Nissan Trucks and SUVs

first take off slave cylinder, it should be mounted on your frame, then take off hoses, connect hoses to new slave cylinder. mount slave cylinder back to frame and bleed ur clutch for f*****g hours.

screw into end of transmission.

Why does your 2001 Nissan Pathfinder heater fan stay on high even after I try to shut it off?"

needle might be cracked

yes

Look on the passenger side behind the battery for a Blue box with two double pin connectors on the bottom

Yes there is from 1986.5 - 1989 pickup and pathfinders if that answer your Question.

have a look at www.crutchfield.com

It's a great site to buy audio gear. Also a great place to gather info.

turn key off.

0.044 thousandths of an inch

I would look for a short somewhere in the wiring Harness.Pick up a book with the wiring diagram and test between that fuse and the end of the like where the wires meet the engine to make sure a wire is not broken or possibly ground out,or bare and touching another wire.

my 97 Nissan was doing the same thing, i found on alot of 97 Nissan trucks the same thing is happing, look at the second valve cover bolt from the fire wall it will be under the wires running beside the valve cover on the left side and it rubs a hole thru the insulation in to the wiring and causes a ground all i did was re wrap the wires with extra electrical tape so it could not rub thru as easy worked great

well this will be about as helpfull as a hole in the head.. using a tappet clamp according to the chiltons manual. But seriously, if you want post your email and i will forward you a scanned copy of the pages and you can go to town...... Stapo22

No. The valve uses an hydraulic lifter that is built in the rocker arm assembly. The whole rocker arm has to be replaced.

Depends on the model and options . If a smaller hard body pickup under the key ignition bottom steering wheel ,it should feel like a push /pull button you push in the center to put them on and pull down to make stop.Good Luck

== == if it's a manual transmission there isn't one????????/

On my '93, it is underneath the air filter. At first, I needed to pull the air cleaner off to get to it, but now that I'm more familiar with it, I can check it more quickly. On my 96 manual trans you have to remove a plug on left side of trans below vehicle. Upper plug is fill lower plug is to drain. Fill till it overflows, then it's correct level. Don't know why manual transmissions never use dipstick??? mystery to me.

Both the signal and 4-way flashers are located behind the plastic lower dash panel aprox under the radio. The lower dash panel must be removed to gain access to the flashers.

If it is the same as the 1993 version, there will be screws/bolts in the back of the bed that you can unscrew/unbolt and u should be able to get at the tail-lights from there.

datsun 520

my truck (nissan pick up) has not halogen, so i have to change the sealed beam. how to do it?

On my '95, I had to remove the grill to gain access to the sealed beams. Then remove the screws holding the retaining ring. (don't take out the adjusting screws!)

Unplug the old bulb, plug in the new one, making sure it is right side up, and put everything back together.

yes

Starter lockout relay, next to the battery.

Tennessee

Under hood, passenger side, front side of shock tower, mounted in fuel line

no the drive shafts are different as the transmissions are,its a no go.