0
Infiniti I30
The Infiniti I30 was a mid-size luxury car produced between 1996 and 1999. The 1996 Infiniti 130 used a 3.0L VQ30DE V6 engine producing 190 HP and featured 4-speed automatic or 5-speed manual transmission.
490 Questions
How do you replace the instrument cluster in an Infinity I30?
Remove 5 screws under steering column Crack open and remove steering column covers. Lower Steering wheel Remove two screws on top of instrument shroud Pop out bottom of shroud which has retaining clips Remove two connectors on left side of shroud by squeezing locking tabs Unscrew air sensor on right side of shroud Remove shroud Remove three mounting screws and pull out instrument cluster Remove three connectors on back of cluster by squeezing locking tabs
How do you replace a fog light bulb on a 2000 Infiniti I30?
If you look under the bumper in the area of the fog lamp, you will see a plastic cover preventing access. There is about a 2 " hole in this cover. If you look into the hole you will see a screw head. This is the fog lamp assembly screw. You must remove it to remove the assembly to get at the bulb. However, you really need to remove a few screws and clips to get under this access cover. This is the only way you can remove the bulb wires from the back of the assembly as the assembly slides forward out of the bumber. After you get under this plastic cover, remove the side bulb by twisting slightly counter clockwise. Remove the Fog lamp wire by twisting that connector as well. There will be two wires still connected to the back of the fog lamp. remove these carefully. There is a push clip on the side of fog lamp assembly toward the engine. Push this with your finger or the head of a screwdriver. Push on the back of the assembly and it should slide out. Once out, you should be able to figure out how to remove and replace the bulb and then re-install. There is also a PDF repair manual on www.pdftown.com that you can download for free. Once downloaded, you can open each chapter as individual PDFs. The password for each doc is "pdftown.com"
If a 1998 Pontiac Transport 3400 starts but stalls out what should you check?
There's a solinoid in the transmission.Suggest to check that first.
Turn on interior lights. Start engine. If the lights go out when the engine stalls, you have a bad ignition switch.
Where is the Starter located on a 1996 Infiniti I-30 automobile?
It is located underneath the air filter, at the driver's side. Therefore you have to remove that filter and its base while you are standing (the car need not to be jacked). I hope this would be helpful to you.
How do you put refrigerant in an Iinfinity i30?
To add refrigerant to an Infiniti I30, first ensure the engine is off and the air conditioning system is turned off. Locate the low-pressure service port, which is typically found on the larger diameter aluminum line. Attach the refrigerant can's hose to the port, start the engine, and turn on the AC to the maximum setting. Finally, slowly release the refrigerant into the system while monitoring the pressure gauge until it reaches the recommended level. Always follow safety protocols and consider consulting a professional if you're unsure.
What is the shop labor hours to replace a knock sensor on a infiniti q45 1997?
"http://wiki.answers.com/Q/What_is_the_shop_labor_hours_to_replace_a_knock_sensor_on_a_infiniti_q45_1997"
Personal experiences and the solutions:
After the battery make sure you check the battery cable connecters. For some reason I have had really bad luck with them. I spent a lot of money looking for problems that weren't there.
I have a 2000 infiniti i30 and mine made the same clicking noise and would not even turn over. After checking all fuses and electrical connections, it was thought to be the starter. It was starting fine days before but just went out suddenly. I had the old starter and the new starter tested before purchasing the new one. Mine was held by 2 bolts which you must remove the air filter housing to get to and a series of extensions and swivels and breaker bar. Hope this helps.
This is likely an issue with the neutral safety switch.
I had the same problem w/97 I30t, After a new battery, starter and almost a new alternator it truned out to be a type of modulator inside the steering column. The part was about 70-75 bucks. I have not had a problem since.
I had the identical problem with my 96 I30 after letting it sit for a year and after recharging the battery. I have 343,600 miles on mine and I'm the original and only owner. I downloaded the schematic diagrams for the electrical system. I took out fuse #17 (10 Amp) which basically shut down the anti-theft (start) and it still didn't start. After checking that fuse #33 (7.5 Amp) was good, I replaced the starter (very first one) and it's working fine. The only other thing it could be is the inhibitor switch (Park or Neutral switch) so try both positions and if it doesn't start in either Park or Neutral, it's probably the starter. Bought the starter brand new on Ebay for $75 delivered!
Trouble code P0740 means:Torque converter clutch circuit malfunction
Where is the location of starter on 1998 infinity i30?
when facing the front of the car the starter is below the accordian ducting for the air filter. Basically you have to remove the air filter and some of the duct work so you can get at the two bolts and harness. An hour and a half will be adeqaute time to replace the unit. when facing the front of the car the starter is below the accordian ducting for the air filter. Basically you have to remove the air filter and some of the duct work so you can get at the two bolts and harness. An hour and a half will be adeqaute time to replace the unit.
How can you tell a 02 sensor is bad?
the check engine light will come on, the vehicle may run roughly. i'm not sure that you will know by sight or feel, you may need someone to code the vehicle to know for certain.
How do you install a alternator on a Infiniti J30?
How to Change an Alternator: Video Series check related link below
What is and where is the OBDII Diagnostic Link Connector on a 2001 Infiniti I30t?
Under edge of dash, on the driver's side, left of the steering wheel.
How do you change a belt tensioner pulley on a infiniti I30?
You will be best off safely jacking up the passenger front wheel. Remove the wheel for more work room. Loosen the 14mm nut on the pulley. Then back up top there is another 14 mm nut on the top loosen that. Now back under neath remove nut and replace pulley. Reverse for reinstall.
