What is the function of the inner tie rod?
on a steering rack the inner tie rod is threaded and will be the mount for the outer tie rod.
What kind of brake fluid does a 1995 Geo Prizm take?
A Geo Prizm requires regular DOT 3 brake fluid. Brake fluids labeled DOT 4, or "exceeds DOT 3 and DOT 4 specs" (such as Castrol GT/LMA) are also acceptable; these DOT 4 fluids have higher wet boiling points.
Where is 92 geo prism horn fuse?
If you can't locate it in the fuse box on your kick panel, check under the hood. I do know that your horn relay is there and I think the fuse is too, but I'm not positive about the fuse.
Wired incorrectlyor defective starter solenoid that stuck in closed position
What size speakers fit the rear of a 1996 Geo Metro?
6 ¾". Standard 6½" speakers can be made to fit by drilling the mounting ring, but it would be best if purchasing new speakers, to buy ones that already have an adapter ring included or are already designed to fit 6¾".
Also, because the speakers are mounted low in the door, choosing ones with a pivoting tweeter would be wise.
Where is the fuel pump located on a 1996 Geo Prism?
I am not 100% sure about the 1996 but on the 1994 it is located in the fuel tank. You need to remove the back seats to expose the mounting bolts.
What is Whine noise when wheel is turned all the way?
It's normal it's the power sterring bypass (relief) valve
Is there a difference between the wheel on a 1996 geo prizm and a 1997 geo prizm?
Both are 14" wheels. Should not be any difference
How do you change the struts of a 1994 Geo Prizm?
The struts are surrounded by a large coil string which is under very high compression. If you do not have the proper tools and remove it improperly you risk serious injury. You should consider having this done by a professional.
How do you remove a fusible link in a 1994 Geo Prizm?
Not sure if you have to remove a horizontally positioned bolt hold it from coming out above. But, the way Geo Designed it is the most outragous set up, big cluster f**k. The fusible link has two deep prongs held by a horizontal bolt and each fusible link has two wires running up underneath the link and the bolt must losen to remove the link but all you can do to loosen the bolt is a open end wrench and it is between a 9mm and a 10mm wrench. Hoping a 5/16" works but running out of options. You think something like this would be simple.
Did they change the fuel filter and the air filter as well. Odds are they didn't replace the fuel filter as they're kind of a pain in the rear to get to.
How much air do you have to put to the tires for a 2000 geo prizm?
The correct air pressure for tires is on a placard on the drivers door. The number that is on a tire itself is the maximum pressure that should be put into a tire, a tire should never be filled to this amount. Being up to 4 psi over the recommended pressure on the door will slightly improve gas mileage and usually improve handling. Typically tires should be inflated to around 35 psi.
How can you determine if you have a 1.6L engine or a 1.8L engine in your 1996 Geo Prism?
Answered by this question:
Using the vin numbers to tell which model Geo Prizm you have?
How do you replace a leaking fuel tank on a 1994 GEO PRIZM LSI 1.8L?
You'll have to drain the tank first. This will make it easier to handle. Take off the gas cap first of all and disconnect your battery. Take the back seat cushion out and remove your fuel pump access cover. Disconnect the wire connectors to the pump then jack the car up and support it with jackstands. Next you remove the center exhaust pipe and heat insulator. Then you disconnect the parking brake cables and move them aside. Now you disconnect the fuel lines and the filler hose. Make sure you plug these hoses to prevent gas leaking out. Last thing is to remove the straps and gently lower the tank. You may want to have a floor jack with a board on it to support the tank. And it wouldn't hurt to have someone assist when you lower it and pull it out.
Where can you buy taillight covers for a 1991 geo prizm?
hey whats up. they dont really offer any covers to buy. What you can do though, is mask off your own design on your tail lights with masking tape and paint it the same color as your car with plastic safe spraypaint... it looks awesome, for example, i did small circles across the light, or you can make 1 thin like in the moddle tht wld look pretty sick too...the design is up to you!! You can also just buy spray tint and tint them
What type of refrigerant is used when refilling the AC system on a 1993 Geo Prizm r12 or 134?
r12 is the original refrigerant on a 1993 model year Prizm r12 is the original refrigerant on a 1993 model year Prizm