvoline 5w-30 in my 5.3 liter. owners manual will give recomendations.
How do you replace the serpentine belt on a 2001 Suzuki Vitara 4cyl?
Hello,
I found this question while searching for an answer to the very same problem after the belt broke. To replace it is really easy (once you discover how to do it!). Once you open the hood and face the engine, you will see to wheels without grooves. The one on your left is the one that tense the belt. To loosen the belt, just place a wrench at the 12 position and turn it clockwise to, say about 3 o'clock. That will move the wheel down and will release the pressure on the belt. To put a new one, just do the same. Please note that to remove the old belt (if it is not broken) or to place the new one IT IS NOT necessary to remove the small belt that you see attached to the radiator fan, just go with the new belt around and below the fan (between the fan and the radiator).
Have fun!!!
Jose
It all depends on the setup though. REMOVAL
- Disconnect negative (-) cable at battery.
- Loosen adjusting bolt (1) and pivot bolt (2).
- Slacken belt by displacing fan pulley.
- Remove cooling fan. Just detach the fan/clutch from fan pulley.
- Remove cooling fan belt (3).
INSTALLATION
- Install belt to fan pulley and crankshaft pulley.
- Install cooling fan.
- Adjust belt tension as specified.
- Tighten adjusting bolt and pivot bolt.
- Connect negative (-) cable at battery.
Log Out | Help
UNIVERSAL TECHNICAL INSTITUTESelect Vehicle | New TSBs | Technician's ReferenceComponent Search:Conversion Calculator 2001 Suzuki Truck Vitara JLS (2Dr) 2WD L4-2.0LVehicle Level Engine, Cooling and Exhaust Engine Drive Belt Service and Repair AlternatorAlternatorGenerator BeltREMOVAL
WARNING: Disconnect negative (-) cable at battery before removing and installing generator belt.
- Loosen tensioner by turning the tensioner pulley (2) clockwise.
- While holding the tensioner and belt loose, remove generator belt (1).
INSTALLATION
- Loosen tensioner by turning the tensioner pulley (2) clockwise.
- While holding the tensioner, install generator belt (1). NOTE:
- Make sure that the belt fits each pulley's groove properly.
- After installing generator belt, perform checks described above and make sure that tension indicator is within standard range.
That all!
© 2010 ALLDATA LLC. All rights reserved.Terms of Use
Where is the abs control module in the Chevy Avalanche?
On the drivers side frame, directly under the driver's side seat on the frame rail,control module and abs pump.
How much horsepower does a 99 Volkswagen jetta have with a 2.0?
115-122 HP
www.canadiandriver.com/articles/jc/99-01jetta.htm
How do you change the knock sensor on a 2003 Chevy Avalanche?
That engine has 2 of them and you MUST remove the intake manifold to service the knock sensors.
How do you connect a game console to a Chevrolet avalanche?
i use 12 volt adapters. you can find them any auto store or electronic store. most plug in to the cig. lighter. I cut the plug and wire them (fused) to my primary accesory wire.
How do you repair power window on 98 olds intrigue?
To repair the power window on the 1998 Old Intrigue, you will first need to remove the interior door panel to access the window motor, switch, and actuator. You can then determine which part is broken or damaged and replace that part.
LTZ is the trim or range level of the truck my dad has a Chevy silverado 3500 dually and on the side it says ltz that the best since the Chevy ss but those havent been made since 2006
How do you change the Cabin Air Filter on a 2002 vw golf?
Open the engine hood.
The cabin filter is located underneath the weather stripping on the passenger side.
Unscrew four screws and pull out the filter frame.
How do you replace running light bulb on 2007 Chevrolet pickup?
This procedure is probably the same as for a 2007 GMC Sierra, which has been answered here by someone already.
Check to see if it has come unplugged. There is also the possibility that the connector got damaged, and there is a tear in the copper foil. If so, some parts stores carry a repair kit that may fix the problem. About $9.00
