0
Oldsmobile Cutlass
The Oldsmobile Cutlass was a compact/mid-size car produced by General Motors from 1961 to 1999. The Cutlass was one of the most popular nameplates in the vehicle industry during the 1970s.
1,158 Questions
Where is the radiator drain petcock on a 1992 Oldsmobile Cutlass Cierra?
On the back of the radiator, driver side.
Where is the trunk release in a 1996 Oldsmobile ciera?
I haven't seen a truck release for my 96 Ciera. I think you will have to go by the key itself.
if it is a three speed automatic it is probably the TCC solenoid sticking. On the front of the trans (pointing towards radiatoer) there will be a square plug that you can unplug. if that fixes the problem then it is TCC sol. DO NOT DRIVE ON LONG TRIPS UNPLUGED THIS IS TEST ONLY. WILL CAUSE TRANS OVERHEATING AND DAMAGE IF DRIVEN EXTENDED PERIODS . but if it does correct the problem you know what is wrong.
It will NOT cause transmission damage in early 90s or older cars, only when you get into 96-97 and older cars with overdrive transmissions.
So, just look in the front of your transmission, its a 4 wire plug, unhook it and you should be on your way.
Where is the thermostat located on a 96 olds ciera sl 3100?
follow the upper radiator hose , you will see it goes to a alum. piece under the throttle body . you sould also see the temp control sensor aswell in that alum. piece. the thermostat is in there, good luck getting to it . it looks like you have to take off the throttle body and part of the exhaust that goes across there.
How to install a serpentine belt for a 1999 Oldsmobile cutlass?
First, find a diagram of the correct routing around the pulleys for your car. There may be one on a sticker under the hood somewhere; if not you may find one online, or just draw a diagram of the old one before you remove it. On a serpentine belt system, there is one pulley that tensions the belt. Relieve the tension on this pulley, and remove the old belt. Install the new one, carefully following your diagram. Make sure that you get the grooved side of the belt on the ribs of the ribbed pulleys correctly; you don't want it over the edge of the pulley.
Where is is the starter located on a 1992 cutlass cierra Oldsmobile?
6 cyl. ? at the rear lower section of engine 4 cyl. ? at the lower front end of engine behind the radiator
What is the firing order for a Oldsmobile Alero?
4 cylinder engine- 1,4,3,2 6 cylinder engine- 1,6,5,4,3,2
Where is the camshaft sensor located on a 1988 Cutlass Oldsmobile?
engine size would help... normally, on a 3.3 or 3.8 in the front of the block just below the water pump, you'll see a wire coming from the back side and a single bolt with an 8mm head on it holding it in. More than likely if it is a 3.3 or 3.8 engine the magnet on the camshaft sprocket has come off or the timing chain is flopping.
Where is the Oldsmobile flasher?
The turn-signal flasher on my 2001 Olds Intrigue is the same unit as the hazard warning unit. The part number is GM 10401280. you can access to and replace it through the center vent air deflector. You can use a small flat screw driver to open the top clip of the vent deflector to remove the vent. The Hazard Warning Switch Turn Signal Flasher will be visible on the left.
Where is the fuel pump fuse located on a 1992 Oldsmobile cutlass ciera?
the fuse box is in the glove compartment, in a little black box on the left.
What frame will fit your 65 Oldsmobile cutlass?
The frame from ANY GM A-body of the same body type (2-door, 4-door, etc) will bolt right in because they all use the same frames. So a frame from a Chevelle, Tempest/Lemans/GTO, Buick Skylark, or Cutlass will fit. Any frame from 1964-1967 will work. 1968 and later frames won't work because the wheelbase changed in 1968.
Where do you put the transmission fluid in a 1997 Oldsmobile Cutlass?
You add fluid at the same place you check it.
What type of refrigerant is used in 1993 cutlass ciera?
R- 12, gm didnt switch over to 134/a until 1994 model year
Where is the flasher for a 1995 Oldsmobile Cutlass Ciera wagon?
1995 Oldsmobile Cutlass Ciera turn signal flasher is behind the fuse panel. The 4-way flasher is to the right side of the glove box below the horn relay.
Where is the thermostat on a 1998 Oldsmobile Cutlass V6 and how do you change it?
Find it at the engine end of the upper rad hose. When replacing it make sure the spring goes toward the engine. Looking at the engine (1998 olds.. cutlass) while hood is up. on the right hand side. Follow the large radiator hose to the engine. The thermostat is located in the metal housing under the air intake. (attached to the air filter) Not a good spot. No easy access. YOu musst remove part of the air filter system to get to it!
Where is the turn signal flasher located on a 1988 Cutlass Ciera?
FRONT SEATING AREA, DRIVER SIDE, UNDER DASH, MOUNTED ON PASSENGER SIDE OF STEERING COLUMN. First, check the fuse for your turn signals, and the bulbs. If these are ok, then remove the ashtray drawer(remove 4 screws with a 9/32 socket or nut driver. You will see the flasher to the left of the opening. I found that I also had to remove the cover below the dash (6 screws). This allowed me to work with both hands from both sides of the flasher. It is held down by a 2-pronged metal holder, and is easily popped out. You may need a small straight screwdriver to pry the flasher off it's two prongs. Pop the replacement on the two prongs, and insert the flasher back onto it's metal holder. This is difficult to do because of surrounding wires and other electrical items.Replace the under dashboard cover and ashtray drawer.
What size tires can you use on a 1995 Oldsmobile cutlass supreme?
Look inside the driver side door jam is should tell you tire sizes. If you cannot find it, refer to your owners manual.
Where is fuel pump reset switch located on 1998 Oldsmobile Cutlass?
GM cars do not use inertia/reset switches.
