answersLogoWhite

0

🚗

Dodge Ram

The Dodge Ram is a large pick-up truck produced by Chrysler from 1981 to present. The car, which features a front engine and rear/four-wheel drive, was named “Truck of the Year” three times by the Motor Trend magazine.

13,744 Questions

Where is the 1998 dodge ram 1500 4x4 fuel filtre located?

It is in the fuel tank, part of the fuel pump module.

Where is the horn on a 08 Dodge Ram?

There are 2 horns, a high tone and a low tone, they are located inside/behind the front bumper.

Where is the IAT Intake Air Temperature sensor on a 1998 S-10?

It's located in the air duct between the air filter and the throttle body. The large square sensor is the MAF (Mass Air Flow) sensor. The small sensor further up is the IAT. The IAT is stuck directly into a hole in the duct, with a small electrical connector attached to it.

What is the location of the flasher signal in 1974 corvette?

I assume you mean the Flasher Relay. It is located in the front seating area, passenger side, under dash, mounted above kick panel.

Why would a 2001 dodge ram 1500 sport being running fine until it warms up than start shifting rough?

bypass the the line that runs into the radiator. witch is a trans oil warmer. reconnect both lines together

How many quarts to fill transmission on a 1997 ram?

From empty the manual will hold about 5

The gas automatic holds about 12

The diesel automatic holds about 16

From empty the manual will hold about 5

The gas automatic holds about 12

The diesel automatic holds about 16

Where is the crank sensor on a 1997 dodge ram?

Behind the passenger side cylinder head, sticks down into the bell housing

How can you tell if rear end gear have lost teeth?

You will need to remove the plate that's on the back of the rear end housing and look inside at the gears to know for sure.

How much does a ram truck weigh?

The 1500 weighs in at approx 6000 pounds......but it would also depend on two wheel drive or four.

What does no bus in a dodge ram 1500 truck mean?

The "bus" is the communication network on the vehicle. "no bus" is a failure message that the system is down. The problem can be any computer, or any wiring in between.

What can a mass air flow sensor cause that is going bad prevent an engine from doing?

I found that I would have trouble starting the truck , rough idle and poor fuel mileage , there is a product on the market that will clean the sensor. CRC makes it and it's called MAF cleaner , about $6.oo , good luck. Terman

What is the torque rating of a 1974 Chevy small block 400?

A 1974 Chevy 400 came with either a 2 bbl or 4 bbl carb. The 2 bbl made an advertised 295 ft. lbs of torque at 2600 rpm, and the 4 bbl made 290 ft. lbs at 2400 rpm.

What is the best antifreeze for the dodge hemi?

Use a HOAT (Hybred Organic Acid) coolant. Zerex G05 is a good one as is the Fleetguard Compleat EG. Do not use an OAT coolant like DexCool. Of course you can always get the right stuff at your Dodge dealer and the price is competitive (at least in my area). These coolants do a better job protecting the aluminum and what not in modern engines.

For the original Hemis its best to use the original IAT (inorganic acid) green coolant thats been around for years. This would be like the original Zerex, original PEAK and Fleetguard heavy duty should be OK too. These use silicates and phosphates as the main corrosion inhibitors.

Don't rely fully on color as it not universal for each type- though as a rule most green colored coolants should be OK for older engines and the yellow colored ones OK for newer engines.

Where is the IAT sensor located on a 1997 eclipse?

if you are trying to find this to make more power by upping your fuel mixture by tricking that sensor i am telling you its a bad idea. you really are not going to make any real power, contrary to popular belief, especially if you are an N.A. motor. if you are trying to find it for a real reason it is on the back side of the intake plenum closer to the passenger side of the motor. it has a grey plug and what will look like a threaded nut and nipple that attatches it to the plenum. honestly if you are trying to trick the ecu with that sensor you are going to regret it later on. in all actuality if its a turbo car you should even be worried about something that insignificant spend the dough get a boost controller and youre good. if its an N.A. car nothing you can ever do short of a motor swap or a heap of nitrous will ever make that car fast.

Why does your 1997 Dodge Ram pull right when braking?

The left front brakes are not applying at the same rate as the right front. Possible causes are a failed left front caliper, left front brake hose, frozen caliper slide, etc.