0
Dodge Intrepid
In this category you can ask questions about Dodge Intrepids. These questions can include where to find parts, how to get help, or how to do it yourself.
1,915 Questions
Where is the crankshaft sensor on a 98 Dodge Intrepid?
It should be on the transmission by the passenger side of car. It has three wires connected to it.
How do you replace a Timing belt on a 1994 Acura Vigor?
Check out http://www.acuravigorclub.com for answers to many Vigor maintenance questions. For an indepth step-by-step answer to changeing the timing belt on a Vigor refer to http://pw1.netcom.com/~gentile/Vigor/Timely0702.htm. Hope this helps, OBrown
Where is oxygen sensor in 2001 Dodge Intrepid?
In the exhaust, there are 4 of them. One before and one after each catalytic converter.
What is the proper Spark plug gap for a dodge dynasty 1992 3.3 V6 engine?
look on the underside of the hood there will be a sticker that says the gap
What does a wornout brake pad sound like?
A squeel- but many DO NOT have wear indicators so will not make any sound at all until they are gone and they grind tearing up your rotors. It's easy to check them. When car is parked and they are cool, feel them through your wheels holes. If the pad material is thinner than the backing plate its attached to-it's time for new pads.
What type of oil does a 2002 Dodge Intrepid se use?
5w30 is the preferred oil for the 2.7L Engine
10w30 is the preferred oil for the 3.5 (winter months 32 and below) 5w30 is ok for cold winter starts.
Where is the trunk release in 1995 Dodge Intrepid?
The trunk release in a 1995 Dodge Intrepid is under the dashboard on the driver's side. There is also a remote trunk release.
What does Error Code p0700 mean on a 1999 Dodge Intrepid?
Trouble code P0700 means: Automatic Transmission Control System Malfunction You need to check the TCM for codes
Will rims from a 1994 Intrepid fit a 2000 Intrepid?
i have a set of rims from a 2000 intrepid on my 97 intrepid so ya they will fit
How do you install ignition coils in 01 intrepid?
unplug wires and us a star bit to loosen screws once you do that just pull up on it and it will come out.
What type of person would have a nom de plume?
Plume in French = pen in English, so, a 'nom de plume' is a pen name, exactly the same as an internet nickname. Classicly, however, a typical user would be an author who wished to remain anonymous.
Diagram for 05 dodge magnum 2.7 liter?
I've looked evrywhere online and about the only place is in the Haynes and Chilton manuals. I ended up buying one cause I couldn't find one anywhere....
What happens when a speed sensor goes in a cirrus?
When the speed sensor goes out the transmission goes into limp mode and will not allow the car to shift out of first gear. You can purchase a new out-put speed sensor from any dealership for about $17. To replace it you will find it on the driver side of the transmission case it is very simple once you locate it, the old one screws out the new one goes right back in. Don't forget to disconnect the battery before replacing so that the computer will reset itself.
If the computer does not reset, remove both battery leads (NOT THE BATTERY TERMINALS and connect them with any object that will conduct electricity, FOR APPROX 10 SECONDS it is what is called A HARD RESET. (AGAIN DO NOT CONNECT THE TERMINALS JUST THE BATTERY LEADS ON THE CAR)
On mine it was the Intake Manifold gasket .Not just the top plentum but the one under that .Cost about 8.00 for the gaskets.Run the engine codes and if it says misfire on a plug then that could be it .
Could also be a clogged fuel filter, a bad Idle Air Control sensor (which can be cleaner with carb cleaner), or a faulty EGR valve which I was recently told by an old timer at NAPA that they rarely fail....And for me just recently it was the most obvious, faulty plug wires...but for $10 for some plugs and $20 and change for the ignition wires, I'd fully explore that before moving forwards with sensors...they're electronic, meaning no returns to the autoparts store...sucks!
Where is the input and output speed sensor on a 1993 dodge shadow six cylinder?
These sensors are located on the front of the transmission. (http://dnlfiles.bf2guru.com/Ebay/Transmissionstore/604%20trans.jpg )link shows a picture of this trans. One sensor is located directly under the trans cooler lines. and the other horizontal to that towards the end of the trans
Where is the cooling fan relay located on a 2004 Dodge Intrepid?
The 2004 Dodge Intrepid cooling fan relay switch can be found on the back of the cooling fan motor. The cooling fan relay switch is attached to the fan motor with two retaining screws.
How do you replace the water pump on a 2004 2.7 Dodge Intrepid?
This is a very big, labor intensive job. You will need to buy a service manual.
What are the torque specifications for Dodge Durango?
They can be found in the owners maintainence or repair manual. If not, they can be found in the Haynes repair manuals, or any other certified repair manual.
How do you test a cooling fan relay on a 1997 Dodge Intrepid?
All the relays are the same. Just swithch it with the fuel pump relay and if the car runs, the relay is good.
Does dodge still make dodge intrepids?
No, 2004 was the final model year.
No, 2004 was the final model year.
Is there a fuel pump access panel on a 2001 Dodge Intrepid?
No, you will have to remove the tank.
The 1993-1997 Intrepids where the only ones with access panels.
No, you will have to remove the tank.
The 1993-1997 Intrepids where the only ones with access panels.
How do you remove spark plug tubes on a 3.5 intrepid?
You need a special tool that wedges itself inside the round tube and then you unscrew the tube.
How do you bleed air from cooling system 1997 Dodge Intrepid?
on side of thermostat housing there is a bleed screw with engine running slowly
open screw you will hear air coming out do not do this when HOT, with cool engine
only , when fluid does start to come out tighten screw back in
Where do you buy plastic wing nuts for 2005 dodge magnum tail lights?
The only place I have found that you can buy these at is a Chrysler/Dodge dealership parts department. I put on a trailer hitch and put in the wiring harness, and dropped one of those into the hole and couldn't get it out. That was the only place I could find them.
