Where is the cam shaft position sensor on a 2001 dodge diesel?
It is below the injection pump, in the back of the timing cover.
Why would a 1600 Boxer engine start ok but backfire and have no power under a load?
Out of time or spark plug wires incorrectly installed.
How does the diagram of Kia 1998 sephia fuse box under the dash look like?
When you open door and look down to where your foot pedals are, look to the left and you will see the plastic trim around foot well, you will then see a pull out section of plastic trim, when you remove this panel cover you will find the fuses, on the backside of the plastic cover it will tell you which fuse is for which part of electrics. Hope this helps.
I just fired my ecm with that same number in my 94 ram5.9l
What could cause the ABS and brake light to come on a 96 Dodge Dakota?
An electrical failure in the ABS system.
An electrical failure in the ABS system.
Where is the speed sensor on a 2005 Dodge Ram 1500 located?
There are transmission speed sensors on the transmission and abs speed sensors for the wheels. The speedometer signal comes from the abs system.
There are transmission speed sensors on the transmission and abs speed sensors for the wheels. The speedometer signal comes from the abs system.
Where is the radio speaker amplifier in a 1998 Dodge Ram Van 1500?
In the radio, there is no other amplifier.
Is 4.10 gear ratio bad in a dodge cummins?
No, it is a great ratio for pulling power.
No, it is a great ratio for pulling power.
Will the 6.1 out of srt8 hemi fit in a dodge charger se?
Short answer: Yes. But considering all the time, trouble and $ you'd spend on such a project, you'd be better off just trading in an SE for an SRT8.
How do you depressurize the fuel system on a 1996 Dodge Ram?
Remove the fuel pump relay from the under hood fuse box and crank the truck until it doesn't try to start.
Will the car pull to the right when braking if the left front caliper is binding in its bore?
Generally, yes.
The binding caliper causes the pads to rub against the rotor heating the pads and rotor up. Hot pads and rotor provide less braking under equal pressure (when braking) so the right brake works better. The car will pull toward the better brake.
Why is my brake lights staying on in my 1995 dodge ram 2500?
You have an electircal malfunction. Take it to a repair shop.
What causes 2006 dodge mega cab 2500 to shake in the front and rear while accelerating?
A worn out Universal joint in the rear driveshaft.
Where is the oil pressure sending unit on a 1996 Ford Explorer v6?
the sending unit is located near the bottom of the block on the left ( driver side) it is on the same harness as the oil level switch
How do you fix the automatic transmission on a Dodge Stratus 2000?
You have to know whats wrong with the transmission before you can fix it.
ABS light comes on and at the same time you have no power to windows wipers heater blower?
try new ignition switch but not the key part of the switch the electronic part of the switch...when everything stops try turning the key towards the start position but don't turn to far as not to grind the starter while running...if everything comes back on it's for sure.but sometimes even turning the key will not work. remember the electric part of the switch only...
What would be the problem with cruise control shutting off on 2005 mit. lancer?
There is no one specific fuse according to the Lancer manual that relates to only cruise control (according to my 2008 Lancer owner's manual, anyway). It might be tied-in with another circuit related to it. The best thing to do would be to check continuity for all fuses in both fuse boxes (in the engine compartment and under the steering wheel), and any blown fuses might be your issue.
Another possibility could be the stop switch located at the top of your brake pedal (you'll have to remove the panel under the steering wheel to get to it). If this switch has failed, the engine's ECU won't recognize the stop command electronically. While the car will still stop, this electrical signal is necessary for cruise control to be active. The biggest give-away is that typically when this switch gives out, your brake lights won't work either.
Where is the oil pressure sending unit on a 1999 Honda Prelude H22?
it is on the back of the engine block below the oil filter on the base model prelude. type sh model isn't as easy to find
How do you replace a wiring harness on a Dodge Ram?
The wiring harness can be removed by unplugging all of the wires. The wiring harness is also held in place by several retaining screws. Remove the retaining screws.
That is behind the catalytic converter.
Where is the 1998 dodge ram 1500 4x4 fuel filtre located?
It is in the fuel tank, part of the fuel pump module.