Chrysler

Disconnect the electrical connector, then unscrew the sensor. Installation is the reverse.

If you open the drivers side door, there should be information on the side of the door that would touch the car frame one of the things it lists is tire pressure.

No

No

If your check engine light is on replace your camshaft sensor if your check engine light isn't on it could mean theres a fuel problem you may have a clogged injector or a fuel pump going bad

between the front seats there is a plastic plug in the floor,remove it then using the jack handle turn the nut counter clockwise until the tire can be pulled out from under the van. follow the instructions in the owners manual.

Never heard of anyone wanting to do this. Safe? I suppose it is safe but the engine will have a very bad miss and sound horrible. Why would you want to do this?

Your gs mileage will suffer greatly and a bad plug is easy to change when you know which one it is, CheckSpark easily identifies bad plugs in seconds, no pulling wires or plugs until you have found the bad one. You get them on e-bay.

.o17 is about right

DTC P0340 is a camshaft position sensor or circuit problem.

They often stick, with emergency brake OFF, vehicle jacked and blocked, use s small block off 2x4 against inside rim of drum, hit it with a heay hammer, rotate drum and keep hitting on opposite sides.

Disconnect the battery, remove the spark plug wires and boots, and remove the old spark plugs. Toss out the old spark plugs, put in the new spark plugs, replace the spark plug wires and boots, and connect the battery.

It's located under the car, right below the trunk/cargo area. There should be a hole in the middle of the rear cargo area where you attach the lug wrench and turn to the left. Keep cranking it until the spare tire reached the ground. It's in the owner's manual.

There are no factory installed grease fittings on a 2014 Chrysler Town and Country.

Radio memory, interior lights, memory seat functions,

Radio memory, interior lights, memory seat functions,

Check the coolant level, the cooling system hoses and the radiator, if it's fine you need to check the thermostat.

Th horn is located behind the passenger front bumper, near the fog light.

Heat went out in my 300, what could be the problem

With abs DOT 4 and without abs DOT 3 brake fluid.

They often stick, with emergency brake OFF, vehicle jacked and blocked, hold a small block of 2x4 against inside rim of drum, hit it with a heavy hammer, rotate drum and keep hitting on opposite sides.

on the front of the engine at the bottom near the oil filter.

No arms it uses struts.

No, speakers do not have a fuse. But if hooked up to an amp, there should be a fuse somewhere on the power wire connecting to your battery. If no amp, check radio fuse. If no sound but the stereo comes on it might be that your speaker wires are'nt hooked up correctly.

I was offered $400 for my 79 Chrysler 6 hp. Only paid $500 for it 20 years ago.

You can purchase the sub frame bushings on line for about $40.00 each. You will need 4. The job itself takes about an hour at your local mechanic.

Then you will need an alignment. It's about $100.00.

1. Remove the lining on the side by removing the plastic pins.

2. Use a flat head screw driver to slide underneath the pin tops to pry out.

3. One pin near the trunk opening covers a fixed screw and needs to be pulled off.

4. After removing the side lining in the trunk, you can access the rear lights.

5. Twist the plastic housing and pull out the bulb.

6. Insert new bulb.

7. Be patient when reinstalling the lining.

No ccd communucations from bcm or tcm. You have a computer communication issue where the engine computer is not getting information from the body or transmission.