0
Dodge Caravan
The Caravan is a minivan produced by Chrysler Group LLC for its Dodge brand. Since its introduction to the market in 1987, this long wheelbase (LWB) vehicle was manufactured in five generation models.
4,933 Questions
How do you replace a CV axle on a 1992 dodge caravan?
For a job like this you should have a basic Haynes or Chilton book for your van.
A normal driveway mechanic should be able to do this in about 4 hours.
Set park brake. Be SAFE!!!!!!
Loosten lug nuts 1 turn on wheel to be removed.
Use breaker bar and remove axle nut.
Jack up car & support with 2 jackstands.
Remove wheel.
Remove brake caliper assy.
Use tool to remove lower ball joint mount.
Remove both sides of the sway bar retainer cap and rotate sway bar down.
Now you can swing hub assy away from end of shaft.
Remove old shaft.
Carefully support ends and slide in new shaft.
Install is reverse.
GL
Dean.
The battery light indicates that the battery is not receiving a charging current. You may have a bad alternator or a broken drive belt (if you have a broken belt you'll have overheating and power steering problems too, though).
What is the little red dot on dash of a 2003 dodge caravan and how do i turn it off.?
It is a security light. The dealer should be able to update the cluster so it will shut off.
How do you remove upper oxygen sensor 2001 dodge caravan?
You need a special socket that has a cut out so you can slide it over the sensor. The socket can be bought or borrowed from the auto parts store. I believe I borrowed mine from Advance auto. They make you pay for it and return your money when you bring the socket back in one piece. However, yours is a bit rusted by now as was mine last year. Some heat goes along way here. Now your going to need a really long extension to go at it from the top. I can't remember if I needed a swivel or not.
Hope this helps.
Where can one find the obd 2 connection on a 2006 Dodge Caravan?
The 2006 Dodge Caravan OBD 2 port is under driver side dash lower left instrument panel
If i change my spark plugs will my water stop get in my cylinder on my 03 dodge grand caravan?
No spark plugs have nothing to do with water in your cylinders. I would guess a bad head gasket, worped head or cracked in the water jacket might be a closer bet.
Hope this helps.
This is when the engine coolant ( which may include anti-freeze, anti-corrosion, anti-boil and other fluids ) is drained from the radiator, hoses, pump, engine block etc and the system is flushed clean with water (which may contain degreasers, cleansers, etc. ). After that, the fresh coolant with the new additives are put into the system.
The usual reason for doing this is to clear blockages from the small radiator tubes and the sludge and dirt that may have been deposited in the slower circulating areas of the engine.
Worn, loose, or broken suspension parts. Have the suspension inspected by a professional. This can be a very dangerous situation, and I suggest you attend to this ASAP.
Where is the erg valve on a B2300 and how difficult is it to replace?
On a 2001 b2300 it is located above the transmission and you have to take part of the transmission out to get to it. It cost me 538.00 at the Mazda dealer!!!!!!!!!!!!!!!
What is the difference visually between a 3.3 and a 3.8 ltr dodge motor?
The only visible difference is whether the intake has 3.3 or 3.8 o n it.
On a 4.3L vortec v6 do you set the timing marks on the 1 or second mark on the dampner puley?
2nd to the v mark
How do you change rear wiper blade 2010 caravan?
It will depend on if your rear wiper looks like a traditional wiper blade or if it looks like a newer, fancier wiper blade. If traditional looking then watch "hook arm" video. If a newer-style wiper blade then watch "xx-E video".
Obviously a fault [short or ground] in the wiring circuit(s) to these devices.
If they are on the same circuit, a single fault is probably the cause.
If they are on separate circuits, the cause could be either a single fault in a circuit which supplies power to those circuits, or there is a fault on each [unlikely] of them.
The first step is to check for a "blown" fuse. A blown fuse is generally not a "cause" of failure; the cause is whatever caused the fuse to fail.
Most people simply replace blown fuses, but a blown fuse indicates that either a short circuit or an "overload" condition has occured [causing the fuse to fail]. Simply replacing a blown fuse is much like [in medicine] treating a symptom, without treating the disease.
For troubleshooting explanations and suggestions, see answers to a similar question: "What would cause the cigarette lighter to stop working all of a sudden without the fuse being blown on a 1992 Lexus LS400."
You must remove the bolt holding the spark plug clip and wiring just above the water pump housing, and move the wires out of the way as much as possible. The hose is held to the housing by a squeezable clip - need long preferably curved needle nose pliers to squeeze and pull off hose.
If no room, you are gonna have to take off the AC unit so you can get down there.
Why are the low beams not working but high beams work on a 1997 dodge caravan?
Replace the bulb. The low beams and high beams use separate parts inside the bulb.
If replacing the bulb does not fix the problem, check the fuses.
I looked at my remote filter on my 93 S10 Blazer and it is bolted to the inner fender which shouldn't need to be removed to remove the fender.
on the 3.8,s it is right behind the alternator but you have to look way down underneth ( so between the alternator and the firewall but down under)
you will see the cap to fill it and you probally will need a long funnel
Where is the fuse to the cigerette lighter on 2005 dodge grand caravan?
The fuse for the cigarette lighter on a 2005 Dodge Grand Caravan is located inside the van. The fuse box will be on the drivers side.
If your problem is squeaking from the front of the car this is coming from the front suspension and proberbly the transverse arms. This is the first stage of the problem and is repairable without any major costs. The problem occurs when the MOS2 Molybdendisulfid grease in the balljoints start to dry out. This is repaird by removing the 4 tranverse arms and the C-link on both sides of the car and overhauling the gaiter covered balljoints. Carefulle remove all grease in baljoint and in gaiter and generously replace with new. Be careful when removing and mounting retaining springs. I have done this on my Passat 98 1.8T and it really works. My problem ocurred after 75000 km. This overhaul can NOT be done according to VW. The nest stage with this problem is instead a crunching noise from the same mechanics and it is a costly problem because one or more ball joints are damaged and worn out beyond repair. Now one ore more transverse arms or complete kit has to be replaced. Cost, ~$1000 for kit only. Can also be found on the internet in Germany for ~Euro 350. Regards Bo L
What does a tune up for a 1996 Dodge Caravan consist of?
A tune up consists of checking/refilling all fluids, checking the battery and cleaning corrosion if present, replacing the spark plugs and checking/replacing the wires, check and/or adjusting the drivebelt and replacing if necessary, checking and/or replacing the air filter, checking and/or replacing the PCV valve. (Check it by first removing it and shaking it; if it rattles really loud, it's fine..If it doesn't rattle, replace it.) Also check the hoses for damage, and sometimes it is necessary to replace the fuel filter during a tune-up.
