0
Ford E-350 Van
The E-350 is a full-size van produced by the American automaker Ford Motor Company for its E-Series or Econoline product line. This heavy duty passenger van is frequently used as school bus, ambulance and commercial van.
1,646 Questions
How do you replace the starter in a 1992 Ford econoline van?
Disconnect battery - terminal Raise and secure vehicle if needed Remove 2 or 3 mounting bolts Disconnect wiring Twist and drop to remove
How difficult is it to change the coil pack on cylinder 5 on a 2002 E250 V8 engine?
The coil pack itself is easy to remove, getting to it is the hard part. Remove air filter and housing and go from the front. Remove the wire connector and remove small bolt. I changed all eight, not fun, but saves lots of money. If you have a 1/4" drive swivel head socket and extension, it is not that bad.
How do you fix the speedometer lights in a 1993 Lexus ES300?
Hi, I had the same problem with my es300. I found a company in Michigan that is able to replace the needles and get them to light up again. They had it back in a few days.They are called Dash Electronics & Speedometer the number is (248) 835 1332 found them on the web at: www.dashusa.com good luck!!
I called dashusa.com and they said that it costs around $350 to fix the needles. They basically add on an LED light to the needles, they don't replace the needles.
May you drive with just your parking lights on in place of your headlights?
no, you may not, because ,driving with just your parking lights only( in place of your headlights) is against the law
Where do you check the transmission fluid on a 1987 ford E350?
Usually the dip stick is on the passengers side just to the side and a little behind the air cleaner box.
1994 e350 speed sensor location?
The spped sensor is located on the top of the rear axle housing. It,s on the top front of the engine, 1 pm position of round housing, between fuel filter and alternator of my 1994 E-350 with 7.3 L diesel engine.
Take it to a dealer are you joking.
Take off the drivers side door panel. Most are held on with clips that push into a round hole. Look for a few screws, Remove them then you can get to where the key lock assembly is. Pop off the horseshoe ring holding into the door.
Take the lock assembly to a locksmith or you can bring the whole van to him and still be cheaper than those dealerships that want a body part.,
How do you check fuel pump or change fuel pump?
the fuel pump is located at the rear of the car, in the gas tank. to replace the fuel pump, the entiregas tank must be completley taken out of the car
the fuel pump should "wine" (like a nice Merlot) or "energize" when you turn your key on. When the car is running it also "wines" like an electric motor. You can also hear this outside the car at the trunk. If your car will not start and you suspect it could be the fuel pump, turn your key on, and listen carefully for this sound. You may not have to replace the pump! I went to a repair shop to make an appointment to have the non operating fuel pump replaced in my 1991 Mercury Marquis. They told me the job would cost about $ 500.00 ! But they also told me to try something first.1. Jack up the rear of the car.2. locate the pump.3. Have a helper turn on the ignition switch, do not turn to "start". 4. Simutaneously, you beat on the tank where the pump is located with a rubber mallet. On the 3rd "cycle" of this routine my pump started to work & continues to do so.
wear your seat belt and you will not hear the alarm
check your owners manual for disabling beltminder.
GREAT NEWS! There is now a quick and easy way to disable that annoying alarm while on private property in 2 seconds or less! Go to the net and type " Seat Belt Alarm" in your search engine. You're gonna love this!
How do you fix the problem of jumped timing with out timing light?
Your question is too vague usually when someone says that their engine has jumped time that means that the timing chain has jumped on the timing sprockets. If that is the case you would need to change them. If the distributor is out of time to do it right you would need to have a timing light. You would need a repair manual for the specifications to fix both of them.
What is the spark plug gap for 1987 Ford Econoline 7.5L engine?
According to one of Fords websites :
For a 1987 Ford E-350 , 7.5 L / 460 cubic inch V8 engine :
The spark plugs are gapped at ( .044 inch )
the firing order of your van is 1-3-7-2-6-5-4-8 in a clockwise distributor rotation, the right side as you sit in the vehicle being numbered 1234, the left 5678 from front of the engine towards the back
What is the difference between direct injection and indirect injection?
Direct injection injects the fuel charge directly into the combustion chamber, (more efficient). Indirect injection injects the fuel charge into the intake port behind the intake valve, or in the case of Throttle Body injection, into the center of the intake manifold for distribution to the cylinders. Indirect injection was much cheaper to produce, but resulted in higher emissions and reduced power relative to direct injection.
Source(s):ASE Master Technician, 46 years experience.Where is the distributor on a 1993 E150 ford van located?
On a 1993 Ford E-150 GASOLINE engine :
Follow the spark plug wires to the distributor cap on top of the distributor
On the 4.9 liter / 300 cubic inch inline six cylinder engine ( the distributor is on the DRIVERS SIDE of the engine )
On the V8 engines it is ( near the front of the engine on the top of the engine )
How do you drain the water from the fuel in a Ford F-250?
Depends on how much is in there, if just a little, put some rubbing alcohol in there and it will remove it as you drive, or you can try a siphon. if you really stuck a garden hose in there, i would take the fuel filter off and turn the key forward and let the fuel pump all the water out till you get down to gas. as you know gas flots on water, and the fuel pump sucks from the bottom of the tank, so it will suck water first, then gas. have fun If this is a power stroke and the water in fuel light is on their is a drain petcock located behind the fuel filter apparatus that will drain your water from the water seperator check your power stroke owners manual, the exact directions are there.Do this as soon as safely possible when light comes on you can perform this anywhere with no tools required.
WARNING::: Rubbing alcohol (Isopropyl rubbing alcohol) same kind used for cuts,scrapes should not be put in to your fuel system at all,the active ingredient is 70%Isopropyl alcohol BUT the inactive ingredient is 30% WATER...so by placing as small bottle of rubbing alcohol into the fuel system you are also adding more WATER into the system....
Isopropyl alcohol is a major ingredient in the "gas dryer"type fuel additives that are designed to remove water from the fuel system HOWEVER these gas dryer additives do not contain any water what so ever unlike common rubbing alcohol..
By adding a 16oz bottle of common isopropyl rubbing alcohol(70%/30%) into the fuel system you are also adding 4.8 ounces of WATER.....which defeats the purpose since you are adding more water to the water you wish to remove in the first place..
just spend the extra $1.25 and purchase the correct fuel additive.
Why does the OD Off light blink on and off on a 1994 Mercury Cougar?
You may have a transmission problem. Have the computer scanned for Diagnostic Trouble Codes.
Where is the fuel cutoff switch on a 1999 Ford E-350 van?
On a 1999 Ford E-350 , the fuel pump shut off switch ( inertia switch ) is in the
front passenger footwell , behind the kick panel ( the kick panel is the interior
trim panel in front of the front door beside the passengers right foot )
What is the firing order for a 1987 ford 351?
For a Ford 351 cubic inch / 5.8 liter V8 engine :
The firing order is ( 1 - 3 - 7 - 2 - 6 - 5 - 4 - 8 )
The distributor rotor turns COUNTERCLOCKWISE ( looking from the top )
The marked # 1 position on the distributor cap faces towards the REAR
The engine cylinder locations are numbered :
4 - 8
3 - 7
2 - 6
1 - 5
front of vehicle
What are the tune up specs for 1965 Pontiac Star Chief?
Dwell 28-32 degrees Plugs .035 Timing 10 BTDC
Where is the transmission heat sensor located on Ford e350 2006 automatic?
you have to remove trans pan and filter to remove they go bad.its easy to replace small black sensor with two wires you can get new sensor at any ford dealer just tell them you need a trans temp sensor and when you remove pan and filter look for the sensor you have it twists out easy good luck
