Ford Escape

#1----#2----#3

#4----#5----#6

front of Ford Escape > driver

Buckle up!

According to the 2008 Ford Escape Owner Guide :

Both the 2.3 liter four cylinder engine and the 3.0 V6 are designed to use :

( " regular " unleaded gasoline , 87 octane )

If the check engine light is flashing every second or so with the engine running that

means an engine cylinder misfire has been detected

Should be Ok, check towing capacity against GVW to be sure, stay well below the limit.

Also check with the dealer if the Escape has an automatic transmission, damage can result from towing if not done properly.

on the bottom of the transmission there is a plug that you take out. you can stick your little finger in the hole where the plug was to see if it is low. if you do not get fluid on your finger, it may need a quart or so.

What do you mean by "Torgue Setting"? Here are the Spec's. for that engine. Horsepower 175.00 HP (128.8 KW) @ 4000.00 RPM Torque 245.00 Ft-Lbs (332.2 NM) @ 2400.00 RPM

if the ignition is cycled, driver's seat belt is unbuckled for

more than 10 seconds and the vehicle speed is greater

than 5 mph (8 km/h).

The Enhanced Warning System (BeltAlert) can be enabled

or disabled by your authorized dealer or by

following these steps:

NOTE: The following steps must occur within the first

60 seconds of the ignition switch being turned to the ON

or START position. DaimlerChrysler does not recommend

deactivating the Enhanced Warning System

(BeltAlert).

1. With all doors closed and the ignition switch in any

position except On or Start, buckle the driver's seat belt.

2. Turn the ignition switch to the ON position and wait

for the Seat Belt Warning Light to turn off.

3. Within 60 seconds of turning the ignition switch to the

ON position, unbuckle and then re-buckle the driver's

seat belt at least three times within 10 seconds, ending

with the seat belt buckled.

NOTE: Watch for the Seat Belt Warning Light to turn on

while unbuckling and off while re-buckling the seat belt.

It may be necessary to retract the seat belt.

4. Turn the ignition switch to the LOCK position. A

single chime will sound to signify that you have successfully

completed the programming.

The Enhanced Warning System (BeltAlert) can be reactivated

by repeating this procedure.

NOTE: Although the Enhanced Warning System

(BeltAlert) has been deactivated, the Seat Belt Warning

Light will continue to illuminate while the driver's seat

belt remains unbuckled.

If you have a owner's manual the directions might be in there. For my 2001 Escape that's where I found the answer

For a 2009 Ford Escape , 2.5 litre four cylinder engine :

With engine oil filter change :

( 5.3 U.S. quarts / 5.0 litres of 5W-20 ) according to the Owner Guide

The 2003 Ford Escape has a 2.0 L base engine size.

It depends on how many hours per day, how many days per week, and how many weeks per year you want to work, so for example multiply 19.00 by 8 (hours per day), then by 5 (days per week), then by 50 (weeks per year) and you will have your answer.

1.5 tons or 3000 pounds, it can't on electric mode though

The ground clearance of the 2006 Ford Escape is 0 ft. 8.4 in. (8.4 in.).

Escapism is a way of escaping reality. Like, for example, if you're having too much stress on your back, you might take a long, hot bath and feel relaxed by the time you get out.

You can view the Owner Guide online at :

www . motorcraft service . com ( no spaces )

Click on Owner Guides

The fuse diagram is in the Owner Guide

2002 Ford Escape turn signal bulb replacement: Purchase the correct replacement bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the replacement procedure. The owner's manual is the best place to start for bulb replacement. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).

To replace the antenna on a 2004 Ford Escape, first, locate the antenna base on the roof of the vehicle. Using a wrench or socket, unscrew the antenna by turning it counterclockwise. Once removed, replace it with the new antenna by screwing it back on clockwise until secure. Finally, ensure the connection is tight and check for proper reception.

A creaking noise in the front end of the 2003 Ford Escape might be caused by shocks or struts that need to be replaced. This might also be caused by damage to the shocks or struts from high mileage.

9mm Hexbit Allen Socket. Hard to find. Sears usually carries, you can order online

In "Escape the Freezer 5," you can light the rag by first finding a source of fire, such as a lighter or matches. Once you have the fire source, combine it with the rag in your inventory. Use the lighter or matches on the rag to ignite it, allowing you to progress in the game.

Yes

Check the Vehicle Emission Control Information ( VECI ) decal located in the

front of the engine compartment ( it will show what type of spark plugs to

use and the spark plug gap )

16.5 U.S. gallons ( 62.5 liters )