0
Dodge Durango
The Dodge Durango was a full size SUV (sport utility vehicle) manufactured by Chrysler for the Dodge brand. Produced in the company’s assembly plant in Newark, Delaware, this 8-passenger vehicle was initially powered by a 5.9 liter Magnum V8 engine.
3,297 Questions
What is the front shoulder room in the 2013 Dodge Durango?
The 2013 Dodge Durango has 58.5 in. of front shoulder room.
Where to you get wiring diagram for 99 Dodge Durango?
Haynes Or Chilton Repair Manuals From Local Auto Parts Store Or Order One From JEGS.com Or Summit Racing.com
Where is the camshaft position sensor located on a 1997 Buick Riviera?
the sensor is located behind the pulley for the water pump has one single 8mm bolt in it u need to remove pulley to get at it
Where is the rear differential located on a 98 Durango?
Between rear wheels. it is the rear axle housing. The diff is usually the round object in center that driveshaft attaches to with gears inside.
What does code no bus mean on a Dodge?
The "bus" is the communication system for the computers on the vehicle. "no bus" means that communication is not happening. It could be a computer, wiring, fuse, ground, etc issue. You will need wiring diagrams, a scan tool, a DVOM, and some electrical knowledge to properly diagnose.
How do you change the license plate bulb in a 2001 Dodge Intrepid?
It is very easy to change the license plate bulb in a 2001 Dodge Intrepid. You will need to remove the tag and then unscrew the light cover. After the cover is off, unscrew the light and replace with a new one.
Is water pump a frequent problem on 2000 Dodge Durango?
I bought my 2000 Dodge Durango SLT 5.2 lt, 318cu in May 2007. When I got it home I noticed a small leak. The car never overheated but I crawled under and saw the leak coming from the water pump. Late November 2008 the water pump failed again. Yesterday January 4th 2009 it failed again so I am searching the internet looking for answers why. Rick K.
So if there are users out there with a similar story please add or if you have found a so;ution to the water pump repeated failure issue
I work on Dodges for a living and have not heard of any thing like that if you are buying quality parts.
What can cause a check engine code for misfire for number 3 and 6 cylinders?
cylinders 3 and 6 are not, "firing properly."90% sure its either those 2 spark pluggs or those 2 spark plug wires.Replace them and if you fixed it the light will go off as long as theres n other codes...(problems).pluggs are cheaper to fix.and u can tell by sight if yheyre good or noyt.Sp Id start there.
How to reset the Tire pressure warning 2004 Dodge Durango?
The tire pressure warning light should go out once all of the tires have the correct pressure. If it does not then one of the sensors in the wheel is probably bad.
It could be your TPS (throttle position sensor). my 2000 durango was doing the same thing and that was the problem..
Where is the Camshaft position sensor located on a 1991 Pontiac Bonneville SE?
I would suggest you go to www.autozone.com and enter your vehicle information under REPAIR INFO, VEHICLE REPAIR GUIDES, then select DRIVEABILITY AND EMISSIONS, then ELECTRONIC ENGINE CONTROLS. Select the control you are looking for and Autozone will tell you exactly where it is located and how to replace it. Hope you find this info helpful.
behind passenger side front wheel , have to take the pulley off..believe its the water pump pulley and the tire well off
How do you replace the air filter on a 1996 Oldsmobile Aurora 4.0?
it is in the right front.Loosen the clamp from the throttle body and there two more right by the box loosen all and remove tube from throttle body to the air box after that you can see the air filter box it has 3 push tabs on it push them in and pull the cap up swap filters and reverse your procedure.There is a sensor on the tube you might have to unhook very easily with a small flathead.The first time you change it you might have to use some elbow grease to get everything loose and be able to get the top of filter box off but dont fret its easy anyproblems just ask.
What does the flashing lightning bolt mean in your 2004 dodge durango?
I recenlty had this problem..it is the Electronic Throttle Control. I took my truck to Dodge to have it repaired they had to replace the throttle body and clean and reset something in the computer. It cost me $573.00 to have it repaired. It took only a couple of hours for repairs to be made. So far so good I have had my truck back for less than 24 hours so we will see!
How do you replace the water pump on a 1992 Pontiac Bonneville?
you have to remove motor mount ,jack up engine use a board so as to distribute weight , loosen motor mount bolts, raise engine,remove motor mount, remove rest of bolts, remove water pump, clean area, put gasket stuff on pump,place gasket put more stuff on top of gasket ,reinstall water pump, tighten in a back and forth pattern,replace motor mount,also you will have to remove belt before anything else by moving tensioner but figured you knew that already
How do you install a CD player in a 97 Mercury Mountaineer with a power antenna?
You need to buy a set of Ford radio removal tools (about $5) they are "U" shaped. Push the 4 ends into the 4 holes on the front of the radio about 1" until it releases and then use the tools like handles to pull it out. On 2002 and earlier I think you have to remove some trim first. After pullling it out unplug the antenna and the harness and you are done
How do you install a CD player in a 2003 Echo?
If not available for after-market systems:...goto an audio video store or (better) an auto audio specialist and purchase the install kit for the model CD player you have to match the echo year.
last choice is: to goto a junkyard that has an echo and retrieve extra parts before beginning installation and last choice is goto a Wal-Mart and buy the cheapest Chinese aftermarket kit for echo years-??-??...which may or may not be a great solution...I've seen these kits work perfectly for installing normal size chassis into a GM(large) dash opening, but have also seen 'worthless, non- adaptable parts in these broad range inexpensive kits...
Very last choice or alternate is:...If you haven't purchased the CD system yet...goto a circuit city or better store and get free installation with purchase on system...you will still be charged for additional kit(s), which they usually only use minimal parts from.
2000-2004 TOYOTA ECHO (Factory Radio/CD replacement)1) Remove the (2) Outewr A/C heater control knobs.2). Remove the (2) Phillips screws from these locations
3). GENTLY unsnap the A/C-heater control panel, disconnect the harness and remove.
4). Gently u7nsnap the trim from around the radio and remove.
5) Depress the tabs securing the heater controls in place and pull slightly forward and upward to allow access to the top radio mounting screws.
6) Remove the six Phillips screws securing the radio.
7). Gently slide the radio forward and disconnect the wire harnesses and antenna lead and remove radio.
8) if adding single Toyota CD player to existing radio, plug CD player to contacts on radio.
if your engine is ideling like crap and it wont stay running unless you are holding on the gas check your heads i am having the same problem with the gas smell and i had a valve seat drop out on me on my number 7 cylinder if they are fine check your idler air control it may be throwing to much gas into the cylinder
