What does axle code 19 mean on an 1998 E150 ford van?
code 19 is a 3.55 gear ratio non limited slip differential econoline ford
How do you repair a door hinge in a 1988 Monte Carlo?
The best thing to do is to purchase a complete new hinge assembly and replace it. These GM type vehciles were notorious for the hinges going bad.
AlsoIf you take the hinge out most part stores sell the repair kit (the brass bushings and new steel pins) in their HELP! section. It's not too hard to do.I have a 86 Monte and the doors sis sag down and you had to slan them shut, but all you need to do is replace the upper pin, not the whole hinge. you need to take your door off and hit the pin out and put the new bushings back in the right spot and you have to mallet in the pin whenthe bushings are allready in place. your going to need a jack with a towel over it or another perosn to help put the door back on.
How do you change the Ignition switch on 89 Ford E-150?
You must turn the key to accessory mode and find a small hole in the housing where the barrel is. Push in with a paper clip or very small screw driver and pull the key and barrel out. When installing the new one, make sure you turn the key toward accessory mode before insterting it into the housing. You will hear the spring "click" Turn the key off and remove the key. DONE!
How do you replace a fuel pump on a 1999 Dodge Ram 1500 pickup?
start by draining gas tank then jack truck up don't forget to trig wheels, remove straps that hold gas tank to chassey, use penatration oil on bolts, disconnect filler hose and vent hose lower tank disconnect fuel lines and wiring, remove tank from under truck now you will have to remove sending unit from gas tank that is where you will find fuel pump unscrew old pump, install new pump. Replace everything same way you took apart.{p.s. becarfull not to damage locking ring that holds sending unit in place
You'll need to examine the alignment of all of the pulleys to see which one is misaligned, then figure out why. If your serpentine belt keeps coming off, check for. 1. Belt getting worn on the edges. Replace belt. 2. Pulleys coming loose. Tighten pulleys and re-install belt. 3. An accessory may have been replaced incorrectly, so that the belt does not track correctly.
The timing belt blew on a 93 eagle talon non turbo 2.0 16valve DOHC would that have bent the valves?
More than likely it will have bent valves but not all of them will be. It also depends on if the car was driving or stopped just idling. The other thing is if they are really bent you might of cracked the valve guides
How is the coil pack numbered on a 1998 Ford 4.2 L V6?
On a Ford 4.2 liter V6 with the Electronic Distributorless Ignition System ( EDIS )
coil-----3 - 4
pack----2 - 6
plug-----1 - 5
How do you replace the fuel filler neck on a Ford Econoline Van?
Unscrew it at the top and unclamp it at the bottom.
What size tire will fit a ford e250 van?
You will need LT 245/75 R16 Tires. I'm not sure it's absolutely required, but you should make sure they are E rated or 10 ply. This is especially important if you are carrying heavy loads.
Coil over plug location ford e-150 1997 5.4l?
:) Over each spark plug. 4 on each side of engine. These are "inboard" close to the intake manifold instead of the exhaust manifold.
What is the firing order for a 1989 Ford e-van 5.8L?
if it is a 351 windsor the firing order is : 1-3-7-2-6-5-4-8
What would cause a vehicle to lose power while driving?
If you lost power while driving and it did not start again, it could be an alternator issue. Double check the battery just to make certain it isn't an issue with the cable connectors too.
Turn off the airbag light on 2005 tacoma?
To turn off the airbag light you need to give a firm, well placed punch to the person nearest to you.
Where is the DPFE Sensor and the EGR Valve on a Ford E150 van?
The DPFE sensor is the back pressure sending sensor that controls the EGR valve.
The Location ( on a 99 E150 ) is on the driver's side upper rear area of the engine.
It is best to remove the inside engine cover to get to it. You can see it from the hood area if you shine a light and look back to the area looking above the mass air flow sensor then along where the 3rd back spark plug is. Look for a silver rectangular device about 2 " tall X 4" long 1" thick. It has a plug to the rear on the face and two 3/8" hoses coming out and going down from it. To replace or check voltage etc. take the inside engine cover off ( some people refere to this as the "Dog House" ) . Hope this helps. I know I could not find the location on the net so I thought I would share.
If you change your car refrigerant R12 to R134A do you have to change the AC compressor?
No you don't have to change the A/C Compressor.
Where is your mass air flow sensor located on 2001 E150 ford van?
On a 2001 Ford E-150 :
The Mass Air Flow sensor is between the engine air filter and the
engine air intake tube . ( it is INSIDE a round shaped plastic housing )