answersLogoWhite

0

🚗

Dodge Ram

The Dodge Ram is a large pick-up truck produced by Chrysler from 1981 to present. The car, which features a front engine and rear/four-wheel drive, was named “Truck of the Year” three times by the Motor Trend magazine.

13,744 Questions

What does code P0301 mean on a 2001 dodge ram?

Trouble code P0301 means:Cylinder 1 misfire detected

How many 1970 4 speed dodge TA challengers were made?

There were reportedly 989 1970 Dodge Challenger T/As sold with the 4-speed transmission.

How much will speedometer change if you go from 15 inch rim to a 20 inch rim?

The idea when doing this is to install a tire with a shorter sidewall. It's the overall diameter of the tire you are looking to match. If your stock set up has a tire with an overall diameter of say 26" then you'll want to find a tire with the same overall diameter in the 20" version. However, you aren't going to have much sidewall left on the tire with the 5" change you're making. Watch out for potholes or those rims are toast. Tire Rack online allows you to shop tires by size and you can click on the specs. The diameter will be listed there. Keep plugging in tire sizes until you find the ones that match.

Why are federal BLM fire trucks smaller than city fire trucks?

City fire trucks (which are called structural engines because they fight fires in structures) have to carry ladders along with a much larger pump because they use much more water than BLM (wildland fire) engines. Since they don't need all that extra large equipment wildland fire engines to be built shorter to make it easier for them to maneuver on mountain roads and through dense forest areas.

Why are your rear speakers not working in your 2001 dodge magnum?

There is no 2001 Dodge Magnum. The earliest 2000’s model is the 2005 year model.

How do you tighten the steering on your ram?

More than likely it's a bad gear box. Also could be worn front end parts.

How do you change front wheel bearings on a 2003 dodge ram?

Take tire off, take caliper and brakes off, take off axle nut, take off caliper, take off three bolts from back side of bearing hub assembly (may have to turn steering to get bolts off). You can put a bearing puller or use something to move spline shaft back further. Use a slide hammer and slotted flange to "bang" out wheel hub assembly bearing, (most parts stores have these to rent and you get your money back on return). Parts stores also let you rent the axle nut socket. Ssince most people don't have this size.

If this doesn't work because it is seized, take the whole housing off (some are cast aluminum, mine was).....three nuts, two are usually 13/16 and the bottom one 15/16" take the whole housing off, hammer down on it to get loose. Take to a place with a press....pepboys, local tire shop...make some phone calls. Have them press it out and put the new one in. Total cost of project: 200$ for wheel bearing hub assembly 50$ labor at pepboys to press old out and new in.....and 8 hrs. labor if you have air tools.

What is the gas tank capacity on a 1999 dodge ram?

{| ! | 1500 series with 6.5' short box 98 L (26 gal.) 2500 Series Club Cab and Quad Cabwith 6.5' Short Box 129 L (34 gal.) All 8' Long Box 132 L (35 gal.) All Cab/Chassis Models 132 L (35 gal.) |}

What causes your 1990 Buick LeSabre to jerk while driving up small hills?

If the hill is steep enough, and if you are going fast enough, with mild to heavy throttle pressure, or at highway speeds, with the cruise control set, the jerk you will feel is the transmission kicking out of overdrive as the engine applies more power to get over the hill. First thing I would do is check the Transmission fluid level. If it's ok then is the fluid "Burned" (used up). If it is burned have it and the filter changed. A good "reverse" flush even better (it will get the fluid in the torque converter also). Sounds like a Tranny problem but it could be "Engine Load" related, check the tranny first. TommyTrouble try to change sparks. it welped to me

How to change oil?

Park vehicle on a level surface. Remove the oil pan drain plug and drain the oil out in a catch pan. Remove the oil filter and apply oil to the gasket of the new filter. Screw on the new filter tightening it 3/4 turn after it makes contact with the mounting surface. Pour in the correct amount and weight of oil needed for your vehicle.

What is meant by 'anything is possible when you have enough nerve'?

You need intelligence and motivation to accomplish your dreams. Any fool can have "nerve" and follow a dare. It takes someone special to cultivate intelligence and to remain motivated during the tough times.

Where is the temperature sensor in a 1996 dodge ram 1500 5.2l?

It is located to the left of the thermostat housing for the temperature gauge, there is another to the right of the thermostat housing for the computer.

What transmission model does a 2001 dodge ram 1500 3.9L have?

Manual is a NV1500

Auto is a 42RE

Manual is a NV1500

Auto is a 42RE

How do you change headlight bulbs in a 2004 impala?

See Headlamps, Front Turn Signal, and Parking Lamps on page 5-53 of your "Owner's Manual", under Section 5: Service and Appearance Care - Bulb Replacement.....

Can you run e-85 in your 1997 dodge ram?

No, the ethanol will "eat" the rubber in the fuel lines, pump, and seals.