Why wont your starter disengage even with the key off?
Your cars starter motor is wired directly to your cars battery. A relay,operated by the keyed ignition switch closes this curcuit thus engaging the started motor. If the relay fails in the closed position, the starter motor will remain powered until the battery runs flat or the starter motor burns out.
Hope that answers the question
Your cars starter motor is wired directly to your cars battery. A relay,operated by the keyed ignition switch closes this curcuit thus engaging the started motor. If the relay fails in the closed position, the starter motor will remain powered until the battery runs flat or the starter motor burns out.
Hope that answers the question
Options on a 1972 Chevrolet cheyanne super truck?
There were several options available on the 1972 Chevrolet Cheyenne super truck. There were several different options involving the size of the engine. There were several options available as to the transmission.
Are the headrests on your 1988 Volvo 245 removable?
If you will carefully press in on the backside of the material of the front seat back following a straight line downward from the headrest post you will come to a tab at the end of the post. Raise the headrest to the upmost position, press with your thumb on the material and against the tab while putting just a small amount of upward pressure on the headrest and the tab will release the post. You have to do this to both posts of the headrests to remove them from the front seats. I have an 89 240 and the headrests do come off, as do all 240 wagons.
Can you swap an engine with an automatic transmission with one that is manual?
Sure you can you just need the correct flywheel to replace the flexplate that is on the old one, the engine is manufactured to accept either transmission. But if you are thinking of making the change to the vehicle as well there are many other things to do as well such as clutch pedal and linkage, center console change, possible driveshaft change that make the job much less attractive.
What do you do if your transmission dip stick on a 1997 Chevy pickup is stuck and won't come out?
Try twisting or turning it. If it is frozen because of the cold, get a rag with hot water and hold it over the top of the dipstick. If it is not frozen, then that is not a good indication.
Is there a O2 sensor on a 1988 Chevy Cheyenne 4.3 v6?
Yes, of course! It is in the vacinity above the oil filter side of the motor, and near one of the spark plugs........ you can see it connected with only one wire as you are looking down at a front driver side view under the hood, it's very obvious.
Spark plug gap for 1976 Chevy Cheyenne pick up?
good rule of thumb on spark plugs. .035. If it's too small, it will still fire. If it too wide, it won't.
Where is the crank sensor on a 1998 Chevy 1500 truck with a 5.0L engine 4X4?
bottom of timing chain cover one 8 mm holds it in good luck
How can I verify a check to see if its bad or not?
Individuals and Consumers:
For consumers or individuals, it is much more difficult to verify a single check because banks are being increasingly more concerned with privacy issues.
A service is available to look up single checks by the routing number if you have a land line phone and are willing to pay the $5 for the phone call. The number, to verify a check as of February 23, 2011 is 1-900-868-2995, and you can verify two checks at a time.
If it is a cashier's check, you can contact the bank it was issued by and tell them that you need to know if a check is good. With the account information and check number, they can tell you if it is an account that is in good standing and if it has the funds to cover the amount listed on the check.
Business Options:
For business, services like Telecheck, BetterCheck, Certegy, CheckSystems and others can provide accurate and instant verification for most checks.
Systems like Telecheck use the check writer's history and identification to gauge the likelihood that the check will be good, where networks like BetterCheck will give the account status as of that day.
Guaranteed Verification:
Of course, the only sure way to verify a check, is to take it to the bank that issued the check and ask them to make sure the funds are available.
If you take it to the issuing bank, you can get cash for the item on the spot. This is much safer than depositing the item into your own account.
If you deposit the item into your own account, you will be 100% responsible if it is returned for any reason. The depositor is responsible for the full face value of the check, plus fees and you could open yourself up to prosecution for depositing a false document in some cases.
When you take it to the bank that issued the check, you can walk away with real cash for the item and there is no recourse for the bank unless you know the item is a fake.
Getting Around the System - Back Door Verification:
There is yet one more way to verify a check on an account and that is to have the account holder on the phone with you, call the bank and have the teller verify the account holder and listen to the verification while it is going on.
If you have a check and the account holder's social security number or tax ID, you may be able to log into via the bank's telephone banking system and verify the item yourself.
What are the symptoms of a faulty ignition switch on 1997 s10 blazer?
when you turn on the key and get no dash lights example check engine or seatbelts. vehicle will still turn over but not fire up. but the dash lights are the key if they come on when you turn the switch and you hear the fuel pump pressure up then the switch is fine. would need to know more of the problem to be sure but this is a good start.
What causes oil to come out of a dipstick hole?
pressure in the sump caused by engine breather pipe being restricted or blocked is one cause for oil coming up through the dipstick hole
Where is the fuel filter located on a 1998 Chevy Cheyenne 305 v8?
Good chance its located in the fuel tank.
How do you release emergency brake?
how do i release the emergency brake on a 1963 ford thunder bird?
Where do you locate the check engine light sensor for 1997 Cheyenne 1500 truck?
There is not one sensor. All the ECM sensors are tied to the check engine light.
How do you repair the passenger side door handle on a 1997 Chevy Cheyenne pickup?
You must replace the handle, they are made of plastic. For the inner- remove both screws in the door panel[in the grab handle] remove the trim from the door handle. Remove window crank and with proper tool remove door panel. Tool is cheap. With panel off, there will be one rivet holding old door handle in place. Drill out rivet [ 3/16 ] and slide whole door handle assembly forward. Carefully remove door and lock rods and reverse the process to assemble. Outer- One bolt is behind door panel and the other is on the outside edge of the door right behind the handle. Simply remove bolts, remove handle and swap door lock into new handle and replace.
if you have throtle body injection the regulator should be right on the throttle body it self.On a 1996 Chevy truck there is not a throttle body , the regulator is under the upper plenum(the plastic piece that sits on the intake)also the injectors are under there as well all 8 or 6 witch ever motor you have.
Can you adjust a hydraulic clutch for a 88 1500 Chevy pick up?
No you can not, There's no adjustment.
Where is the oil pressure sending unit located on a 89 Chevy 350?
At the back of the block, near the distributor.
Where do vacuum lines go on a chevy small block?
You usually need a constant source from the intake manifold to the power brake booster, and a spark-ported source from the carb to the distributor. There could be other emission-related lines as well, depending on the year.
What year is a chevy engine with casting number 10066036?
The Chevy engine with that casting number was made in 1993.