0
Mitsubishi Galant
The Galant is a car built by Japanese automaker Mitsubishi. The car was launched in December 1969 as “Colt Galant.” It is available as a two- and four-door sedan and features a choice of 1.3 or 1.5 L four-cylinder engines.
1,291 Questions
Where is the brake light switch at on a 1996 galant?
I think this switch which is adjustable is located above the brake pedal on a braket with a locknut. May be the bump rubber on the pedal lever is broken.
How do you change the spark plugs on a 2001 Mitsubishi Galant V6?
remove intake manifoled to access back 3 plugs. time consuming but can be done
How many quarts of oil does a 2002 Mitsubishi Galant take v6 3.0L?
4.5-to 5,just start with 4,and check the dipstick,add a half a quart at a time,till its full. you do not need to start or run the engine to get an accurate reading,that is a myth. I managed an oil change shop for 3yrs. nikknowledge!
What kind and size of stock speakers are in the 2006 Mitsubishi galant DE?
- Front: 6-1/2"
- Rear: 6" x 9"
- Front door: 6-1/2"
- Rear side panel: 6" x 9"
What is the clicking noise in driver side front tire every time it makes a revolution?
CV joints need to be replaced
Is there a safety kill switch on a 1999 Mitsubishi galant?
yes my friend own one and his had kill switch locate above the right rear tire inside the car.
Where is the transmission serial located on Mitsubishi Galant?
In most cases it located just above the fluid pan on the pasenger side just behind the govener its either stamped or bolted on
What would couse number 4 cylinder to misfire after changing plugs and wires?
First thing: pull th plug and check the gap and any extreme fowling. My first question to this problem-how do you know it is the #4 plug that is mis-firing?
If you are certain it is #4, pull the plug wire, insert a spark testor or an old plug, put on a glove that is well insulated (chore gloves work well dry), have somewone crank the engine, hold plug testor or plug about 1/4" from a well-grounded nut/bolt on the engine and check for spark. If the spark is blue, the spark is good. If it is an orange/yellow, it is weak-check the colil within the distributor.
Anther way to check spark is with a spark plug wire light-i use a lisle 19380
wire light-just put the groove area of the tester on the plug wire and it will light if the spark is strong enough.
Sorry, Santa cannot be reached at this time, he is much too busy with the overseeing of the toys and goodies that the elves are making, his cell phone and his blackberry is turned off so he will not be disturbed. His computer keeps crashing because of the emails that he is getting , so it is better just to write an ordinary letter.
Sorry for the inconvenience.
You might want to ask your parents about that. They will have the right answer, not the internet.
the car is garbage the car is garbage
99 Mitsubishi Galant soft chirping sound under hood?
Probably just a worn belt. The 99 Galant upper belt is easily tensioned and the lower belt is not too difficult to replace. A fair shadetree mechanic can replace both in 30 minutes for less than $20.
What is the Spark plug gapping for a 2000 Mitsubishi Galant?
Factory gap is 0.044. Also (and most people will argue this point) stay away from plugs like the Bosch platimun 4 (with 4 fingers) or the 2's. NGK makes a great plug in both copper and platinum, copper is also factory, but I like the platimuns better muself (Bosch makes good plugs too, don't get me wrong, I have all Bosch wiring on my Galant) but stick with the factory gap for best performance. The ECU is calibrated for that specific gap, so don't get suckered into buying some high dollar irridium or platinum non gapped plugs that are suppose to give you a couple extra horses. They are a way of money! My 2000 Galant 2.4L is custom turbocharged and that was the first thing my mechanic did was through out my Boach platinum 4's and told me to get plugs with the factory gap!!!!
Where is your fuel pump relay located on your 2002 Mitsubishi galant?
On the Driver's side of the dash when you open the door you will a panel that says "Fuse Access" pull that off.
You will see 5 relays. 3 going in a vertical line and 2 smaller ones along the bottom.
1 far left on the bottom is fuel pump relay #1
1 in the middle of the bottom is fuel pump relay #2
How can you replace the serpentine belt on a 97 Galant?
Most cars and trucks today have what is called a serpentine belt which runs most accessories.They are very dependable and usually easy to replace. To decide if your belt needs replacing, simply look at the grooved side of the belt to see if it is cracking badly. A couple of cracks every 3 inches is normal, but if you see cracks every 1-2 inches I would recommend that you replace it. On most cars and trucks the procedure is basically the same. First off, get the correct belt by bringing your cars VIN number to the parts store(located on your cars dashboard) the parts store may need it. If there are two choices, get them both so you can complete the repair. Once you have the correct belt, take a minute to review how the belt runs across the pulleys and also check to see if your car/ truck has a underhood diagram of belt routing in case you need it. In most cases you will need a socket wrench or breaker bar with either a 3/8" and /or 1/2" head on it and possibly a short extension. Some models may require a wrench of these similar sizes.Now that you are ready to go to work, you will need to find the spring loaded tensioner which is generally located near the top of the belt path; it usually has a shinny pulley on it. Look at the tensioner and insert the tool into it and apply opposing pressure to release the belt.Now, simply install the new belt making sure it fits into the grooves on all the pulleys. Start the car to check it and you are done and you saved yourelf some money!
Where are the timing marks when installing a new timing belt in a 1993 Mitsubishi pickup?
Before changing any timing belt, it is recommended that you first line up the crankshaft timing and the camshaft timing. To get both aligned, you have to rotate the cranshaft twice. After rotating the crankshaft, align the mark to "0". Take note of any other markings and then you cane begin to disassemble the timing belt. It would be a great help if you can get some cam locking tool to hold the cam in place if you have a DOHC engine
Why wont your 95 Mitsubishi galant not turn over with a new starter battery and ignition switch?
THESTARTING SYSTEM CONSISTS OF THE 1) BATTERY, 2) STARTER MOTOR, 3) SOLENOID, 4) IGN. SWITCH, 5) CIRCUIT PROTECTION AND 6) THE WIRING. IN AUTOMATICS, THERE IS AN INHIBITER SWITCH LOCATED IN HE "PARK-NEUTRAL" SAFETY SWITCH OR "TR SENSOR" (TRANSMISSION RANGE) TO PREVENT STARTING IN GEAR.
CHECK THE STARTER CONNECTIONS-MAKE SURE THE SOLENOID WIRE IS GOOD AND CONNECTED (TIGHTLY). CHECK UNDER THE HOOD IN THE FUSIBLE LINK BOX. THE #1 IS A 30A IGNITION SWITCH FUSIBLE LINK. DURING YOUR WORK ON THE STARTER, IF THE BATTEY WAS NOT DISCONNECTED, YOU MAY HAVE "GROUNDED OUT THE STARTER OR ACCIDENTLY TOUCHED THE BATTERY WIRE TO THE SWITCH LINK AND "BLOWN" THE FUSIBLE LINK.
THE ENGINE NOT "TURNING" OVER MEANS THAT THERE IS A CURRENT "INTERRUPTION" TO THE STARTER MOTOR. REMEMBER HERE-WHEN YOU TURN THE IGN. KEY, A 12V SIGNAL IS SENT TO THE SOLENOID TO ENGAGE AND THEN THE STARTER MOTOR GETS A 12V POWER FROM THE BATTERY TO POWER THE STARTER.. IF YOU FOLLOW THE WIRING IN THE SYSTEM, YOU WILL SEE THAT THERE IS A WIRE OFF THE + SIDE OF THE BATTERY TO THE FUSIBLE LINK BOX THAT GOES TO THE 30A LINK. THE WIRE THAT LEADS FROM THE LINK GOES TO THE STARTER. IF THIS LINK IS BAD, THE STARTER IS DEAD WHEN THE KEY IS TURNED.
Why dont the brake light work on a 2000 Mitsubishi Galant not work even though fuses seem good?
Probably need to replace the bulb.
2002 Mitsubishi Galant where is the tail light fuse and relay?
The 2002 Mitsubishi Gallant tail light fuse is located in the first column of the fuse box. The tail light relay switch is also in the fuse box, at the top of the third column.
Where is the oil dipstick on a 2003 galant?
It is located on the back of the engine to the left (close to your dash). It has a white handled that says "engine" on it.
How do you you open a glove compartment with a broken latch handle on a 2001 Mitsubishi galant?
if you still have the spring intack unlike mine. then get a flat head screw driver. with your right hand insert driver above spring from left side of lock. (your right). now with driver push spring down and it will pop open so becareful. if the spring has fell off good luck. im on the web trying to figure it out now.
Why would a car wobble at low speeds not the car but the steering wheel?
Check the tread on your tyres and if they are worn on only one side your car needs a wheel alignment. I had the same problem with a shaky wheel and after getting new tyres (i needed them) and a wheel alignment the car wheel never shuddered again. I was told I must hit the curb a lot
2000 Mitsubishi Galant the radio says OFF how do you get is to say code?
Leave the key in the "on" position for about an hour.
