0
Dodge Caravan
The Caravan is a minivan produced by Chrysler Group LLC for its Dodge brand. Since its introduction to the market in 1987, this long wheelbase (LWB) vehicle was manufactured in five generation models.
4,933 Questions
Is a 1995 Caravan transmission compatible to a 2000 Caravan?
No, the range sensor/neutral switches are not compatible.
No, the range sensor/neutral switches are not compatible.
Why would the gas gauge on a 1993 dodge caravan stop working and how would you fix it?
it could be the coil pack it could be the coil pack
Can you drive when the rt front axel is grinding?
Not recommended can seize or break cause injury to you and other motorist.Also the more it is driven the more other parts may be damaged.
most likely the lock actuator plastic gears a stripped and slipping go get a new lock actuator
Where is the brake fluid dip stick?
My brake fluid reservoir is clear plastic with a thread on cap , there is no dipstick ,
there is a maximum fill mark on the white plastic reservoir
Sounds like you have a (604) overdrive transmission. If so your transmission is in "limp in mode" that means it is stuck in second gear. a protection device built into the trans when faults occour. You will need to have someone read the codes set in the transmission. I would be happy to tell you what codes are when read On my '91... I added tranny fluid, and the problem was solved. I put a heavy transmission fluid in that's made a slipping transmission. Someone has to look at it so see if that's what it is. If it is you could save getting a new transmission. Sounds like you may have been running it without enough fluid and may have caused some damage.
How do you open a locked 2001 dodge caravan door.?
my car front doon
lock check inside ok but remot working not
open
Where is the fuse for the ac control on a 2001 dodge caravan?
If there is a fuse for it, it should be in the fuse/relay box under the hood next to the battery. Pop the cover off and inside the cover you'll find the fuse and relay list to identify their positions.
What is the most likely cause of blown hazard lights fuse on a 1999 Dodge Caravan?
Blown fuses. Consult your owners' manual for their location.
When do caravans open in skegness?
Caravans in Skegness typically open for the season around March and remain available until the end of October, depending on the specific site and its management policies. Many caravan parks may have varied opening dates, so it's best to check with individual sites for their exact schedules. During peak season, which generally runs from late May to early September, availability may be higher.
How do you replace the headlight bulb located on a 1998 Oldsmobile Aurora?
On the passenger side there is a large black fuse box cover that has to be removed and then you reach thru the small hole to the lamp... might be easier to unplug in place and then twist it.
Driver Side - remove the air filter assembly to reach the lamp.
How do you fix squeaking in the steering column on a 2000 dodge caravan?
The squeaking of a steering column can usually be fixed by adding power steering fluid. It can also be fixed by replacing the belt in the car.
What would cause a grinding noise when you only turn slightly to the left on a 1996 Geo Metro?
If the "grinding noise" is present while cornering left and all but disappears when cornering right, my experience* says it's your right rear wheel bearings needing replaced.
* My '96 did the exact same thing
another thing to check is my exhaust pipe would rub the rear suspension on the passengers side and make an awful noise only when turning left and it would be worse with more weight in the car
Before you make plans to set off with your goods in tow, there are some basic checks to make. You mustn't overload your vehicle or trailer and should look at your trailer and car handbooks to find out what the recommended maximum weight is. Whatever load you are carrying must be securely fastened down and must not be sticking out dangerously. Take care to ensure that there is no chance any animals can break free. The weight in your caravan or trailer must be properly distributed. Heavy items should be loaded mainly over the axle and you need to ensure a downward load on the tow ball. Again, check your handbooks for the recommended maximum weight and tow ball load. This is particularly important to avoid the possibility of swerving, snaking and losing control. If this does happen, ease off the accelerator and reduce your speed gently to regain control.
Auto belt tensioner how to install?
Put tensioner in vise careful not to damage it, squash the pin back inside and align hole, put a paper clip into it...reinstall w/ new belt and remove paper clip ....and tension is on belt and ready for service.
The paper doesn't work need steel pin long enought that you can pull out after belt installation.
Feel free to edit this answer to reflect the actual fuse location if/when you find it.
I'm not 100% certain, but if there is a fuse it should be in the black fuse box, under the hood, next to the battery. Just pop off the cover, the fuse locations should be listed inside the cover and that one would probably read 'PANEL' or 'PNL' illumination, or something like that (you might have to do a little shorthand translation).
Some models, again I'm not 100% sure about 2004, also have a small fuse box located on the driver's side end of the dashboard that might hold that fuse as well. It's only visible and accessible with the driver's door opened.
Why is your '95 Maxima not starting only hear clicks?
If the battery is bad, you may only hear clicks. It could be the starter, but I would check the charge on the battery first.
First, There are several marks on the Crank shaft pulley. It would be possible to re-install the timing belt on the crank shaft pulley when #1 piston is not a TDC. i.e. the crank shaft could have been rotated to another mark when the timing belt was off. The easiest way to check this is to verify that when all your timing marks are aligned, #1 piston is all the way up. Second, when you say that the rotor is not at #1, do you mean it is not at the plug where #1 spark plug wire is attached? If you lift your distributor cap off and look underneath the cap, you will see that the point for #1 is actually not at #1 but about 90 degrees off. The rotor should point somewhere toward the front valve cover when at #1. The only other thing I can think of is that the crank shaft pick up sensor (which plugs into the distributor) was never plugged back in after the water pump was installed.
