0
Dodge Ram
The Dodge Ram is a large pick-up truck produced by Chrysler from 1981 to present. The car, which features a front engine and rear/four-wheel drive, was named “Truck of the Year” three times by the Motor Trend magazine.
13,744 Questions
It can be a bad sending unit or it can be low oil pressure. Start by replacing the filter with a Motorcraft filter if you have a Ford or Purolator if you have a Dodge, and making sure you are using the recommended weight of oil. If the problem still exists then replace the sending unit.
How do you change a rear pinion bearing on a 1999 Dodge 1500 RAM 4X4?
remove rear drive shaft from vehicle.remove large nut ( pinion nut) at front of diff, which is generally hidden when driveshaft is in place.with a bearing puller remove pinion bearing, replace with new one. install new pinion seal. reinstall pinion cover and pinion nut. tighten to specified torgue.reinstall driveshaft check diff oil for proper amount
How do you replace Brake pads on 2004 Dodge ram 2500 4x4?
The brake pads on a 2004 Dodge Ram 2500 4x4 are replaced by removing the wheels, unbolting the calipers, and taking out the brake pads. The caliper piston must be pressed back in before new pads are installed.
Show me a diagram of the firing order for a 1993 Pontiac Grand Am 3.3L V6?
1-6-5-4-3-2 #1 cylinder is in the front on the passaenger side and you wire it from the top down on the coil pack
Where is the transfer pump on a 24 valve 5.9 cummins?
Factory location was driver side of the block, above the starter. New location is in the fuel tank.
Can stock 360 heads and valve train support a cam providing 444467 gross lift?
I believe the stock valvetrain can handle up to a .480 lift before valve springs and pushrods are needed. You can always call Summitracing Tech service. It is free.
Where is the speed sensor located on a 1997 dodge ram 1500 truck?
on my 4x4 it is on top of the rear diff into the housing..
The N14 was a 14 liter, inline six, heavy duty diesel engine made prior to the implementation of ACERT emissions regulations in 2002.
How can you tell the difference from a limited slip and an open differential?
Three ways:
- Call a Dodge dealer with the VIN # and ask
- There is a tag usually on one of the rear diff cover bolts that says what it is, ratio and what oil additive to use.
- Jack up the back wheels and try turning one of the wheels. With the trans in park or for a manual in gear, in the limited slip the rear wheel will not turn by hand. The open differential will.
Except my truck, It has so many miles on that the guts inside the limited slip are so worn that it acts like an open diff for this test
How many speed sensors are on a 1998 dodge ram?
There are usually two separate speeds sensors on a 1998 Dodge Ram. One is located on the rear of the automatic and one is located on the front of the automatic.
How do you take off wiper arms off of a 1998 Dodge ram?
The wiper arm has either a nut under a cover at the transmission post or a sliding plate . The nut is self explanatory, the sliding plate you will stand the arm up to releive the pressure and slide the plate from under the post.
The red round circle light is the indicator for a failure in the theft alarm or Sentry Key (chip key) system.
The red round circle light is the indicator for a failure in the theft alarm or Sentry Key (chip key) system.
How do you tune the engine on a 2001 dodge ram 1500?
specd-halo l.e.d. projector headlights wiring installation" 1994 dodge ram
How do you take off and replace the starter on a 1998 Trooper?
The starter is located on the drivers side of the engine compartment, just inside the rear of the inner fender well. If you are looking to replace the starter it is not a fun job. I read that you have to drop the lead pipe. I took off the heat shield on the wiring harness by the lead pipe and the heat shield on the lead pipe. Then I took off the cross member. Finally I put my jack under the engine and rised it as far as I could. This allowed me to flip the starter and pull it out in reverse. I still found I had to wiggle it. I also shaved a little of my tranny housing of with a dremmel. This was a sucky job, but it worked.
Dave
Exhaust leak in engine compartment area?
The first thing to look for is around the exhaust manifold area.This is where many exaust leaks start for different reasons.The area of the the leak is going to be usually a black color because of the of carbon residue left from the burning of fuel.This will be the tell tale sign of the leak.the exhaust manifold usually leads to a down tube that either goes into a pipe that that goes back to a catylitac converter or to a flex pipe(it usually looks like a braided steel hose.These pieces are bad for rusting out.That's the problem im having now.front wheel drives are different than rear wheel drives,because of that flex pipe,fwd have that and rwd don't.Rwd use a donought from the exhaust manifold to the pipe,where as fwds use that flex hose.Now in a rwd car that donought can and will be damged or rust out,just like the areas where the flex tube is on a fwd do.these areas are usually bolted together with a clamp of some sorts so those are the the areas you should look first.
What kind of Antifreeze does a 1998 Dodge Ram Truck use?
It will use normal antifreeze and it should be mixed 50/50 with water.
It does not matter.
How do you replace a heater core in a 85 dodge ram van?
Take out the screws that hold the AC/Heater housing together and separate it, and it's right there.
