0
Dodge Ram
The Dodge Ram is a large pick-up truck produced by Chrysler from 1981 to present. The car, which features a front engine and rear/four-wheel drive, was named “Truck of the Year” three times by the Motor Trend magazine.
13,744 Questions
Which is the correct voltage division setting for testing a throttle position sensor?
Volt meter should be in a 5 volt scale.
Is a stock 99 dodge 5.9L gas V8 injected or carburated?
All newer cars are fuel injected. But some are carburetored fuel injection(CFI) and some are tune port injected (TPI). The CFIs share an injector or injectors in a carburetor valve body like the old carburetors, and the TPIs have an injector at or in each cylinder for that cylinder only.
Too much fuel or not enough fuel going in...too large a jet size or incorrect float adjustment. I suspect too much fuel because of the performance carb.
Answerprobably because you were hitting the secondarys to early with to much throttle wich would dump to much fuel in the pots AnswerTypical problem with engines that have had "external" modifications only to improve performance. It's called "over-carburation", and is often the case when a carb that is too big is bolted to an engine not properly prepared to accept it. Headers help, but what you will need to do, is replace your cam with one that matches the capacity of your carburetor, or get a smaller carb. In short, spend more money.Where is the block heater cord on 2011 dodge ram truck?
Very few where built with the cord from the factory. On the diesel it is located on the pass side. The heater element is behind the oil filter. The cord usually has to be bought from the dealer and installed.
How do you replace the PCV valve on 03 dodge ram hemi?
From the manual: 5.7L V-8 The PCV valve is mounted into the top of the intake manifold, located to the right / rear of the throttle body (Fig. 12). The PCV valve is sealed to the intake manifold with 2 o-rings (Fig. 13). (1) Remove PCV valve by rotating counter-clockwise 90 degrees until locating tabs have been freed. After tabs have cleared, pull valve straight up from intake manifold. (2) After valve is removed, check condition of 2 valve o-rings.
Are the high mileage motor oils worth the extra money?
Most people are saying that the "high mileage" oils are better for protecting gaskets and seals in your engine. However most recommend only using it if you've noticed soot or dark smoking coming out your exhaust. If the exhaust is clean and you're properly changing your oil regular oil should be fine.
How many O2 sensors are there on 1991 dodge Ram van B-250 5.2L engine?
there are 2
upstream before the cat n downstream after the cat
How do you Remove air filter housing dodge ram?
Before removing air filter housing, allow engine time to cool. Remove Phillip head screws with a power drill preferably. Remove all hinges then lift top off. Replace air filter with a clean new version. Make sure you follow owners manual instruction book.
How do you change the power steering pump on a 2000 dodge ram 1500 with the 59 liter magnum engine?
you need a special puller, it is designed to remove the pulley whitch is pressed on, after the pulley is removed you can get to the 4 bolts that secure the pump, the puller also servs the purpose of pressing the pully back on, can be bought at most auto parts stores, i paid around $70 for mine, unless you do this type of work often it will get used once and that's it, so you may be dollars ahead just to pay someone to do it for you
What does a dirty air filter look like?
a dirty air filter usually has a dark dingy color to it either black in filters found in vehicles or grey dusty like those found in a home. usually any color other than the original factory color.
Hold it up to a bright light, if you cannot "see through it" it needs to be replaced. Also if it is oily you might want to replace it.
How do you figure out what is wrong with the fuel system on a 1980 Volvo 242?
Check your fuses first.
No they are not. The hazard flasher should be located in the fuse panal. While the turn signal flasher is located behind the dash near the AC controls. Can be a pain to find and replace.
where are the abs inop
What is the stock timing for the 2004 5.7 hemi?
Not sure what you are referring to. The ignition timing is computer controlled and is not adjustable.
Not sure what you are referring to. The ignition timing is computer controlled and is not adjustable.
How do you stack 2 quads in a pickup bed?
The best way is to stand both of them on their rear wheels. Answer: I normally see them standing on their real wheels with the back second quad piggy backing on the first quad. Put something on top of the first quad to limit scratching. Also make sure you secure both bikes to limit excess movement.
What would cause horn to honk all the time unless you unhook battery?
the contact is probably stuck in the button in the steering wheel. Unplug the horn in front of the grill. Now you can reconnect the battery cable. the cover comes off most vehicles pretty easy. the contacts should be under that.
Are all helper springs for a Dodge Ram 1500 the same?
Certainly not. There are various types of helper springs for all vehicles, including your Dodge Ram 1500. The most common types of helper springs are steel overload helper springs, air bag helper springs, add a leaf kits, and rubber bump stops like timbren kits. All can be used to achieve the desired load support. Some have advantages over others. Air bags are nice because you can have the ability to adjust your load support to your desired capacity by raising or lowering the pressure in the bags. However, many steel helper springs are progressive nowadays, meaning they will adjust with your load so that your factory ride is unaffected when you are unloaded. Timbren kits will act as a helper spring and give you load support when you need it as well. They are installed between the axle and the chassis and will make contact when your vehicle is loaded. All of these are good options, it depends on your situation and taste is to which you choose. All can be found and purchased at sites like <a href="http://sdtrucksprings.com">http://sdtrucksprings.com</a>
Is a cummins better than a powerstroke?
no a powerstroke is the biggest peace of S H I T. cummins is the best diesel there is.
It can also depend on the year of the motors. The powerstroke 7.3 turbo diesel is a very strong motor that has done very well for Ford. The 6.0 powerstroke on the otherhand has done very poorly for Ford. The cummins also gets better fuel mileage than the powerstroke by around 5 mpg's just as a stock motor, but power adders will afect that. In my personal opinion i would would take the cummins over the powerstroke.
Dodge V8 firing order is 1 - 8 - 4 - 3 - 6 - 5 - 7 - 2. Clockwise on the distributor. The cylinder numbers are 2 - 4 - 6 - 8 from front to rear, passenger side, and 1 - 3 - 5 - 7 front to rear driver side.
