0
Dodge Intrepid
In this category you can ask questions about Dodge Intrepids. These questions can include where to find parts, how to get help, or how to do it yourself.
1,915 Questions
Bank 1 includes cylinder number 1. Bank 2 is the other side.
Where is the Location of oil drain plug on 2000 Dodge Intrepid?
For the engine oil - at the bottom of the oil pan.
How do you jump start a 2000 intrepid?
there is a small box where the battery would be that you hook the positive to and you can just hook the negative to anything that would ground it
How many and where are the input and output speed sensors located on a 2000 Dodge Intrepid?
There is one of each and they are located on the left (or driver's side) of the transmission. The front one is the input sensor right by the dipstick tube, and the rear one is the output sensor. Must be careful when tightening the new ones since the are plastic.
How do you turn on the fog lights on a 97 Dodge Intrepid?
The light switch pulls out to turn on the fog lights. They won't come on with the brights. ----turn on the headlights and gently pull out that same knob--note fog lights will not work if hi-beam are on....junboy33
Why does your Dodge Intrepid make a grinding noise after putting new brake pads on?
I had the same problem. It sounds worse than the old breaks. I upgraded to a break pad that has copper in it. It is a softer pad, but works great. Also get the rotors turned. That will fix the problem.
Do you have to take apart the engine to replace the water pump on a 1997 Dodge Intrepid?
3.5L, yes. It is driven by the timing belt.
3.3L, no. It is external.
3.5L, yes. It is driven by the timing belt.
3.3L, no. It is external.
There could be a blockage in your heater core, I suggest you get it flushed to see if there is flow through it.
There could be a problem with the jetting (for your altitude) or the condition of the air filter (dirty?). These are what I would check first.
What size engine in the intrepid has engine problems?
What_size_engine_in_the_intrepid_has_engine_problems
What to do with a 2002 3.5L intrepid with a check engine light code p0132?
Trouble code P0132 means: O2 Circuit High Voltage (Bank 1, Sensor 1) Replace the upstream O2 sensor (cylinder 1 side)
I had this happen. You need to make sure you disconnect the negative battery cable. Wait a few minutes and reconnect. This is needed to reset the "computer". Then drive it. If it returns to limp mode, repeat the above and it will eventually return to normal shifting.
Does the engine come out through the top or bottom of a 1994 Toyota Camry 2200?
job done...motor comes out the top, leave the trans in place.
How much will it cost to repair the front transmission seal on a 1995 Dodge Intrepid?
I was told by one shop that it would cost me $975.00 for an overhaul of the transmission which involves replacing seals and I think O-rings. The guy seemed very honest and it sounds like it was within a reasonable price range. However, I am still thinking about whether or not to fix or replace the transmission or even better yet get a new car.
What is a whining noise on 2.7 liter 1999 intrepid engine?
It could be your power steering pump, check power steering level. Also could be alternator or AC bearings.
How do you replace the headlight assembly located on a 2000 Dodge Intrepid?
look in the users manual for the instructions on replacing bulbs. it's the same because you have to remove the assembly to replace the bulbs there are 2 jack screws , on the top of the assembly, one on each side. remove them and pull the assembly out towards the front of the car. remove the lights put the lights in the new assembly. put the new assembly back in and replace the jack screws. you will need to adjust the lights.
Car shakes when press the brake?
Remove the brake rotor and have it checked at a reputable auto parts retailer.
Rotors often warp with age, especially if they have been overheated.
