Buick Rendezvous

Bottom left of radiator toward rear. Lay under car, look up in front of left tire toward radiator. Plastic wing nut like plug.

One of the common problems with the vous and Tek is the window regulator clips break. the dealers say you have to replace the whole unit at 160 bucks and not just the broken piece. but you can replace just the clips the the part numbers of the clips are:

Clip - 15286776

Clip - 15286777

there are two clips per window a left and a right side. the dealer price i found was 26 dollars each. you can get them online for 15 but they usually charge a minimum 10 dollar shipping charge which brings it to 25 so watch the shipping charge. my Buick dealer didnt have these in stock but the Chevrolet had plenty so i assume these cover a wider range than jsut Buick and Pontiac. hope this helps clips are very easy to do

When the clips are about to go the window does a few things it clicks when you roll it up or if the window is downa nd you slam the door itll rattle

i have a 2005 BUICK RENDEZVOUS AND MY TRACTION LIGHT IS ON PLUS MY ABS LOCK LIGHT ON THE DATCH BOARD

Code 45---Rich exhaust--- Check the evaporative charcoal canister and its components for the presence of fuel

Remove the large plastic screws around the back, and inside the locked storage area, plus, the ledge at the bottom of the lock (bar) and the small screws on top.

A few things can cause this. Start with the simple and troubleshot your way to the more difficult. CHECK THE FUSES. It could be as simple as a blown fuse. If you find a blown fuse, be sure to replace it with the correct Amperage fuse. MASTER SWITCH IN OFF POSITION. Many cars come with a master switch, or child lock-out switch. This is typically found in reach of the driver, near the driver's window switch. MASTER SWITCH BAD. The master switch could be bad. Check for power to and from the switch. This step also continues on to the last posibility, a wiring problem. Since your question implies all the windows are not functioning. If all the other test prove to be OK, then it is likely a wiring problem. Checking the wiring at the master switch will shed some light on this. Good luck, and hope it's the fuse.

Disconnect the battery, then bend the ends of 2 paper clips about 3/8". Slide them in at the edges of the switch, there's just enough room. Swivel so the bend is behind the switch and pull out. May take a few tries, but it worked.

The BCM is mounted under the Saturn's dash. It is located on the drivers side near the kick panel.

Monetary policy will never be effective if interest rates: not respond to a change in the money supply, and investment spending does not respond to changes in the interest rate.

a tune up will fix that

If plugs and wires do not fix you may want coil tested if still not fixed look at injector

I have asked this question to many stereo installation shops, and the answers have been the same. Most shops are reluctant to accept this type of job. The problem is the upper plastic roof panel has small tabs that hold it in place. Over time, these tabs become brittle and break during removal.

First you will need to remove the rear seat.

Next you will need to remove the upper plastic roof panel (above the rear window), being careful not to break the tabs I mentioned earlier.

You should be able to access the top of the plastic side panels the hold the speakers.

http://www.clubprotege.com/wil/howto/tachometer/index.htm

Yes, you can. Just purchase a seat and the seatbelts from a salvage yard, and there are bolts under the carpet in the back of the vehicle. Good luck!

low on gas maybe

***CAUTION***The halogen bulb contains gas under pressure. The bulb may shatter if the gas envelope is scratched or if the bulb is dropped. Handle the bulb carefully. Grasp the bulb only by its base. Avoid touching the glass envelope. è The headlamp bulb should not be removed from the headlamp until just before a replacement bulb is installed. Removing the bulb for an extended period of time may affect headlamp bulb performance. Contaminants may enter the headlamp where they can settle on the lens and reflector. Never turn on the headlamps with the bulb removed from the headlamp. Headlights Removal & Installation 1. Raise and support the hood. 2. Raise the headlamp retainers by pushing rearward and pulling up. 3. If equipped, rotate the headlamp bulb protective counterclockwise and remove. 4. Disconnect the headlamp bulb electrical connector. 5. Remove the headlamp assembly. 6. Rotate headlamp bulb retainer counterclockwise and remove. 7. Remove the headlamp bulb by pulling it straight out with a gentle up-and-down rocking motion. ***WARNING*** Do not touch the glass bulb with your fingers. Oil from your fingers can severely shorten the life of the bulb. If necessary, wipe off any dirt or oil from the bulb with rubbing alcohol before completing installation. To Install; 8. Install a new bulb into the headlamp assembly. 9. Install the headlamp bulb retainer and turn it clockwise to engage the retaining tabs. 10. Attach the bulb electrical connector. 11. If equipped, install the headlamp bulb protective cover. 12. Install the headlamp assembly. è Be sure the headlamp assembly is positioned correctly with the alignment pins inserted into the proper holes and onto the ribs of the reinforcement. 13. Engage the retainers by gently pushing down. 14. Turn the lights on and check the bulb operation.

They can't be fixed. You have to change the radio. The climate control is the same way, You have to change the unit to get the light working.

good luck you usually end up breaking those off by putting a screw driver in the keyhole and twisting. In order to make a key they need the cylinder and quess where it is?

might be a bad fuel sender unit or BCM

The book states from 2002-2007, the front cv axle nut is a 34mm.

Pry out with tiny screw driver the red refector and the plate around the window switch and take out screws under them. Remove the other visable screws then just forcefully pull the panel off that is held on with plastic expander buttons.

blower fan location on a 1979 lincoln

you have a fuse box under the hood behind the batteryand another located under the dash on the left side of the vehicle access is gained by snapping off the plastic cover. later models also have a small fuse box located behind the glove box. I hope that helps you out.

02-07 will all interchange and fit but i think 04-07 has clear turnsignals and chrome trim and the older has amber lenses and body colored trim to look good youll have to replace both sided

I dont know if they are the same. but my mom has a 2003 Yukon. not a denali. but there should be two levers on the back of the seat labeled 1 and 2. if you pull up on the lever called 1, then you can tip the seat forward. or...fold it down. then pull up on the lever that says 2, then you can lift the seat up. now. once you get the seat up you should see a lever labeled 3. however, this is used for putting the seat back in. there is a bar that runs across the front of the seat on the bottom, about 10 inches from lever 3. if you pull up on that bar you should be able to pull the seat out. then when you are putting it back in, once it locks down in place, you pull up on lever 3 to get the seat to fall. hope this helps.