Hyundai Sonata

How about putting your seat belts on! If the chime is not going off when you put on the belts, take it back to the dealer.

-------------- Better Answer (for the 2007 - 2006 may be similar) - of course you should buckle up. But it nags even when your door is open or key in ignition, fast and loud. The 2009 model doesnt do this, and the dealer refused to lower the volume on my 2007.

I wouldn't recommend totally disabling it, but it is painfully loud . I finally broke down and removed it with the help of my neighbor, a mechanic. You have to remove the entire center console. There are also screws inside the storage compartment (lift the rubber liner) and on the sides. The shift knob screws off, then you lift the console out. Just a heads up, the wires wrapped in yellow tape are the airbags, no big risk. The chime is inside a small plastic box below\behind the cigarette lighter (approx 7 inches wide, remove and unsnap cover) The speaker is integrated with the circuit board. I don't recommend removing it - there are other vital items on the board. The speaker is surrounded a 1 inch deep plastic surround (part of the top cover). So, I put electrical tape directly on the speaker, and stuffed the surround with tire patches, then taped it and put everything back. Now, if you notice a few red lights, engine, etc after you put it back together, don't panic. You computer system will eventually do a self-test, mine reset after I drove for about 5 minutes and restarted the car. The muffled chime is now manageable to me. I can deal with it for at least 30 seconds if I must get in, out, or unbuckle. There you go! Oh, and those other posts about how if you disable it, it will disable the airbags are LIES according to my mechanic - they must have a separate circuit. But as I said, I can live with a quieter chime, and believe in seatbelts. Drive Safely.

does the 2010 hyundai santa fe have an on off overdrive switch where is it located

You need the gasket and it would also be recommended to replace the spark plug gaskets also. You will need a 10mm socket with an extension.

1. remove the 5 bolts from the plastic cover over the motor, if you have one on the motor.

2. depending on when your 2003 Elantra was made you will either have 13 bolts or 12 bolts that hold on the valve cover. If you look on the Driver's side door jam you will see a sticker with your VIN and other information. It will have the Manufacturing date. If it was made on or before October 31 2002 you will have 13 bolts, if it was made on or after November 1 2002 you will have 12 bolts. This will also need to be known to make sure you have the right gasket. remove the 12 or 13 bolts plus the 2 bolts at the top of the timing cover.

3. remove the spark lug wires and 2 hoses from the back of the valve cover.

4. Now remove the valve cover, you may need to stick a flat head screw driver under the edge to pry it off.

5. use the flat screw driver to pry the old gasket out of the valve cover and use the screw driver to pry the spark plug gaskets out of the center of the valve cover. Note: on the spark plug gaskets the center part of the ring comes out the outer edge of the rings are part of the valve cover.

6. push the new spark plug gaskets back in place firmly and push the new valve cover gasket into the valve cover's grooves.

7. Clean off excess oil and dirt from the top of the head/motor where the new valve cover gasket will touch.

8. place valve cover with new gaskets back on the head/motor and finger tighten the screws

9. the torque specs for the valve cover bolts are anywhere between 72 and 84 in-lbs. NOTICE this is in INCH Lbs Not foot-lbs. So it is roughly 6-7 foot-lbs. If you don't have a torque wrench you can tighten them with your socket snugly, you don't have to tighten them super tight (putting all your might and weight into it I mean.) If you do put all your weight/might into it you could break the valve cover. ----- Tighten the bolts in a criss-cross fashion to ensure the pressure is applied evenly.

10. tighten the bolts on the timing belt cover, reconnect the two hoses and the spark plug wires, then put your plastic cover back on if you have one or wish to.

no

Hyundai Sonata center high mount stop (third 3rd brake light) bulb replacement: Purchase the correct replacement center high mount stop (third 3rd brake light) bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the center high mount stop (third 3rd brake light) bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. If there are multiple bulbs, you may want to consider replacing all at the same time in order to keep brightness and color equal (optional).

The cabin air filter is located behind the glove compartment. It is really easy to access, just remove the side clips holding the glove compartment into the console and unhook the elastic string that serves as a guide when you open the glove compartment. It should take no more than 10 minutes to replace the air filter and you'll save a large amount of money doing it yourself. I had two Hyundai service shops quote $99 and $79.95 to change out the cabin air filter. I purchased a new filter for $20 at a Hyundai service parts dealer where I had my oil change and installed it myself.

in a 2203 gt 5 door, after your directions, I just got to see the filter door further disassemble is required to access the area

2000 sonata glsv6- Open glove box. On the right side you will see a rectangular piece of plastic that enters the box thru a hole. This is the closing retractor. Pull it in, then back it out of the hole and let go. On both sides of the box you will see a plastic square. These are the rubber stops. Pry up the front of these tabs then slide them towards you, and wiggle the stops thru and into the box. Now the box flops down all the way. On the bottom you will see a metal hinge. Remove the two bolts and two Phillips screws. On the top, remove the two Phillips screws and the nut in the center. The box will stay attached by the wiring to the box lamp and lamp plunger, so be carefull not to yank it away. Whew! You are now looking at heating shroud. In the center there is a lid over the filter. It runs vertically and is removed by pulling down on a plastic clip that is part of the lid. It is on the bottom. Pull it down and the two tabs at the top will come out of their mounts. The filter is then pulled out by its center tab handle. Vaccuum the area, insert new filter ($11.00 on sale at NAPA). Reverse installation. Now wasn't that fun!

The 2012 Hyundai Sonata-Hybrid has a 2.4 L base engine size.

You get 22 miles city, 30 miles highways...and combined 25 miles per gallon

The gross weight of the 2004 Hyundai Sonata is 4233 lbs..

The PCV valve is located under the black plastic shroud on ther drivers side on top of the intake manifold. It will be covered by a circular foam insulation.

The 2014 Hyundai Sonata has a 2.4 L base engine size.

Why would you repair something that could be very easily, and cheaply, replaced? As for repairing it, that would depend on what part of it is damaged, and your skills.

The gas tank on the 2013 Hyundai Sonata holds 18.5 gal..

There are two license plate bulbs on the 2000 Sonata. They are housed individually. The housing itself releases easily enough. Grip the housing with your thumb and fore finger, thumb on the right hand side of the housing, squeeze the clip under the thumb and pull down the housing. It does not come out very far. The cables are taped to the bumber of the car, you may need to reach up behind the bumper and find the tape and cut it, taking care not to cut the wires. Once you have released the cables, the housing should come out sufficiently for you to grip the bulb connecter. Holding it, turn the housing clockwise about 45 degrees and pull it off the bulb connector. It is all very stiff and difficlut to access, but it is possible, I have replaced one and it does work.

The 2002 Hyundai Sonata has 55.7 in. of rear shoulder room.

low tire pressure

To find the air bag plug under the seat, look for a yellow plug on a 2002 Hyundai Sonata. Re-connect the yellow plug to the yellow plug receptacle. There should also be an orange strap that keeps the plug from separating. If that is broken, it will need to be replaced.

It is located center dash on the floorboard

The maximum tosing capacity of the 2007 Hyundai Sonata is 2000 lbs..

yes

You can use whatever octane you want, generally you shouldn't have to go to higher octane unless your car requires it. If your decidin to go higher because you feel a better power increase this is a sign you need tune up

The fuel pump shut-off switch for a 2001 Hyundai sonata is actually located right below the fuel pump. You will want to make sure that the vehicle is cooled down before attempting any repairs as you can get badly burned otherwise.

should be were the fuses are, under the engine hood