0
Chevy G20
Manufactured by the American automaker General Motors Company for the G-Series product line, the Chevy G20 was a passenger van powered by a 4.3 liter V6 engine, which can generate up to 165 horsepower.
1,037 Questions
How do you change a serpentine belt on a 1992 Chevrolet G20 van?
This is an easy one. There is a belt tensioner on the top of the engine which applies tension to the serpentine belt. A small wheel rides above the belt and applies the tension. Put a ratchet and socket on the bolt found in the center of the small wheel. The wheel and arm it is attached to will move up as you apply pressure to the ratchet. It is only necessary to move the small wheel and arm a short distance in order to slip the serpentine belt from under it.
The trick will be replacing the belt. If the label showing the routing of the serpentine belt is missing (usually on the air intake pipe) draw a diagram before removing the belt.
What is the curb weight of a 1971 VW van?
A 1971 Volkswagen Bus passenger model with the optional radio and sliding steel sunroof listed for $3,164 and weighed 2,900 pounds.
Where can you find a 1985 Chevy G20 van owners manual?
You can find a 1985 Chevy G 20 Van owners manual at most Chevrolet dealerships. Many auto-parts stores can order you an owners manual.
How hard is it to change a water pump on a G 20 Chevy van?
On a scale of 1 to 10, about a 8 or a 9 for DIY. Lots and lots of stuff to remove.
How do you take the steering wheel off of a 1988 Chevy?
You're going to need a couple special tools...a steering wheel remover, and lock plate remover, and probably a pair of snap ring pliers. Good Luck!!
1985 Chevy G20 van starter clicks but doesn't start?
Proper battery connections could be at fault, how old is your battery? Check for loose and corroded terminals on your battery and starter connections. Also the starter might just be bad.
Replace the sending unit it should be located in the gas tank. Good Luck and Remember.
Change Your Mind, Not Your Oil.
Use the First In Synthetic Motor Oil's.
See My Bio For more information.
Most Likely Your Blower Motor Is Going Bad.
How do you set the timing on a 11HP BriggsStratten lawn mower motor?
Replace the keyway under the flywheel, change the camshaft timing.
How do you change the brake light switch on a 1995 Chevy G20?
your in luck i just had to do this on my 95 lol
you will have to carefully lower your steering column, and above it there is the brake light switch conected to the brake pedal and a rod going towards the front of the vehicle where the master cylindar is at. on the little piece sticking out to the right of the brake light switch there is a pin that keeps it in place. remove that pin and then remove the wires connected to the switch. should come right off and then just put the new brake light switch on and reverse the steps.
hope this helps
Where is the computer in a 97 astro van?
the (ecu,ecm,pcm) or computer is under the hood, next to the battery, just under the fuse box on the 97 model year.
Does the ECM on a 98 Chevy 4.3 motor need to be flash programed?
yes they call it reflashing of the pcm/ecm.on older gm's,you could just swap the chips out or have them reprogrammed.most likely a dealer thing.
How do you change a bottom control arm on a Chevrolet g20 van?
you will have to get it to a shop as they will have to compress the coil spring to take the pressure of it, then it is just a matter of one nut holding the wheel and two holding it at the bracket on the frame.
Why does your Chevy G20 van's control panel for the back dome lights and tv-vcr cut out sometimes?
Since those items get their power from the auxiliary fuse block, below the main, I would suspect one of the plug-in power relays! Also, check the fuses that go into the auxiliary fuse block. It is possible it is as simple as a blown fuse. It happens in mine from time to time. My auxiliary fuse block is beside the drivers side captains chair behind the driver. Yours may be different.
What is the gas tank capacity of a Chevrolet G20?
== == Mine is 33 gallons but i believe that was an option, normal is 22 gallons. Mark.
Where is the rear blower on a 1995 G20 Chevy conversion van?
The rear condenser and blower moter are located, behind the right rear wheel area, inside the van. Look for return air vent. They are installed behind the vent housing.
If it is a conversion van then it may be air in the lines.
My G20 Conversion van had a problem with the heat. The AC worked great. I was told there was air in the radiator lines. This was difficult for me to believe however I jacked the front end of the van up and removed the radiator cap and then ran the van for about 20 min as per the online instructions. Of course nothing happened and I felt a little silly for trying.
A few weeks later I had to travel up highway 99 in California, remembering the trouble shooting ideas, despite the objections of the family I shut off the AC and ran the heater on high (no heat coming through the vents) About 5 to 6 minutes of traveling up hill, bouncing up and down on California's horrible roads at 70 miles an hour, low and behold the heat started poring out the vents, and has worked great ever since.
Where is the roll over switch on a 1997 Chevrolet 1500 van?
Chevy did not use a INERTIA switch on there trucks are vans.
Timing for a 1998 Chevy 5.7 motor?
4 to 6 degrees advanced, or BTDC.
NEW ANSWER: You cannot use a timing light on that year engine, It requires an engine scanner to set the timing. The timing is computer controlled. The scanner will allow your to set the crankshaft and cam shaft correlation and then the computer will take it from there.
The above answer is correct for the early modal 5.7L 350.
What is the 43 check engine code on a 87 camaro iroc?
code 43 is electronic spark control open circuit.
It very well could be the EGR valve. I'll tell you how you can check it. Under the dash on the drivers side is a diagnostic plug. Jumper between the diagnostic terminal and ground terminal, then turn the ignition to ON. Do not start the truck. Only turn it to ON. The check engine light will flash a code. One flash then two flashes. It will do this three times. (12 is the code for diagnostics mode) If there is a fault it will then flash another code three times. If it flashes 3 times then 2 times, that means code 32. Code 32 means the EGR system is malfunctioning. If you purchase the Haynes manual at Advance Auto or Advance or any auto parts store it will have this same info. You can get other codes from that manual also. Hope this helps! J.
Where is the location of Number 1 one on distributor cap in 1990 G20 Van 5.7 liter engine?
Locate No 1 cylinder of your engine. it is usually on the passenger side of the engine V8 block front. it is also identified as the most forward portion of the left cylinder bank remove sparkplug cylinder no 1 on the balancer turn Engine (manually) until piston of clyinder no 1 is in top dead center (TDC) the balancer ( extention of the crankshaft forward, towards the radiador)should have a mark to show that TDC Note: in a 4-cycle engine the piston reaches 2 (two) times TDC so make sure it is the TDC where the sparkplug fires. ( That is indicated on the balancer mark) Remove distributer cap, the rotor now points direct to terminal No 1 of your cylinder no 1. This pocedure is fail safe, in case you dont know if someone had the distibuter removed from the engine for whatever reason.
