0
Dodge Durango
The Dodge Durango was a full size SUV (sport utility vehicle) manufactured by Chrysler for the Dodge brand. Produced in the company’s assembly plant in Newark, Delaware, this 8-passenger vehicle was initially powered by a 5.9 liter Magnum V8 engine.
3,297 Questions
What would cause a fault in the ABS system in a 1998 Dodge Durango?
The speed sensor is the last thing i would replace outta the three. You have to replace your front hubs. they are easily done. Three bolts and a hammer to pop the old bearing out. The new hubs come with a new abs sensor. they are roughly $150-$200. I recently did mine and was finished both in an hr and half. The book calls for 2.5hrs.
Can the four wheel drive be changed while moving?
On my 1995 I can change from two wheel drive to 4x4 automatic/or back to two wheel drive when I'm moving. Ford warns not to switch to 4x4 auto when your back wheels are slipping. If I want to use 4x4 low, I have to come to a complete stop, hold my foot on the brake pedal, shift to neutral, then select 4x4 low and then put automatic transmission back in gear.
How much should you ask for your 98 V8 Durango with 180000 miles?
According top Kelley Blue Book (KBB.COM), in good condition with a 5.2l (318 CuI) V8 engine and all the standard options, in a location in the midwest, the price to list it for a private sale would be $3245.00. The trade in value at a dealer would be considerably less.
Why is there a clicking noise in the glove box area on a 98 bravada?
does it happen when you use your turn signal? if so, that's the turn signal relay. that's completely normal.
There are 4 relays in the glove box of my 97 bravada
I'm posting and answering this question because it took *forever* to find an online source with the repair to this common problem!
At the base of the 2000 Ford Focus air filter housing, there are four circular "nuts" which the corner bolts thread through to tighten down the top. It seems these can come loose from the plastic "sleeve" which held them secure from the factory -- when that happens, they just spin when you try to remove the bolts and change the air filter. There is very little room around the box to get at the bottom and hold onto them as they spin, and they aren't true nuts with a hex edge so it's very hard to get a grip on them. My first thought was to remove the battery which would allow more access to the front two, but the fuse box is up against the back two so that wouldn't do much good.
Here's the fix... Remove the hose clamp at the top and wiggle the air hose off. There is also a small sensor that just clips onto the top of the housing, and a small hose on the lower left side (it leads into a small compartment with a breather element). When you clear those three things, pull straight up on the air filter housing. It should pull right up and out; don't wiggle it too much back and forth because there are three plastic pieces which extend from the bottom and are loosley seated into rubber gaskets.
Once you pull it out you can get a socket onto the top of the bolt, and some needle-nose pliers or small channel locks onto the rounded nut. I used a good amount of WD40, and found that going tighten-loosen-tighten-loosen a few times was the trick to freeing the bolts up for removal.
Good luck!
Note: if the round nut still spins with the needle nose plier, you will need Vise grips to lock down the nut. In order to get the mouth of the Vise grips around the nut, use the needle nose plier which failed earlier to break the gussets that are molded into the box which flank both sides of the nut. Make sure the teeth of the vise grip bite into the nut (parallel to nut, perpendicular to bolt).
How many quarts of oil do you put in a 2004 5.7 dodge durango?
book calls for 7 qts i find that i have to 8 in
How long does it take to get to Ulaanbaatar Mongolia from Durango Co?
It depends on your mode of travel.
Air - about 18 hours
Boat - 1.5 weeks
Driving in Dodge Durango - 1 - 2 years
Will a cloged fuel filter allow a 2003 dodge durango to start then kills after 2 seconds?
The iac valve may be bad. located on throttle body,drivers side.
How do you removed the front rotors?
Remove slide pin bolts.
Then remove caliper.
Rotor should slide off the hub.
Why is there water building up on the passenger side on the floor of a Chrysler sebring 2005?
== == == ==
* Heater core leaking? * Evaporator drain plugged? * Windshield seal? * Door seal? * Water backed up from clogged drain holes
How do you replace a water pump on an Alero 6 cylinder 3.4?
I can not answer your question but I do know that there was a recall on them.
What is the firing order for a 2003 Dodge Durango 5.9?
18436572 dist rotation is clockwise and cylinders are numbered 1357 on drivers side and 2468 on passenger side.
How do you fix a window cable that is twisted over itself on a 2002 Durango?
You need to replace the entire regulator assembly.
