0
Car Starting Problems
Some of the common car starting problems stem from a discharged battery, a bad fuel pump (or no fuel), a weakened starter motor, or a broken electrical connection. Checking each part will help troubleshoot why the car won’t start.
5,524 Questions
Tapping noise when I start the car?
ck your oil level make sure it is up to the top line........................you have a clasped lifter does it quite down when it gets warm
Your 2006 dodge stratus wont start and just keeps clicking What is wrong?
Sounds like a battery problem. Check the battery. Clean and tighten the battery terminals and cable ends.
Where is the starter on an 86 Chevy Caprice Classic V8 5.0?
Drivers side, bottom of the motor, beside oil pan really close to the front of the transmission. Follow the red (+) wire from the battery and it will lead you to the starter.
Why would a Hyundai Sonata crank a long time but won't start?
I am working on the same problem in a 1999 Elantra Wagon, and have read that it could be the crank sensor. Hope this helps. here are a couple of possiblities: bad crank sensor, broken or jumped timing belt, bad fuel pump, bad cam sensor. Answer was this the only problem or was the transmission not shifting before too?
What can be wrong when there is gas in the oil and the car wont start?
An injector is probably sticking and causing "wash down". Gasoline can then leak past the cylinder walls and get into the oil. That much fuel in the cylinder will make it impossible to start the engine. I'd also check the fuel pressure regulator
Is your motor ruined if you used ether to start your 6.2 diesel engine?
NO unless you use to much in one shot it could bend your push rods (vapor lock) little amounts of ether will not harm it
oh ya one more thing never use ether if you are using the glow plugs
Can not having gas cause a car not to start?
You are correct. If you have no fuel, there is nothing to combust in the internal combustion engine under your hood. If you suspect this is the case, you can use a bit of what is called starting fluid to see if you car will fire and begin to run. Starting fluid is sold in small spary cans at any auto parts store, and it is fairly cheap. You spray a good shot into the air intake and try to start your car. As the starting fluid hits the intake manifold and is taken into the cylinders, the engine will "try to start" but will not run. This is an indication that you have a fuel problem.
What would cause a 1991 Camaro v6 3.1 motor not to start. i replaced the spark plugs and wires?
Well, if everything is in good condition (cables, spark plugs, battery, etc, etc.) it could be the VATS anti theft system. From what I understand, this system is a problem on the later model third gens. Check your instrument panel when you attempt to crank that car. If you see a light come on that says "Security," that's it. What is supposed to happen is when you put your key into the ignition, the circuit is completed with the antitheft system and if the resistance provided by the chip in the key matches the resistance standard in the VATS module, the car is able to crank up. There's a resistor chip built into the key (you can't mistake it). Some people measure the resistance of their chip in the key(there are 15 different resistance values) and wire a little resistor like you can buy from Radio Shack with the same value onto the circuit side of the connector. If it doesnt crank then, you either have the wrong resistor or something else is wrong.
Answeri had the same problem with my 91 camaro v6 i got a new battery,accelerator. and starter it turned out i needed a new cablescould also be the timing on the engine. have the timing checked
Answervague..starting is a common problem with this kind of car. there are three main solutions, and they are easy to diagnose. this could go for any car. if car does not crank, it is the battery. you can recharge the battery with a jump, but you'll need to replace the battery soon. so if that's the case, use another car to jump the maro and limp on over to the nearest auto parts store to get a new battery. if engine cranks, and engine does not even fumble, or misfires so deeply, then this is a sign that theres no ignition, or too much resistance along the way to spark. you can take a multimeter to every wire to check this, from the distributor to elsewhere. if engine turns, and with hard press on accelerator, it catches and then fumbles, its a fuel system problem. replace filter, and if you can run engine with enough hard accel, try to use injector cleaner as instructed. there is the possibility of vaccuum leaks, but this is a problem which tends to build over time and effect all situations of driving.
Could be ignition coil bad.
ANSWER
Ihad the same problem and it turned out that is was a bad fuel pressure regulator and bad injector
check the knock sensor connector just above the starter on the block or the wires on the solenoid on the starter i have the same car as ur's and I've replaced just about everything on it except for the block & rear
Check your fuel filter/ pump. The pump is in the tank.
Why does the starter click but not turn over 97 Plymouth voyger?
there could be wut they call a ''rough spot' in your starter.. it could mean your starter is going bad.. if your tight on cash, give your starter a whack with something heavy then try starting it again. WATCH OUT, ONLY HIT THE STARTER!
Why will your 07 kx250f not start when cold but will start easily after it has been ridden?
i will tell you what me and my friend did we tryed cleaning the carb but didn't work what i rcomend is to find a good hill or if you have a trolly is force start it or just take it to you're local mechanic
What is wrong when the starter wont click?
The battery is dead, the connection is bad, the terminals are corroded, the starter is bad, the solenoid is bad.
Why wont my truck start after it ran out of gas but gas is in it now?
Have you tried checking the fuel pump. i had a friend burn his out after he ran it empty.
The sensor can be checked by the use of an ohm meter on the sensor terminals. Unfortunately I do not have the specific data for this vehicle.
I changed the timing belt on 1998 ford Ranger and now it wont start. I need suggestions?
your timing marks are off.Recheck your marks and if your not sure where they are at check the dealer for a diagram.My 1996 had indents on the back side flange of the oil pump and cam.the crank I lined up with the outer timing cover
Your front wheel make grinding noise while turning?
grinding on front wheel is caused by 2 things. a bad or loose wheel bearing,or worn out brakes, have them both checked You might also want to check the level of fluid in the power steering reservoir - low or lack of fluid will also cause a noise (although more of a whining than a grinding).
This can also be caused by worn or damaged central velocity joints if the vehicle is front wheel or four wheel drive.
Where is the camshaft censor on a rover 75?
it is on the front of the engine, next to the oil filler cap on the v6 2.5l engine. I am not sure where on any other engine.
Where is the voltage regulator located on a engine diagram for a 1987 Pontiac Bonneville?
The regulator won't be shown separately on your Pontiac. Most GM vehicles of that vintage had Alternators with built in regulators.
What causes the car not to start and iginition not to go out?
If the ignition isn't firing then you're looking at an electrical problem: Bad spark plugs, distributor, cables or battery. If you're frequently draining your battery and needing jump starts, the alternator could be failing as well.
IF IS ONE OF THOSE HIGH PITCH SQUEALING SOUNDS IT MAY BE DO TO A FAUTLY/LOOSE BELT. IT USUALLY SOUND WHEN THE CAR IS TURN ON BUT AS IT ROTATES IT PICKS UP SPEED AND IT STOP THE SQUEALING. WELL THE SUN PART COULD BE DUE TO THE HEAT IT DRIES UP YOUR BELT AND CAUSE TO SQUEAL/SLIP. TRY PRESSING ON YOUR BELTS THEY SHOULD'NT MOVE MORE THAN HALF AN INCH.CHECK YOUR MANUAL FOR YOUR SPECS.
Peugeot 106 1993 won't start Turns over fast but the orange engine dash lamp stays on HELP?
my peugeot 106 1993 did this, check petrol pump isn't knackered ive had to replace mine it may not let fuel to the engine
Can a locksmith replace a car key?
In today's world the method above is slightly outdated. The real answer is; it truly depends on what car you have. If you have a newer model (2005 or higher) you may need a professional locksmith to program the chip to the new car key. If you have an older model you will need a locksmith to look up your key code to make you a new car key. You can call your automobile dealership but they will charge you 5X the amount than anyone or anywhere else. If you have a push start, that can be tricky. BMW, Mercedes and luxury cars may have proprietary car keys so you will need to check with a professional to get an exact answer.
Starter cranke but engine does not start 1997ford Explorer?
could be your coil pack / igntion moduel / or fuel pump
