0
Chevy Astro
Chevy Astro is a mid-sized van manufactured by General Motor’s Chevrolet brand (1985-2005) to compete with the Japanese Toyota Van and Plymouth Voyager/Dodge Caravan twins. Aside from the standard passenger vans, the vehicles are also available as cargo vans.
2,448 Questions
How big is the gas tank on a 1983 Gmc 2500 van?
My 1989 and 1978 were both 125 liter tanks. I don't know how much that is in gallons.
Where is the abs sensor on a 2002 astro?
I'm no mechanic, but I believe it's a part of the splash shield. You cannot see it until you remove the tire/wheel and the rotor. traderreg
What type of gear oil is used in a 2003 Chevy duramax gear oil?
If you are asking about the rear differential, It is - SAE 75W90 synthetic gear oil
The front is -SAE 80W90 GL-5 gear oil
How do you remove windshield wipers for replacement on 1995 Chevy Astro van?
Pull the blade in a direction directly up the windshield, toward the back of the van. It pops off. There may be a clip you have to loosen first. Read the directions that come with the new wiper blades, or ask your next door neighbor to help you figure it out.
Chevy Express van stop lights not working?
Check fuse Check bulbs Check stop light switch.
Chevy cargo vans have been notorious for ground wire problems in the rear light assemblies. If unable to trace grounds, install new wire to frame and problem will likely be resolved. Chevy has not to date allowed a recall on this and more than 1/2 of the vans with light problems have had the same grounding issue.
In my case, I found that thin copper straps supplied the ground. They went up the side of soft, plastic bulb sockets & the heat melted the sockets just enolugh to prevent a ground. I added my own standard, braided wires with a soldering iron, to replace the factory copper strips. My new wires go up the outside of the socket. Problem solved & it's worked for several years now.
How do you remove the starter on a 1997 Chevy Astro?
this is very simple ,..well i guess since i work on veh everyday,..but firts you removed the power from your battery positive cable would be preffered,.. then if working on floor would recommend two ceh jack astand for safety lift veh with jack till you easilly get with room under car there will be two bolt 14mm bolted upward loosen does only fore there may be shims at matting faces between blcok and starter loosen and removed battery cable from stater and starter command cable they are bolted to your starter solenoid now back to main bolts removed bolts and hand balance stater out of place,..sorry i did'NT state that there will be 1 13mm nut to main starter cable and a 8mm for starter command cable ,..simple as that !!!!
im not going anywhere. i think im staying home for the evening and maybe tomorrow i might go out for a bit. if i go out, i will check my mail, go to the store to buy groceries and enjoy the rain as it melts all the snow away. where u going?
How do you apply gear oil in 2001 tiburon?
on the front of the transmission there is a fill plug, pump gear oil in till it levels off with the hole for the plug
99 astro van starts then dies in 2 seconds but run on starting fluid?
Remove the engine cover inside the van and locate the distributor. Inside the distributor is a sensor which will activate your fuel pump. Also locate the oil pressure switch which will also give power to the fuel pump. One of these should do it and both are very easy to access and replace from under the inside engine cover.
There were two people credited with inventing Chevrolet cars. These two people were car dealership owner William Durant and racecar driver Louis Chevrolet.
How do you fix a 1995 astro van oil pan?
i want to fix a 1995 astro vans oil pan how do i go about that?
hello! to answer your question, it does not matter where in the backseat a booster seat goes. it could even go in the middle if you like to better keep an eye on your child. hope i helped you, good day!
What is the layout for radiator hoses on a 1990 Chevy Astro van?
one large hose from bottom of radiator to side of water pump. other large hose from thermostat housing to top of radiator. one heater hose from water pump to heater core, I think this one has a Y in it if there is a rear heater other heater hose from heater core to somewhere on top the engine. If there is a rear heater, its return hose goes to a fitting on the radiator.
What do you need to check if your 2004 Chevy Astro van will not start or jump start?
First take the battery cables off and clean BOIH ends. Then make sure there is a good ground between the engine and body--VERY IMPORTANT- Then let the jumper cables stay on for about 1/2 hour before trying to start it. If nothing it could be the starter. It needs to be checked out,./
What should the timing be set at for a 1995 Chevrolet Astro Van?
It should be listed on a sticker near the fan shroud. My 1995 astro is supposed to be set at 0 degrees below top dead center. use a timing light to adjust the distributor accordingly. .
Where to locate the pcv on 199130 aerostar van?
The PCV is on the drivers side valve cover (towards the rear of it). The air cleaner outlet tube from the air filter to the top of the motor may be hiding view of it somewhat, you should be able to reach around it to remove it. If you cannot see it, make sure if you are going by feel where it is that you don't accidentally pull anything else out by mistake.
How do you turn the air bag light on the dash off?
theres a recall on that go to a dealer it should be fixed the air bag can go off at any time
Where is the fuel filter located on a 1994 Chevy Astro Van?
It should be located under the vehicle on the frame on the drivers side just below the drivers door and the fuel door.
How difficult is it to replace a ac compressor on a 96 Tahoe 2wd?
Well the compressor is not hard, I think (without looking at it) it is like 4 bolts, and a couple of connections. The problem is that most good A/C guys will tell you to replace most of the system at once or when you replace the compressor, you will have to replace most of the parts, one after the other, and perhaps eventually replace the compressor again not to far out... From what I understand... the compressor tears parts up inside, and sends them through the lines to the other parts, eventually eating each of them up.
Where are the oxygen sensors located on a 1996 Chevy Astro?
Up under the car look at the exhaust pipe. Starting from the engine, follow the exhaust pipe toward the rear of the vehicle, there will be a wire plugged in to a sensor in the pipe, before the catalytic converter, and another wire plugged in to another sensor in the pipe, AFTER the catalytic converter.
How do you remove a passenger side door handle to replace it on a 2003 f-150?
Remove inner door panel for acess
How do you keep sliding door from falling off its track of 90 astro van?
I presume you mean the outside track. Most likely, due to the year of your vehicle, your roller bearings are worn out to the point of no longer being able to stay in the track. Get a new set of bearings. Remove the trim covers inside the van where the track runs outside. Remove the right tail light assymbly and the rubber plug you will find behind the tail light. Remove the bolt under the rubber cap. Remove the bolts to the track cover found under the inside trim panels. Remove the bolt at the door latch area that holds the track cover. Remove the track cover, do not force it, just find the bolt you missed.
There are a couple of ways to proceed. I reccommend removing the circlip and driving out the pin that holds the bearing assymbly to the sliding door. Replace the worn bearings and lubricate as needed. Take the bearing assymbly to the rear of the vehicle at the track end and insert the bearing assymbly into the track and run it along the track to the door, then pin it back into the door (a helper, a jack, or any type of door support is useful here). Slide the door along the track to detect ease of operation or other problems. Reinstall track cover, tail light, and interior trim panels.
FYI, some of the interior bolts and the roller assymbly pin are difficult to get to but not impossible. Plug any hole an interior bolt could fall into during removal and installation, have a wobble extension, a magnetic part retriever, spare circlips, and/or spare bolts handy. You might want to use a hole cutter to get to one of the interior bolts.
