0
Dodge Caravan
The Caravan is a minivan produced by Chrysler Group LLC for its Dodge brand. Since its introduction to the market in 1987, this long wheelbase (LWB) vehicle was manufactured in five generation models.
4,933 Questions
If i change my spark plugs will my water stop get in my cylinder on my 03 dodge grand caravan?
No spark plugs have nothing to do with water in your cylinders. I would guess a bad head gasket, worped head or cracked in the water jacket might be a closer bet.
Hope this helps.
This is when the engine coolant ( which may include anti-freeze, anti-corrosion, anti-boil and other fluids ) is drained from the radiator, hoses, pump, engine block etc and the system is flushed clean with water (which may contain degreasers, cleansers, etc. ). After that, the fresh coolant with the new additives are put into the system.
The usual reason for doing this is to clear blockages from the small radiator tubes and the sludge and dirt that may have been deposited in the slower circulating areas of the engine.
Worn, loose, or broken suspension parts. Have the suspension inspected by a professional. This can be a very dangerous situation, and I suggest you attend to this ASAP.
Where is the erg valve on a B2300 and how difficult is it to replace?
On a 2001 b2300 it is located above the transmission and you have to take part of the transmission out to get to it. It cost me 538.00 at the Mazda dealer!!!!!!!!!!!!!!!
What is the difference visually between a 3.3 and a 3.8 ltr dodge motor?
The only visible difference is whether the intake has 3.3 or 3.8 o n it.
On a 4.3L vortec v6 do you set the timing marks on the 1 or second mark on the dampner puley?
2nd to the v mark
How do you change rear wiper blade 2010 caravan?
It will depend on if your rear wiper looks like a traditional wiper blade or if it looks like a newer, fancier wiper blade. If traditional looking then watch "hook arm" video. If a newer-style wiper blade then watch "xx-E video".
Obviously a fault [short or ground] in the wiring circuit(s) to these devices.
If they are on the same circuit, a single fault is probably the cause.
If they are on separate circuits, the cause could be either a single fault in a circuit which supplies power to those circuits, or there is a fault on each [unlikely] of them.
The first step is to check for a "blown" fuse. A blown fuse is generally not a "cause" of failure; the cause is whatever caused the fuse to fail.
Most people simply replace blown fuses, but a blown fuse indicates that either a short circuit or an "overload" condition has occured [causing the fuse to fail]. Simply replacing a blown fuse is much like [in medicine] treating a symptom, without treating the disease.
For troubleshooting explanations and suggestions, see answers to a similar question: "What would cause the cigarette lighter to stop working all of a sudden without the fuse being blown on a 1992 Lexus LS400."
You must remove the bolt holding the spark plug clip and wiring just above the water pump housing, and move the wires out of the way as much as possible. The hose is held to the housing by a squeezable clip - need long preferably curved needle nose pliers to squeeze and pull off hose.
If no room, you are gonna have to take off the AC unit so you can get down there.
Why are the low beams not working but high beams work on a 1997 dodge caravan?
Replace the bulb. The low beams and high beams use separate parts inside the bulb.
If replacing the bulb does not fix the problem, check the fuses.
I looked at my remote filter on my 93 S10 Blazer and it is bolted to the inner fender which shouldn't need to be removed to remove the fender.
on the 3.8,s it is right behind the alternator but you have to look way down underneth ( so between the alternator and the firewall but down under)
you will see the cap to fill it and you probally will need a long funnel
Where is the fuse to the cigerette lighter on 2005 dodge grand caravan?
The fuse for the cigarette lighter on a 2005 Dodge Grand Caravan is located inside the van. The fuse box will be on the drivers side.
If your problem is squeaking from the front of the car this is coming from the front suspension and proberbly the transverse arms. This is the first stage of the problem and is repairable without any major costs. The problem occurs when the MOS2 Molybdendisulfid grease in the balljoints start to dry out. This is repaird by removing the 4 tranverse arms and the C-link on both sides of the car and overhauling the gaiter covered balljoints. Carefulle remove all grease in baljoint and in gaiter and generously replace with new. Be careful when removing and mounting retaining springs. I have done this on my Passat 98 1.8T and it really works. My problem ocurred after 75000 km. This overhaul can NOT be done according to VW. The nest stage with this problem is instead a crunching noise from the same mechanics and it is a costly problem because one or more ball joints are damaged and worn out beyond repair. Now one ore more transverse arms or complete kit has to be replaced. Cost, ~$1000 for kit only. Can also be found on the internet in Germany for ~Euro 350. Regards Bo L
What does a tune up for a 1996 Dodge Caravan consist of?
A tune up consists of checking/refilling all fluids, checking the battery and cleaning corrosion if present, replacing the spark plugs and checking/replacing the wires, check and/or adjusting the drivebelt and replacing if necessary, checking and/or replacing the air filter, checking and/or replacing the PCV valve. (Check it by first removing it and shaking it; if it rattles really loud, it's fine..If it doesn't rattle, replace it.) Also check the hoses for damage, and sometimes it is necessary to replace the fuel filter during a tune-up.
Who was the blonde pop star that had a caravan in her pop video?
Lily Allen ... the track was The Fear
How do you change a Cabin Filter on a 2002 Dodge Grand Caravan?
If your vehicle is equipped with one, it should be located on the passenger side, underside of the dash near the center console. It should be a black plastic snap-on cover about 1 1/2 inches wide by about 6 inches long, that may or may not be marked "cabin filter" (or something similar). Simply pop it off, pull out the filter (pay attention to its correct orientation, the airflow direction matters), install a new one, if necessary, and reinstall the cover.
You may need to use something to pry the filter out enough to grab, and you will likely need to bend the filter to remove and/or install it.
When you hear a clunking sound from the back every time you go over a bump what causes it?
Plymouth Acclaims are notorious for this. Underneath the car there is an anti-sway bar that runs between the back wheels. Surrounding the bar is a u-shaped channel. Where the bar passes through the channel at each end, there is supposed to be a weld, but it was poorly designed and the welds eventually break, resulting in a horrifying clunk every time you hit a bump and the bar hits the channel. There are two ways to resolve this: Pay the dealer $400 to install a new bar and channel assembly (which will break eventually), or pay your local muffler shop $20 to weld a couple of pieces of scrap metal between the bar and the channel to keep it from moving. Problem solved.
How do you hook up a four cylinder distributor cap?
Without knowing the year and engine size, I cannot answer this question. Chrysler makes more than one 4 cylinder. They have even used Mitsubishi engines in the Caravan.
