answersLogoWhite

0

Mazda 323

Sold in many countries as Familia AP, the Mazda 323 was a rear wheel drive (RWD) car manufactured in 1977-1986. Mazda offered station wagon and hatch back bodies for this model and 1.0 L PC, 1.3 L TC, and 1.4 L UC engine options as well.

617 Questions

You have white smoke coming from your exhaust?

White "smoke" in the exhaust usually means there is moisture in the exhaust stream.

If the "smoke" appears while you're driving away shortly after the car is first started on a cold morning it is likely the condensation boiling off the inside of the exhaust pipes (steam). This is normal and goes away as the exhaust warms up. The condensation is also normal; it usually happens after the car is shut off on a cold day and the water vapor in the exhaust gases is allowed to condense as the exhaust system cools down.

If you have white smoke all the time, you may be leaking coolant into the cylinders which could mean a head gasket leak. Usually there is oil residue in the exhaust as well, which would be a tell tale sign of a blown head gasket. Then the white smoke would have a hazy blueish tinge to it. Also, certain chemical engine cleaners and fuel additives can create a white smoke. Have a mechanic check it out if necessary.

How do you repair a thermostat on a 1987 Mazda 323 and where is it?

The termostat is easy to replace, find the big black hose at the top of the radiator, now follow it back to the engine. where the pipe joins to the engine has 2 or 3 nuts holding it on. undo them and under that is your thermostat. buy a new thermostat and put it in. if you have no money to buy a new one just take it out as the car will run fine with out it unless you live in the snow.

What causes the engine to have a excessive white smoke when first start?

pressure test the coolant system you will find a blown intake or head gasket

What kind of gas mileage does a 1991 Mazda 323 get?

I have a 1989 Mazda 323 with a 1.6 Litre engine, Single overhead cam, two wheel drive and manual transmission adn 300,000 km (200,000 miles) on the odometer. In the city I get about 35 mpg (imperial) or 8 litres/100 km. On the highway I can get up to 48 mpg (imperial) or 5.9 litres/100 km. You shoudl get about the same with yoru 1991. If you have an automatic, figure on about 10% less gas milage. Short trips (under 5 miles) will bring your gas mialge down another 15-20%, so avoid short trips adn combine several trips for errands in one outing. A couple of other ways to improve your milage is to ensure all of your tires are inflated evenly (check when cold, 30-32 PSIG) and add fuel injection cleaner to your gas tank every time you cahnge your oil (every 3,000 miles or 5,000 kms or every 3 months). An annual tune-up will also help. Cheers Malcolm

What do you check next if your 89 Mazda 323 with a new coil won't spark when turning it over?

I assume you have new spark plugs, ignition leads, distributor cap and rotor. Also verify that you have 6 Volts at the coil negative terminal when the igniton switch is in the "Start" position. If all the above is correct, then the problem may be the trigger module in your distributor. I suggest getting a replacment from an auto-wrecker (cheaper than new from the dealer. Good luck Malcolm

What would cause a Mazda 323 not to start if there is a spark and plenty of fuel?

In order for the vehicle to start, you need to have a spark, fuel and oxygen. If you're not getting an adequate oxygen supply, your vehicle won't start. Have you checked your intake? Or perhaps your exhaust system could be clogged as well.

Where is cigarette lighter fuse in Mazda astina sp 323 1992?

the fuse is in the fuse panel. if its not the trace the power lines from the lighter back and you should find an in line fuse.

Where in North America is area code 323?

Area code 323 serves outer downtown Los Angeles, CA (but not inner downtown LA, which is served by 213).

The area code 323 is in Los Angeles, California.

The following cities in California, USA:

  • Los Angeles (a "donut" around downtown)
  • Bell
  • Bell Gardens
  • Huntington Park
  • Maywood
  • Montebello
  • South Gate
  • West Hollywood (part)

North American area code 323 is one of several area codes in Los Angeles, California. It is a "donut" around the core of downtown Los Angeles, including Huntington Park, Montebello, Silver Lake, South Gate, and Watts, most of Hollywood, and parts of Beverly Hills, Inglewood, Los Angeles, Pasadena, and West Hollywood.
North American area code +1 323 is for part of Los Angeles, California.

Where is the idle air control valve located on a 1992 Mazda 323?

On the intake manifold, were the end of the throttle cable attaches to the air inlet control. Two bolts, two nuts, two connectors, two very small coolant lines, one small air hose and one really big air hose are all connected to this unit.

Search for "mazda 323 IAC valve" A picture will pop up.

What is a new cotter pin?

A "Cotter Pin" or "Split Pin"is a hairpin shape metal pin,basically a strip if metal folded back on itself with a loop at one end.Usually used to lock a grooved nut to a bolt that will have an appropriate hole to accomodate the pin.Once inserted thru the groove/pin,the excess ends folded round to keep the pin in place.locking the whole assembly.Found on steering arms,drive shaft c/v's etc

Small bushes surronding a lawn?

Small bushes surrounding a lawn are often planted for ornamental purposes. These bushes might include boxwoods, gardenias, or even plumbago.

How do you remove ecu from 1988 Mazda 323?

I just did it. You do NOT need to remove steering wheel.

1. remove the screws that hold the plastic cover around the steering wheel and key tumbler.

2. Remove the top and bottom plastic pieces.

3. Using a "Z" type phillips or an "L" shaped phillips screwdriver, unscrew the single phillips screw at the top of the switch.

If you think that you will strip it, use a long flathead screwdriver and leverage it to the back of the phillips to keep the presser while unscrewing.

The entire process takes less than 10 minutes.

good luck

Where can you find the radiator plug on a 1994 Saturn?

On my 1992 Saturn the radiator petcock is above the splash guard on the bottom of the radiator on the side closest to the belt. You may want to drain the radiator via the lower hose. The petcock on my Saturn came apart. The retaining clip came off of the back. I did not force it and according to the Saturn forums this happens. I am now trying to see if it can be repaired or replaced and much farther than I wanted to be from completing a quick water pump change.

Where is the flasher located in a 1989 Mazda 323?

FRONT SEATING AREA, DRIVER SIDE, UNDER DASH, DRIVER SIDE OF STEERING COLUMN, MOUNTED IN RELAY BRACKET. It is located on the fuse and relay panel on the driver's side (LHD cars)partly up underneath te edashboard. It is square when viewed from the top about 1" X 1" and is about 2" tall. It is for both the turn signals and emergency flashers. Cheers Malcolm

Are 1988 323 parts and 19 94 323 body parts interchangeable?

No, the body panels are not interchangable; Mazda redesigned the 323 in 1990.; 1986-1989 are similar, with detail differences in the tail-lights and headlights and grille. Try searchign under "Images" on Google by typing the year make and model or try Edmonds.com for car facts. Cheers Malcolm

What could cause a 1989 Mazda 323 1600 engine freshly tuned to have either an ignition miss or fuel delivery problem occasionally under acceleration have replaced the throttle body and airflow meter?

Check the spark plug wires for a loose connection or a crack. Sometimes a spark plug wire will work well until internal engine pressures get high, which causes the spark plugs to develop a little extra internal resistance. When that happens the spark can jump through a crack in the wire. Also, check the distributor cap and rotor if they weren't replaced on the tune-up.

AnswerThe distributor cap, rotor, igniton lead set (including the lead to the coil) have all been replaced. The problem doesn't occur all the time when engine is warmed up, never when the engine is cold. Any ideas?

ThxMalcolm

AnswerI have solved the problem myself, but for those of you who have experienced a similar issue, you will want to look at replacing the Oxygen sensor. As i ahd repalced the sensor 3 years ago, I didn't think it was the culpurit. It was a Bosch after-market item. My parts guy recommended NTK (made by NGK) O2 sensors for Japanese cars. I did the work this past weekend and the car is back to running normally.

CheersMalcolm

What is difference between Mazda 323 gt and gtx?

gt is naturally aspirated and the largest engine size in the range ie for BG chassis 1.8 ltr twin cam fuel injected 16 valve engine, also gt is front wheel drive, gtx is four wheel drive and also factory turbocharged representing the most powerful model in the range apart from the GTR (BG).

How do i replace ignition parts on a 1988 Mazda?

I assume you are referring to tune up parts: distributor cap, rotor, igniton leads and spark plugs. The distributor cap is held on with two Philips head screws, the rotor is held on with one Philips head screw. Spark plugs are removed using a standard 13/16" spark plug socket and rachet. Firing order is 1-3-4-2, the distributor shaft rotates towards the front of the car. The distributor cap has #1 cast into the plastic. Timing is 2 degrees before top dead center with the engine warm, idling in neutral or park at 800 RPM and the vacumm hoses disconnected from the distributor's vacuum capsules and hoses plugged. Good Luck Malcolm

How do you replace the starter on a 1989 Mazda 323?

Disconnect the battery. The starter is located on the back side of the engine (the side closest to the firewall). Undo the main battery cable from the starter solenoid (held in place with a nut and washer). Disconnect the two smaller leadwires (push-on connector) from the solenoid. There are three bolts holding the starter to the bellhousing and either one or two bolts holding the support bracket from the starter to the engine block. Remove all the bolts and then the starter can be taken out by passing it underneath the intake/injection manifold and taking out the passenger side of the engine compartment (right side if facing forward). Cheers Malcolm