0
Ford Escort LX
The Escort LX is a compact car produced by Ford Motor Company. Similar to other Escort models, this vehicle adopted the general design and badge of its European model counterpart.
3,056 Questions
How to remove the factory stereo from 1998 Ford Escort?
you will see two holes in each side of the radio, insert standard radio pins in here and the radio will pull out
How to Remove heater core in 1993 Ford Escort Wagon?
The dash must be completely removed in order to gain access to the heater box. Then the heater hoses are disconnected and the heater box is removed and opened up. That gains access to the heater core for relacement.
How do you remove Corvette transmission?
what year corvette? try searching the forums at www.corvetteforum.com - they have TONS of answers
Where is the PVC value on a 1994 madza b4000 40?
Driverside Valve cover I believe. In the back of it. I'm not sure about that year, but I think the Haynes manual said something about having to remove and replace an entire assembly, not just the pcv, to replace it. Sounds pretty dumb huh?
The PCV valve is at the back of the engine right on top right under where all your vacuum hoses connect. I replaced mine a while back and it was just a small plastic piece with a vacuum hose connected to it. It was really simple and took less than 5 minutes.
Where is the starter located on a 1995 Ford Escort?
Behind engine underneath intake plenum. See other wikianswer on the process of replacing the starter in the 1993 escort (same as 1995).
How do you get to the starter on a 1998 Ford Escort to change it?
you have to jack the car up. its on the side of the motor that faces the firewall. looking from under the car it will be on the drivers side of the engine. i believe its held in by 3 bolts.... or 2. be careful to disconnect the battery first or you might get some sparks taking it out.
How do you replace a timing belt on a 1994 ford escort 1.9L after the timing belt breaks?
It would be a good idea to get a Haynes repair manual at your local parts place for $20. It will pay for itself the first time you do anything. There are 27 steps to R and R the timing belt. btw your engine is a non-interference engine which means that when the belt breaks your engine doesn't get any damage. So get a manual and do it yourself.
What happens when you push the red button on I am Bored?
The red button turns on the fuel pump when it is pushed on a Ford Escort.
How do you change the speakers on a 1998 Ford Escort LX?
Okay, to change the rear speakers, push those buttons on the top of the seats. They're at either end. Pull the seat forward. Next, there are three retainers holding the cover down. Use either your nails or something thin and pry up the center circle of the retainer. Then grab on to the retainer and pull out. Keep in mind that it will hurt to pull it out but if you use pliers you run the risk of breaking them, so man up. Once all the retainers have been pulled out. Now, pull back the end of the cushions and pop out the cover. After this just unplug, unscrew and change the speakers. Remember that you really should unplug the battery first, just to be safe. Now, the front speakers are a bit trickier. Get a rag or something similar, it must be thin. If you've got manual windows, get the rag and put it in the handle like so. Rag goes --> o====0 <- this end is connected to the door. Push the rag in until you push out a "U" looking pin. Pull out the handle. Pull out all of the retainers, unscrew all of the screws, there's one inside the cup thing, and one on the door handle. Now just pull the trim panel up and towards the back. Change the speaker and bam, you're done. If you've got power windows, I think all you need to do is unscrew the screws and remove the retainers. Please keep in mind that you really should unplug the battery first. I cannot be held responsible if you mess up anything at all.
How to change the rear hub assembly on a 1999 ford escort sedan?
1. Loosen the lug nuts on the side you want to change.
2. Chock the front wheels.
3. Jack up the car.
4. Take off the wheel.
5. Work the dust cap off with a chisel enough to get a pair of pliers around it.
6. Pull the dust cap off with pliers.
7. Remove the brake drum and shoes.
8. Raise the staked portion of the spindle nut with a punch and hammer.
9. Remove the nut.
10.Remove the backing plate.
11.Unbolt the strut from the spindle.
12.Unbolt the trailing link from the spindle.
13.Unbolt the lateral links from the spindle.
14.Remove the spindle.
How do you remove the headrest on a 79 Ford Escort?
hold the button you push to get it to go back down while pulling it out
Your 97 escort wont start after a new alternator Was Installed. So what else can be the problem?
some of the wiring may not have been hooked up right
What causes a car to run fast when changing down on ford escort petrol car?
you step on the gas that's how cars move isn't it
The best way that I have found to remove the starter is to purchase or go to your local library and check out a copy of the Haines manual. I have used it to remove alternator, ECM, and the instrument cluster.
Where is the camshaft sensor located on 2002 ford escort 2.0?
wher is the camshaft sensor for escort2002
How long does it take to repair or replace a badly dented rear door on a Ford Escort?
Hey Barry==It varies with the body shop. Call and get estimates on time and labor costs. GoodluckJoe
How do you remove a transmission on a 1999 Mazda b3000?
Look for information on 1999 Ford Ranger 3.0L as well. (Same vehichle.)
How do you replace clutch on 1995 ford escort wagon manual?
Pre 1997/9 models of Ford Vehicles were self-adjusting via the clutch-foot-pedal. The pedal engages a ratchet system called the QUADRANT & PAWL and is part of the pedal. The mechanism is very similar on older Ford models of: Escort, Fiesta, Sierra, Granada, Transit & others. Newer vehicles may have a Hydraulic Clutch from 1997/9 onwards, and these work differently from the cable & pully mechanism. Clutch-fluid can be bled to improve the ability to operate the clutch, however this is not necessarily a method of adjusting the clutch.
If your reading this article because you have a broken clutch-pedal then please read on.
If when pressing the foot-pedal it feels like cable is broken, or pedal is loose, ...This is symptomatic of failure of the QUADRANT & PAWL 'ratchet' mechanism due to wear of teeth on the ratchet.
In some cases the pedal fails to pull the clutch out far enough to change gear, and may make a 'springing noise'. This is due to slippage on some worn ratchet-teeth, but the mechanism has not reached full failure. There are 2 ways to remedy the fault.
1. Change the Quadrant & Pawl, using only genuine Ford parts. #Beware of inferior mouldings that are not up to standard e.g. too soft, and do not trust 'pattern-parts' on eBay etc.
2. SHORTEN THE CABLE.
- Disconnect SPRING ON THE FOOT-PEDAL to release ratchet mechanism.
- Clamp cable slack (engine end).
A model escort is someone who is uaually very good looking that is paid to go to an event with someone. Could me that this person is a prostitute although not always.
There are four different engines that you can have with this model. a 1.8L, a 1.9L, a 2.0 SOHC, or a 2.0 DOHC. I am in possesion of the last of the four. The first thing to do is to purchase a manual. There are two major manu. of these manuals. Chilton's and Haynes. I reccommend the latter of the two. More pics and more in-depth instruction. It's a little difficult with some of the engines (2.0DOHC) not so bad with the others.
How do you remove a rear brake drum on a 1994 Ford Laser?
Hey can you explain where your up to in the removal process ? You can jack the back of the car up so both wheels are off the ground. Then romve both wheels Then you'll have to back off the rear shoes from the inside of the the hub with a screw driver. Then remove centre bearing nut Remove drum and photo or take off one side and see how it goes back together by looking at the otherside for the right procedure. Re-fit drum and adjust shoes until it is frim to turn under hand and no more. Hope it helps.
