Computer Hardware

Final Media Player, (supposedly), does not contain viruses, however some anti-virus programs will tag it as undesirable because it offers potentially unwanted software during installation in a manner similar to Open Candy's methods.

A version downloaded directly from the Final Media Player web-site at www.finalmediaplayer.com on May 18th, 2014 was scanned and passed as "OK" by the Avira Anti-Virus Professional 2014 installed on my machine. However, earlier versions of Final Media Player were tagged as Potentially Unwanted Program(s)

I both use, and recommend, VideoLAN's excellent VLC Media Player. It's totally Open Source, licensed under the Free Software Foundation's GPL-2, and contains absolutely no nonsense, adware, slimeware, or other nasties.

MA or mA on a multimeter designates milliamps, or "thousandths" of an amp of current flow.

The switch causes the CPU to start back at the beginning of its instructions as if it had just been turned on. This can take it out of a condition where it is stuck in an endless loop. Reset is good when your computer is frozen and there is nothing you can do. When you reset the computer, it re-sets the functioning , i.e. the computer starts as if its being started again. There may be some data loss if the data you were working on was not saved by the operating system / user. In addition, it may cause some file system corruption on the hard drive.

The key about losing data, though is that only data since the last save will be lost. As the system will reset, anything that was stored in RAM will be erased. Thus all recent changes will be lost. It does not mess your computer up, but causes the CPU to start back at the beginning of its instructions.

(Technically, the RAM is not erased on Reset. In fact, all "Reset" does is indeed re-set the instruction pointer. The RAM stays as is until overwritten by other data (thus enabling an attack on its content if anyone were so inclined).)

The danger is that most modern filesystems (starting with MS-DOS 4.01 in 1988) cache data intended to be written to the hard drive. This makes file IO transfer faster, as the cache resides in memory. The computer updates the cache in RAM, and then transfers cache data to the hard drive at a later time. When the system is "hard-booted" by power loss or triggering the reset button, the data in the cache is lost. This can cause file corruption and data loss as the files may be on the hard drive in a semi-updated state.

Modern filesystems (ext3, NTFS, Rieser fs) journal data on the hard drive. This slows data writes slightly, but it prevents semi-update file corruption -- the journaling system updates files "atomically" in an all-or-nothing way.

Using the reset button can often fix many problems, but not all. Some settings in the hardware will not get reset by using the reset switch. A hung floppy drive or hung sound card may continue to be hung after a reset. Only completely powering down the computer and restarting it will reset all devices back to their initial state. If using the reset button does not work, then try powering down the computer and turning it back on again.

On the first computers, without an operating system, every program needed the full hardware specification to run correctly and perform standard tasks, and its own drivers for peripheral-2like printers and card-readers. Not every computer had an operating system.

banks and engineering firms

You will have to upgrade to a more recent video card so it will support the graphic inhancment option of pixel shadeing 1.0 or 2.0 better looking crisper graphics

On a military map it can stand for Secondary Surveillance Radar, Surface Search Radar, Search & Rescue Region, or Soviet Socialist Republic.

Microdrive is a miniature 1" hard disk designed to fit in a CompactFlash (CF) Type II slot. In 2008 Hitachi and Seagate released 8GB versions. (See Wikipedia, "Microdrive")

WHO IS THE NON-CARIBBEAN SCIENTIST a non-Caribbean scientists

In ASCII encoding, if that's what you mean by "bits": 110110011011111110110110010100100000111100111011111110101 That's "love you", in ASCII.

The two common designs for a desktop computer are tower desktops and table desktops. Choice between these depends on work area space availability.

1.Efficiency is high compared to linear power suplies

2.ripple voltage is very low 20mv.

3.constant regulating voltage is the one of the advantage of smps.

It depends on what you want to do. First question I'd ask is what was the frequency of the electricity in Malaysia? In the U.S., it's 60 hz. Malaysia? Assuming the voltage in Malaysia is 250 volts and it America, it's 120 volts, the output from the adapter will be just less than 1/2 of what you'd have in Malaysia. If it's for a battery charger of some type, I'd just try to get another adapter for use the States, as they're not all that expensive. On the other hand, if it's for some other type of electronic equipment, but equipment that isn't `frequency sensitive` (50 hz. as compared to 60 hz.)you could use a `step-up` transformer, which would convert the voltage from 120 to 240, which is probably close enough. Just be sure that the output is of high enough amperage to meet the needs of the equipment. The transformers could be obtained from a general electrical supplier because the chances of finding one at an electronics store is very unlikely.

On my '93, there is no consumer serviceable port. I think the recharge has to be done by a technician.

When the computer and system detects a new device attached, an inquiry signal is sent to device requesting ID information. The Plug and Play compatible device responds with its identification code. The system searches for an ID in its device tables that matches the response. if a match is found it loads drivers for that device, tries to perform automatic configuration for the device and make it available for the software applications. If there is no matching device available, depending on the system and version in use, it may display available drivers and ask which to use or it may ask to search the internet or a manufacturers site for drivers or it may ask for the location of drivers on the system or it may declare the device not available.

The term "random access" is not normally applied to machines. It is normally used to refer to a form of data storage in which data on any part of the medium can be accessed in constant time.

That depends. If they're computer speakers and all your wires are headphone-jack style, then all you do is run the headphone wire from your speakers and plug it into your computer speaker input on the sound card, or a headphone jack. If they're not computer speakers and you want to wire component speakers through your computer, you'll need a receiver to power them, speaker wire to go from your speakers to the receiver, and a cable to go from your receiver "input jack" to your computer. That cable should have a red and white RCA on one end, and a headpone jack on the other.

This is the process of entering data and programs in to the computer system. You should know that computer is an electronic machine like any other machine which takes as inputs raw data and performs some processing giving out processed data. Therefore, the input unit takes data from us to the computer in an organized manner for processing.

Chat room

The function of the mainframe is to hold all the components and subsystems that make up a large computer.

Operating System.

With illustrative example explain how Operating System Programming Language Hardware support the Computer Graphics?

yes it will do even better because a quad processor that is 2.33 ghz means that it has 4 processors and that each one is 2.33 ghz... therefore by doing 4 x 2.33 you get a resulting answer of 9.32 ghz. So yes the quad core processor will run the game and in fact it will run it very well... by the way i have a 2.5 ghz quad core processor. yes it will do even better because a quad processor that is 2.33 ghz means that it has 4 processors and that each one is 2.33 ghz... therefore by doing 4 x 2.33 you get a resulting answer of 9.32 ghz. So yes the quad core processor will run the game and in fact it will run it very well... by the way i have a 2.5 ghz quad core processor.

just connect the digi cam to the PC thru data cable. Wait for some time after connecting. Then luk in My Computer . U will see one extra icon ( may be local drive (i) ). Open it and you can access the digi cam.