0
GMC Jimmy
Introduced in 1970, the GMC Jimmy was a full-size sport utility vehicle (SUV) manufactured by General Motors. This vehicle was based on short wheelbase trucks and was available in four-wheel drive (4WD) or rear-wheel drive (RWD) layout.
1,424 Questions
How do you replace the heater coil on a 1996 GMC Jimmy?
You'll have to take the dash loos and all the electrical wireing then remove the dash from the vehicle. From there you'll have a brace over the block holding the heater core in place. Remove the brace and screws from the top cover, slide the core out and replace in reverse steps.
How are the door lock and unlock relays wired in order to install a remote car starter kit?
1995 GMC Jimmy Remote Start System Wiring
Vehicle Battery Positive Wire (+): Red
Vehicle Battery Positive Wire Location: Ignition Switch Harness
Vehicle Ignition Wire (+): Pink
Vehicle Ignition Wire Location: Ignition Switch Harness
Vehicle Second Ignition Wire (+): White
Vehicle Second Ignition Wire Location: Ignition Switch Harness
Vehicle Accessory Wire (+): Orange
Vehicle Accessory Wire Location: Ignition Switch Harness
Vehicle Second Accessory Wire (+): N/A
Vehicle Second Accessory Wire Location: N/A
Automobile Engine Starter Wire (+): Yellow
Automobile Engine Starter Wire Location: Ignition Switch Harness
Automobile Second Engine Starter Wire (-): N/A
Automobile Second Engine Starter Wire Location: N/A
Factory Anti-Theft System: GM Passlock II Vehicle Immobilizer
Factory Anti-Theft System Type: The Key Sends a RF Signal to the BCM Module
Car Key Sense Wire (-): Light Green
Car Key Sense Wire Location: Ignition Switch Harness
Car Neutral Safety Wire (+): N/A
Car Neutral Safety Wire Location: N/A
Car Tachometer Wire (-): White
Car Tachometer Wire Location: Ignition Switch Harness
Car Speed Sense Wire: Green/White
Car Speed Sense Wire Location: At Pin #3 in 24 Pin Black Connector at VCM Module
Car Parking Lights Wire (+): Light Blue
Car Parking Lights Wire Location: In Blue Plug at BCM Module
Car Brake Lights Wire (+): White
Car Brake Lights Wire Location: At Switch Above Brake Pedal
Car Reverse Lights Wire (+): Gray
Car Reverse Lights Wire Location: In Harness Going to Transmission
Car Horn Wire (-): Black
Car Horn Wire Location: In Harness at Steering Column
How do you fix a trunk door that will not open on a 2000 GMC Jimmy SLS?
if you here it clicking its not the wiring,fuse,switch or rear latch. There is a plastic arm at latch,it broke on mine.You have to remove back panel to replace it.dealer will remove for you. I cut a hole and covered it with a plate for future access.
Service engine soon light on 1999 gmc jimmy?
If your engine light has come on for your 1993 GMC Jimmy, you need to take you car in for service. You should make sure that you have enough oil in your car.
What would cause the power seats not to work on a 1999 GMC Jimmy?
check for power i had a problem with one in my shop i had no power to the unit i belive it should be the larger orange wire from connector back probe it mine was broken under drivers feet cheers man good luck
What causes the 1996 gmc jimmy check gauges dash message?
The "check gauges" light comes on when one of the sending units detects something is not right. It could be low oil pressure, engine over heating or low voltage. The next time it comes on CHECK GAUGES.
it is behind the glove box, open the glove box, push the glove box catch up, and flip the compartment open, your combo relay is a black relay on the right side, that is where your ticking is coming from, bet thing you can try is to replace it. Mine does the same thing The problem is in the turn signal switch.
How does high altitudes effect tire pressure?
The amount of air in the tire stays the same.The outside pressure drops about 3psi or 0,2 bar, when you are at about 2000 meters or 6000 feet. So you would expect that the pressure you measure is higher. But on 2000 meters height there is mostly a lower temperature, this lowers the pressure in the tire a bit. So it would not be strange if you measure the same pressure.
sounds like a blown fuse. chec under hood and under dash fuses.
What is involved in changing the fuel injector's spider valve on a 1993 Blazer 4.3 Vortec engine?
Purchase the "Nut Kit" from you local dealer, purge the fuel, remove the two halves of the plenum, remove all the old parts, gaskets from both sections if they have stuck to it and put everything back. Now this of course is the simple version without much detail, but the basics. Best if you purchase a shop manual if you pursue further repairs on your vehicle. The obvious when removing the necessary components from the area that you are attending to should be documented and note of which way the parts are and the way they go back. You can now a days with modern technology take digital pictures of the parts and return to look at their placement on your computer if need be and if you have one, which can make a mechanics life a little easier, especially if you need to stop for some reason and return later and pick up where you have left off. This job is not that difficult, a little time and patiences you can complete this. Parts will cost some dollars though.....
How do you repair freezer plugs on a gmc jimmy?
If you have a (casting plug) or what is commonly called a (freeze plug) that is leaking the only repair is to replace it.
What is the spark plug gapping for a gmc jimmy 1995 6cyl?
gap your plugs at 0.35
drive safe
actually the CORRECT gap for these is .45 no wonder they told you to drive safe, must have known it would be running bad!!!
yes the sending is bad your going to be right there change fuel pump too
Looking for vacuum and fuel system diagrams for s-15 gmc jimmy?
Purchase a shop repair manual for that vehicle. All that info is in there.
2000 gmc jimmy engine stalls while driving?
One reason that a 2000 GMC Jimmy engine stalls while driving could be your filter needing to be changed. The problem could also be a bad sensor.
Where is the radiator drain plug on a Jimmy?
bottom of the radiator nearest the passenger side. It's white, plastic, and somewhat resembles a wing nut.
How do you replace the thermostat on a 96 gmc jimmy?
remove the 2 bolts that hold the thermostat housing to the intake manifold which the upper radiator hose attaches to the housing then just pull the thermostat out and replace.
hey I put a 283 in my s10 and its a blast you will need to buy conversion mounts and a set of headers you can use your transmission to without changing drive shaft length and best of all you can use a flex fan because 283s have a small dampner I actually got better mpg then my 4.3 if i didnt have my foot into it
How do I replace the Wiper Circuit Card on a 1990 Silverado?
Replacing the card is easy, the card is located on the wiper motor where the wires plug in. Remove the wires and the hold down bolts (the card bolts not the motor bolts) then remove the card. Always when you are working on electrical parts disconnect the negative battery post BEFORE starting the job. Have fun----v8Chevyguy Before you remove the card, take a soldering iron and melt the solder globs on the old card just enough to make them shine, this usually fixes the (GM recalled) wiper motor. You don't have to remove the card to do this, just unplug it first. There was a big problem with "COLD" solder joints on these trucks.
Can you convert a 76 El Camino front end to the 73 caprice front end?
A simple bolt on swap is not possible. The 73 Caprice is a full size Chevrolet and the Elcamino is a midsized Chevrolet. If you pay a body shop to fabricate the work it would be very costly.
Why wont the 1998 gmc jimmy run it will start and then die whats wrong?
could be the fuel pump or regulator or the fuel pump could be plugged. if it turn key starts, there's enough pressure but if it dies, fuel is not getting to the motor.
Is there a chip in a 1998 gmc jimmy key?
No, there is no transponder in the key on a 1998 GMC of any kind. http://www.brandtlocksmiths.com/doc/DOcGM.htm
Why would my 1995 4.3L'V6 GMC SOMONA have no oil pressure?
1. low oil
2. electronic oil pressure switch has failed (probably not a mechanical oil pressure gauge cause then you would see a oil line running through the firewall to the gauge.
3. short in the wiring
