0
Chevy Impala
Launched in 1958, Chevy Impala is a full-size vehicle built by General Motor’s Chevrolet division. It is Chevrolet’s most expensive vehicle and US best selling automobile through 1965. It is distinguished by its triple symmetrical taillights.
4,997 Questions
Where is the neutral safety switch located on a 1966 Impala?
On a column shift it is on the upper side of the column. Look up from floor beneath the dash.
On a console SS it is often located on the drivers side of the transmission just behind the engine oil filter. You will see a shifter rod connected to itz
How do you fix dim headlights on 2002 impala?
i have two problems my dim headlights will not come on.and when go to put in gas it will flow back word make it seem like the car is full.
Where is fuse located for a 2006 impala?
Which one-there is more than 1 fuse box also=locations in owner's manual
How do you change a head light on a 2000 impala?
See Headlamps on page 6-34 of your "Owner's Manual", under Section 6: Service and Appearance Care - Bulb Replacement...
How do you change the clock on your 2000 impala?
To "change" the clock you need to "change" the radio.....
To "change" the time, see Setting the Clock on page 3-9 of your "Owner's Manual", under Section 3: Comfort Controls and Audio Systems.....
What would cause a 2005 impala to run hot even after the thermostat has been changed?
check to see if the lower spoiler, the one that always hit the curb in the front when you pull up to close to a parking block they are cheep from a dealer and eeasy to replace, if gone car will run hot
What causes the AC switch to turn on only on the five setting on a 2002 Chevy Impala?
If you are referring to the blower motor speed control, and you only have one speed, then the blower motor resistor pack is defective and must be replaced.
Removing rear speakers: We only need the amp circuit boards to rebuild them. You can pull the boards out of the black plastic box from the trunk side. There is 3 deep holes in the box and they have Phillips screws in them. Remove these 3 screws and pull that lid off. Then there are 2 screws that hold the circuit board in and as long as there is a plug for the 6 wires that go into the board, then just unplug it and it can be sent for rear speaker rebuild. If there is no plug, then the whole assembly will have to be taken out from the top. See direction for taking out the back seat below. 89-90 Maxima rear speakers
On some of these, if there isn't a plug to unplug the circuit board from the rear speaker, then the rear seat has to be moved in order to pull speakers out. The plug makes the job simple, if no plug then it's not so easy and you may want to consider having a mechanic remove them. In order to access the rear speakers, you must first remove the backrest of the rear seat. There are 2 10mm bolts on driver side and passenger side, in the crack of the seat, that hold each bottom corner of the backrest down. Once removed, you can pull out and push up on the backrest to slide off hooks along top rear of backrest. Once that's out of your way, there are 2 plastic screws and screw holders that hold the brake light in place, remove the brake light and it unplugs. Also remove the metal bracket that held the light. Along the rear window on the inside, the plastic long pieces will snap up and off with a regular screwdriver. The whole panel now that holds the speaker grills will snap up, look from the trunk, you can see the large plastic snaps (green) that stick out by the speaker, you can help them unsnap from the bottom by squeezing them with needle nose. Move the whole piece to get to the 2 speakers, each has 3 gold nuts to loosen to remove from below.
The clicking sound is your a/c unit trying to engage. I would have freon pressure checked first, if not, a/c unit may be bad
How many quarts of oil does a 2007 Impala hold?
With oil filter change. V6 engine: 4.0 u.s. quarts (3.8 liters); V8 engine: 6.0 u.s. quarts (5.7 liters)...
Where is PCV valve on 2005 Chevy z71?
It is on the left side of engine, but stuck in the intake manifold.
That is you standing in the front of engine.
To unlock a gear shift, typically found in vehicles, you may need to press the brake pedal while simultaneously pressing a release button or lever located near the gear shift. In some cars, you might also need to turn the ignition to the 'on' position without starting the engine. If the vehicle is in park mode, it should allow you to shift gears freely. Always refer to your vehicle's owner manual for specific instructions.
My 2002 Impala was doing the same thing. I took it in and they said it was code C1225. Traced to broken LF ABS Speed Sensor Harness. They replaced the harness and charged $231.88 at a dealership.
What is the maximum speed that can be achieved with a factory Chevy Impala SS?
The top speed of a Chevy Impala SS is a little vague. It was once used at a race car in the 60's, but is also being currently made and not sure which car is being referred to. The overall top speed from the 60's remains unknown as many NASCAR drivers had to modify and fit the engines themselves.
Where is the AC recharge valve on a 2001 Chevy Impala 3.4L V6?
The AC recharge valve on a 2001 Chevy Impala 3.4L V6 is near the firewall. It is the larger of the two tubing.
What could cause a knocking noise in the engine?
Knocking is caused by preignition, where the heat in the cylinder causes the gas to ignite before the spark plug does. The noise could also be piston slap, which is caused by a worn cylinder wall. Try using a higher octane/grade gas and see if the noise goes away.
In certain engines like the Malibu 3.1 liter and others, the knocking is caused by a piston rocking in the cylinder. This is called piston slap. It is a damaging condition, but seems to be considered "normal" by GM.
Does a 96 Chevy Impala SS use synthetic oil?
You can use synthetic oil in any engine.
There is a caveat: if there is quite a bit of sludge build-up, the synthetic oil is likely to soften and release the sludge and it could cause problems.
Understand that the primary difference between natural and synthetic oil is that synthetic oil has essentially no paraffin. As oil ages in the engine the paraffin separates and sticks to the non-moving parts. Since synthetic oil has no paraffin, deposited paraffin will slowly dissolve in the synthetic oil and it's possible for large "chunks" of paraffin to float around in the oil and plug the oil pump pickup screen.
Answerevry car has the abilty to take synth. but no car comes with ti from the factory. especially American cars. mb BMW etc the high models are equipped with hence why u pay 5million for an oil change. now on the other side me personally every car i owned ive switched from conventional to synth. now a car like your most def swith it your motor wold benefit from it greatly more power mpg and it will add more life to your engine meaning it will go further have fun just a recommendation castrol is the best. if your a car nut like me then spend a little money and go with lucas. that's what i use. lucas comes wit a warranty that if your motor blow due lubrication that and whatever broke will be replaced no hassle no question and it also does not have to be proven. if you want to improve power etc email me jamel8222@aim .comWhat is the capacity of the gas tank for a 2002 Chevy Impala?
! have a 2002 Impala LS. The owners manual states 18 gallon. (From wandc.)
this has to do with the sensor in the wheel bearing, unfortunatly the sensor and wheel bearing are one unit. first you have to find out which wheel bearing it is and then replace it, these can be expensive. I've had to replace both of mine within months of each other. take it to get a diagnostic done they can tell you which bearing it is.hope this helps
Where is the VSS speed sensor located at on a 04 Impala?
The VSS speed sensor in an 04 Impala is located on the transmission case or the rear axle of the vehicle. However, on some Impala's it can be located inside the ABS system.
