answersLogoWhite

0

🚗

Chevy Impala

Launched in 1958, Chevy Impala is a full-size vehicle built by General Motor’s Chevrolet division. It is Chevrolet’s most expensive vehicle and US best selling automobile through 1965. It is distinguished by its triple symmetrical taillights.

4,997 Questions

How many quarts of oil in a 2007 impala?

V6 Engine: 4.0 u.s. quarts (3.8 liters); V8 Engine: 6.0 u.s. quarts (5.7 liters). * As per Capacities and Specifications on page 405 of your "Owner's Manual" *

How do you replace a fuel level sensor in a 2000 dodge ram 1500 with a 5.9 liter v-8?

remove fuel tank after draining. remove all lines hoses and wires from top of tank. remove fuel pump assembly by turning large plactic nut counterclockwise. disconnect wires inside pump assembly. slide senor and float from fuel pump assembly.

How do you change the back spark plugs on a 2002 Chevrolet Impala?

Answer

you need to remove the "dog bones" or top mounts on the engine. then pry the engine forward about 4" There is a special tool for tilting the engine made by Lisle corp. called a GM engine tilt tool about $40. Not sure if you need to loosen or disconnect the trann mounts

Tool not needed. After the top motor mounts are removed with car in neutral use a ratchet strap. Hook it on the bar over the alternator and in the main beam running across the front of the car. Also remove the bar in front of the window underneath the hood that runs between the top of fenders. When pulling the wires from the plugs don't pull on the rubber that goes over the plug, instead grip the plug wire heat-shield with a short pair of needle nose pliers and pull.

How do you replace the stereo on a 1999 f150?

There are two small holes on each side of the radio.Go to Wal-mart or Best buy and buy two "u" shaped keys (one for each side) they are no more than 5 dollars. Insert the tips into the holes and push them in until they stop,pull the keys(left to the left and right to the right) and pull straight out.If you install a aftermarket stereo you'll need a installation kit and harness adapter. You can get the keys,installation kit and harness for 25 dollars or less. The whole job should take no longer than a half hour.

What does an impala body control module do?

I know one thing it does. My air conditioner wouldn't come on. The replacement of the module fixed the problem but now the radio is locked. The dash indicator light that said a door was open when it was not is now working properly. Seems to control quite a bit of the car.

How do you fix a security message on a 2005 Chevy Impala?

Well i have a 2001 cheverolet malibu.....my wife's car. If you dont have access to your manual the first thing to do is get car in a position that is flat in nature. Then turn your key just to the on position(not starting engine) Then just sit and wait for approx. 15 minutes or so the security light will flash a couple of times. Then you turn the key off and then start your engine......Face toward Mecca and pray.....LOL this should do the trick if not. You may want to think about taking it to shop.

I just bought a 05 impala..and paid to have low tires light go off..u just hold the radio button until the radio says security..then scroll by radio power button to what option u r lookin to fix and reset it..the first button u push is the tune button..sorry and with car running..and exit when done

How do I Change Fog lamps on 2002 Oldsmobile intrigue?

The lamp is in a socket that plugs in behind the reflector/bezel assembly. A couple bolts hold each assembly in place. You may be able to reach the lamp socket and twist it out without removing the whole assembly from under the car. Be careful to not push too hard, the reflector housing is all plastic.

Where is the airbag module found on a 2002 Chevrolet Impala LS?

It is in the steering wheel and the passenger side dash. EXTREME CARE should always be used when working on airbags as they are very dangerous.

Air bags and restraint systems should be left to the dealership or a repair shop.

How do you replace the passenger compartment air filter on a 2007 Impala?

See *Passenger Compartment Air Filter* on page 171 of your "Owner's Manual", under Section 3: Instrument Panel - Climate Controls, for replacement.....

What could cause that the cruise control switch doesn't work in your 02 impala?

most cruise control problems are caused by a leaking vaccum canister that controls the throttle on the cruise, your switch is probably fine.

How do you remove the DashBoard on a 1999 Mazda Protege So that you can install your new dash?

First remove the two screws in the plastic cover surrounding the gauges. This piece snaps out, be gentle!! Then remove the 2 screws at the base of the gauges, also there is 1 screw at the top of the gauges. Then pull the gauges out, disconnect the three wiring harnesses. Thats it. simmpler then it sounds. Good luck

How do you remove the rear speakers on a Mitsubishi Eclipse?

There are large plastic panels that form the sides of the rear seat passenger area. Take those off by pulling the "pins" from the top. There is a screw holding the bottom down under the rear seat, which comes off by pushing the lower front of the seat backwards about 1". You'll feel a black clip where you should push - located where the back of the shins of a seated passenger would be. You will probably need to replace the "pins", as they don't seem to last long. Once the plastic panel is off, unscrew the speakers themselves, rather than the larger black metal "bass box" they are housed in. Disconnect the two wires when they are a few inches free of the box.

How do you replace wiper crank arm for 2005 Chevy impala?

if your wipers shut off in the upright pos it is wiper tranmission i have one

603.485.3150 tHE PASSENGER SIDE DOES NOT WORK. tHE DRIVER SIDE IS FINE

How do you replace the front parking light bulb on 2001 Impala?

See your "Owner's Manual" under Service and Appearance Care - Bulb Replacement...

How do you remove the spark plug wires on 2000 Chevrolet impala?

I just got done doing my wifes 2003 Impala. I removed the brace which runs from the pass. side to the drivers side. did not have to remove the upper motor mounts. I had a heck of a time removing the spark plug wire,so I broke the old spark plug off by using a 3/8" extention with a crows foot attached [this let the crows foot to go back toward the head ]. I simplely broke the end of the spark plug off with the plug wire still in place, then I removed the plug from the cylinder head. The heat shield slides off the spark plug boot for easy removal of the top end of the spark plug.This saved me a lot of time. only took 45 min. to change the back 3 plugs. I learned this the hard way the first time around. Hope that this helps.