0
Chevy Impala
Launched in 1958, Chevy Impala is a full-size vehicle built by General Motor’s Chevrolet division. It is Chevrolet’s most expensive vehicle and US best selling automobile through 1965. It is distinguished by its triple symmetrical taillights.
4,997 Questions
What amp fuse is required for the heater fan on a 1978 Chevrolet Impala?
It requires a 30 amp fuse.jd
What does code P0442 on a Chevy Impala mean?
Evap emission control leak. This could be as simple as a loose or bad fuel cap. Unless you find the fuel cap loose, I would start with replacing the fuel cap.
"Stear" isn't a word, but "steer" in this sense would be to guide the course of a vehicle.. not sure why this is even on here.
Where is the headlamp fuse on a 2004 Impala?
The headlamp fuse on a 2004 Chevy Impala is located in the main fuse panel under the dash. It prevents the headlamp from drawing too much power or being damaged by a surge.
How do you turn off the low tire pressure sensing system on a 2003 Ford Expedition?
All you need is an old transmission pan magnet (the round type with the hole in the middle) that will fit over the valve stems. Here is what you do.
First, you will need to cycle the ignition from the off position to the run position three times, ending in the run position the third time. Press and release the brake pedal, then turn the key off. Cycle the key three more times, once again ending in the on position the third time. The horn should sound briefly 1 time, and vehicles equipped with the message center will read "trian left front tire". Take your round magnet and place it over the valve stem of the left (drivers side) front tire (with the stem sticking through the hole in the center) and keep it there until the horn sounds briefly. Move to the right front tire and do the same thing, then right rear, then left rear. Once you've done that, the message center should display "tire training mode complete". Turn the key off and you're all done! I'm not sure if this works on all new Fords, but im pretty sure it works up to at least 2005. everyone out! If you have any questions just reply to this post and I'll do my best to help ya!
check the level of the reservoir and the radiator
if both are filled to factory specs and check coolant message still appears
try removing battery for 5 minutes and reconnecting
AnswerTake your car to your mechanic to make sure the intake cover gasket is not leaking. Impalas with the 3.4 are notorious for leaks. The mechanic will install a new gasket with GM approved sealant and you'll be all set. It'll set you back at least 600 bucks unless your still under warranty. Answerit might be the coolant level module. go to www.impalahq.com and click on the how to link. it gives a good description how to replace it. AnswerYou may have a busted intake gasket, causing oil to leak into the radiator fluid, and vice versa. I'd take it to a good shop and let them take a look. Happened to my 2000 Impala. You'll have to get a oil change and coolant flush, along with seal replacement. AnswerMy problem was a bad coolant level sensor. The dealer wants $58 for a new one so I tried to fix the old one. By soaking the sensor in vinegar, it worked again for about a week. The sensor is very hard to remove without taking out the battery first (which is also very hard to remove).In the process of flushing out the coolant system, I removed the coolant reservoir which was coated with gooey deposits that would not wash off with detergent. I found that paint thinner quickly dissolved the deposits so I decided to try cleaning the coolant level sensor with the paint thinner also. So far, the sensor is working again so it appears that coolant sludge on the sensor was causing the problem. By the way, before cleaning the sensor, remove the 2 o-rings first because the paint thinner will ruin them. Also wash off any traces of paint thinner before reinstalling the reservoir or the sensor.
How do you turn off the low tire pressure sign in the message center on a 2001 Chevy Impala?
I drive a 2002 Chev impala for a living, and what you have to do is turn off the radio, push and hold "Disp" (the bottom button encased in the tuner knob), until settings comes up on the display. use your seek buttons (located to the left of the "1" button) to select the setting you wish to reset, then push "display" once again, to show "reset", push it once more, and "done" will appear on your display. You so the same for oil life, auto-locks, etc. once finished, you seek to "exit", push display, and you're back to normal playing mode. Hope this helps. we took ours to dearler ship they said they replaced somthing and it was fixed well 2 mths later it came back on it just so happened i had to replace my battery at same time when i did it went off now when i have tires balaced or it comes back on i dissconnect battery it works there is suppose to be a way to clear it through the radio but its not there hope this works for u too Mitch
Where is the blower motor resistor on a 2001 impala?
It's located up inside of the blower motor housing under the dashboard. I also have included a link to a video that will show you how to get to the resistor and also the tools that you will need for the job.
How come pasenger headlight are dim a 2001 Chevy Impala?
If the passenger side headlight on a 2001 Chevy Impala is dim, it may be time to change the bulb, or there is a problem with the wiring on that side.
What is the gas mileage rating for the 2007 Chevrolet Impala?
3.5L: 21 city/31 highway; 3.9L: 20/29; 5.3: 18/27.....
How do you replace the engine air filter in a 2001 impala?
See *Engine Air Cleaner/Filter* on page 6-19 of your "Owner's Manual", under Section 6: Service and Appearance Care.....
Ticking noise coming from engine on 2000 Chevy impala?
Collapsed hydraulic lifter? - try a quart of mystery oil
car has relay. It has ignition power on one leg, 12 v always on one leg , and one leg grounds thru ecm. You also have a temp switch on intake that closes circuit
@ 228 to engage fan also both fans should run with a/s on
Where is PCV valve location for a 2000 1500 Chevy?
It will be on the back top of the drivers side valve cover.
Where is the map sensor located at in 2004 Chevy impala 3.8l?
Twist the neck of oil fill tube and remove it (the oil fill cap can remain attached). This will allow you to remove the plastic splash cover from the top of the engine, just lift front. You'll see a fuel rail from left to right in the middle in the intake manifold area. The map sensor is on the left side of the fuel rail. If you Google for the MAP Sensor at auto parts stores you'll see a picture of one to show you just what you're looking for. Good luck.
The "SS.Skuzzy" really did exist a verry long time ago. The "SSSkuzzy."was built by Andrew Onderdonk in 1882 to clear caraboo road from the carts that were pulled by oxen to bring supplies to build the railroad across Canada.The SS.Skuzzy was built to take supplies to the site that the railroad was beeing built the only way to get the"SS.Skuzzy" through hells gate was to get the chiniese workers to pull the boat through. :)
How do you get the wiper arms down on a 2002 Impala if they stay up when the motor is turned off?
I have the same problem with the same car. I'll let you know if I get an answer if you'll do the same.
eelpie@insight.rr.com
Where is the temperature sending unit on a 2001 Impala with a 3800 V6?
the temperature sending unit is right under the throtle body .
What is the wattage of the factory stereo amplifier on a 2002 Chevy Impala?
I have a 2002 demo model, and its 60 watts per channel. peak power not rms.
Do you need a special tool to remove the door panel on a 1999 Oldsmobile Alero?
You do not need any special tools. The first think I did was to remove the tweeter speaker from the upper inside part of the door closest to your dash. I did this by carefully using a screw driver wrapped in electricians tape to pry it off. The clips will release with enough pressure. Same thing goes for lock/unlock button. Then look to where the handle is to pull your door closed. There should be a very small rectangular panel that can be pryed off revealing two Philips screwss remove and then pry the house the screws were holding. This will allow you to remove the panel that controls each window. After doing that all you have to do is gently pry the door panel away from the door working from the bottom to the top. Do this on both left and right side of door and then lift upwards and it should come off.
AnswerYou do not need any special tools. The first think I did was to remove the tweeter speaker from the upper inside part of the door closest to your dash. I did this by carefully using a screw driver wrapped in electricians tape to pry it off. The clips will release with enough pressure. Same thing goes for lock/unlock button. Then look to where the handle is to pull your door closed. There should be a very small rectangular panel that can be pryed off revealing two Philips screwss remove and then pry the house the screws were holding. This will allow you to remove the panel that controls each window. After doing that all you have to do is gently pry the door panel away from the door working from the bottom to the top. Do this on both left and right side of door and then lift upwards and it should come off.How do you change the thermostat on a 2005 Chevrolet Impala?
Drain the radiator in a container. Remove the engine end of the top radiator hose. The housing has 2 bolts that you remove. Remove the thermostat and clean the surfaces and reinstall the thermostat. Reinstall the hose and add coolant.
