How do you replace a starter on a 1994 Chevy pick-up?
Hey George===First remove the negative battery cable. Rme ve the flywheel cover. Then remove the bolts holding the starter to the block. Drop the starter down enough to remove the wires. then remove the starter. GoodluckJoe
What causes the wait to start light to flash on a 92 dodge diesel truck?
The wait to start light on a 92 Dodge Diesel truck can be caused by a lack of fuel to the engine. It can also be caused by a wiring problem.
Can a snow blade from a 1979 power wagon fit on another truck?
The plow blade will fit any similarly sized truck. However, the mounting assembly needs to be matched to the frame of the vehicle it is going onto.
What would cause front brakes to lock up on a 1976 Dodge power wagon?
caliper froze, brake line collapse, or wheel bearing out.
How do you replace universal joint on front axle of a 93 dodge w 250?
This for the 4x4 version, remove the caliper and brake assembly, remove the spindle nut (large bar or very large impact) remove the lower ball joint nut slowly with a jack under the ball joint and gently release the pressure on the suspension eventually lowering the jack. swing the wheel hub assembly a side and remove the axle. place the joint in a supported vise and remove the retainer clips that hold the u-joint stable in the joint housing, gently with a socket the same sixe of the u-joiny cap and a brass hammer pound the joint from the housing, install the new joint and reassembly in the reverse of disassembly. Be sure to torque the spindle not and replace all clips/kotter pins.
How do you remove a front axle shaft in a 1988 dodge ramcharger 4x4?
like you do in any other vehicle
Where can you find a wiring diagram for a 86 dodge ram-charger?
try a chiltons repair manual from the library.
Are parts available for 1977 dodge 4 wheel drive power wagon?
We have a 1977 Dodge Power Wagon CREW CAB 4x4 - FOUR DOORS - disassembled and being rebuilt. Most of the parts were found through the internet from private parties.
(My wife told me today I have to sell mine because it has taken me too long to get it rebuilt. We had a deal that I would finish it in two years or else. It has been 4. The long block is complete - new rods, pistons, and rings. Block is straightened. All that is needed is the blocks - found them in Las Vegas for $300 but haven't bought them. No cancer on body except a small bit on driver's door. Painted chassis and rear ends. New seals. Self locking hubs. If interested, call me. Jay 520-399-2420)
What is the horsepower of a 2006 dodge cummins diesel?
The power rating for the 2006 5.9L I-6 Cummins diesel engine is 325 horsepower and 610 pound foot of torque.
Is trans for 2002 dodge ram 1500 5.9L same as 2003 dodge ram 1500 5.7l the same or will it work?
Completely different, not interchangeable.
What would the torque spec for cab bushings on a 1983 dodge pick up?
The torque specification for cab bushings on a 1983 Dodge pickup typically ranges from 35 to 50 foot-pounds. However, it's always best to consult a service manual specific to your vehicle or check with a reliable mechanic for the most accurate information. Proper torque ensures that the cab is securely mounted without risking damage to the bushings or the chassis.
What type of oil to put in 1985 Dodge W150 transfer case?
For a 1985 Dodge W150 transfer case, it is recommended to use Dexron III automatic transmission fluid (ATF) or a similar type of automatic transmission fluid. It's essential to check the owner's manual for specific recommendations, as some models may vary. Ensure that the fluid is at the proper level and in good condition to maintain optimal performance. Always consult with a mechanic if uncertain about the right type of fluid.